2020 Karma Revero GT technical service bulletins
45 technical service bulletins and manufacturer communications cover the 2020 Karma Revero GT.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Recovery cap retention, a method to bolster tension for the tow hook cover
- Alert to service centers that 12 volt is no longer stocked in the karma distribution center
- Alignment of headlamps service procedure
- New component is available, instructions how to install are provided
- Update to procedure for oil sump removal & replacement
- Supplementary instructions on replacement of oil sump on engine.
- New B-Pillar retention clips are available, which will be replaced on complaint
- A supplemental instruction to remove and reinstall the external rear view mirror caps
- New fasteners are available for better headlamps
- Install of recommended 12Volt battery maintainer
- Over the air Software update to redirect the vehicle to the new server.
- A software update for Karma Vehicles Infotainment system only, to connect to the current servers for...
- Update Remedy for possible wind noise complaint and door effort on opening
- Revised tool list for service providers
- A new bracket is provided to reposition the Diagnostic Module TL for best performance in the vehicle.
- Headlamp Control Unit Replacement Safety Recall
- On complaint this is offered to provide a software update (BL1070) over the air to remedy the complaint of...
- On complaint of relative Fuel tank isolation valve (“FTIV”) diagnostic trouble codes presented, this guide...
- Describing the process to use the diagnostic tool and USB for manual baseline updates of vehicle software...
- Remedy for infotainment module fan noise.
- Update to Workshop manual procedure and information for sound module location
- This bulletin will outline the process of what to expect and what to perform for a software update.
- Baseline Software update for specified models
- Knocking noise remedy, by verifying torque spec on some front end bolts
- Update to previous communication regarding vertical location of radar calibration mirror
- Baseline 1050 software update
- This bulletin will instruct on visual inspection process and identification of the wheel rims for the...
- Traction Control/ABS Warning Light illuminated on the after the vehicle has been transported via a flat...
- A service communication on installing license plates for the GS-6
- Pre-Delivery Inspection guide and sheet
- Supplement to workshop manual communication to add a torque value for replacement repairs.
- Software Baseline release
- Document instructs to check the torque on the fastener for Ground 109A
- Inspection of the AFRM date code to validate part for future updates
- Coolant Flush Procedure, to clean out debris, under certain conditions
- There is a specification change in the Manual Service Disconnect (MSD). Replace the current installed unit
- Supplement to the Karma Sync Procedure for Radar Module Calibration, equipment use bulletin
- Karma Automotive has released a Baseline update for the MY2020 Revero GT, BL1030
- Surround view camera system camera calibration instruction bulletin
- Baseline software update instrucitons
- Some Revero GT models may have been built with an External Sound Module (ESM) that has been updated
- In order to bring the Revero GT into the best performance Karma Automotive has released a Baseline update...
- Sensor Protection Cap Install, a sensor cap is to be installed for cosmetic reasons
- In order to bring the Revero GT into the best performance Karma Automotive is replacing components on the...
VIN decoder
See the problems and recalls for an exact car
Buying a used 2020 Karma Revero GT?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history