Pulling in the clutch causes the rpms to drop below 1000 RPM causing the engine to die or stall. This happens frequently. It can occur several times in a row or it can be several days before it happens again. I've tried to increase idle speed to 2000 RPM, manufacturer recommends 1300, which did not help. I would estimate it has occurred 50+ times since I purchased the motorcycle new on june 28, 2013.
Kawasaki EX300 stalling problems
11 of the 14 owner complaints about the Kawasaki EX300 describe engine stalls while driving.
- owner complaints
- 11
- typical mileage
- 235
By model year
- 201311
What owners say
After parking my motorcycle in the sun for about 2 hours I returned and started it up. Everything appeared normal. I accelerated to about 15 MPH and then as I prepared to come to a stop I started braking and pulled in the clutch. The engine RPM's dropped lower than the idle speed and the engine stalled as the bike was still moving. I coasted to a stop. I placed the bike in neutral and restarted the motor. It started up fine and I continued on to an intersection where I attempted to make a u-turn. There the bike stalled on me again while in the middle of making the u-turn as soon as I pulled the clutch in. I barely escaped being rear ended by a SUV that was also making the u-turn and that did not expect me to come to sudden stop in the middle of the intersection. I immediately tried to restart the engine meanwhile I had two other vehicles stuck behind me blocking the intersection from oncoming traffic. The engine stalled again at the next stop light. After about 2 or 3 miles of constant movement did the issue go away. This same problem has occurred several times since then and always after the motorcycle has sat in the sun for several hours. It never occurs in the morning on a cold start and when it does occur it goes away after a couple miles of riding.
When coming to a stop with clutch disengaged engine stalled and had to be restarted. Luckily no traffic was behind me or I might have hit from behind.
This incident has been happening since the first day I have owned the kawasaki ninja 300. I would slow down to a stop and the engine would stall. I would then put it back into neutral and restart the motorcycle. It would happen a few times until the motor gets warm, then it stops stalling. It happened to me at least 3-7 times when riding it today. This happened to me about 4 times now.
When bike is in the sun all day the bike will stall when the clutch is pulled in. Also left fairing pops out called kawasaki about both things and was told we have no record of this go to the dealer so I went to the dealer and again given the run around this is a big problem for the safety of the rider.
I was going through a slight curve, not a big one just a normal curve going about 20 miles per hour when I tried to slow down the bike sort of stalled so I went straight into the curb into where I hit a tree. There are many people that saw e incident and found it very strange as well as I did. I have enough experience into which I know it wasn't my fault I lost control of the bike. Going 20 miles per hour with nothing that could have caused this pretty strange.
Pulled the clutch in when coming to a stop and the bike stalled. Happened 8 more times getting the bike home. I have adjusted the idle to 1500 RPM and the bike now drops to 1100 RPM when clutching during a stop then recovers to 1500 RPM after stopping. Dealer mountain motorsports claimed they had not heard of it happening on any other ninja 300s. They contacted me back stating that they had contacted kawasaki and kawasaki is aware of it but have no cure for it as of this time. They claim it is an idle stop problem. This could be extremely dangerous to a new/newer rider.
Engine stalls unexpectedly for no reason. No user error. Motorcycle was sitting in sun in a parking lot for 40 minutes. I started the motorcycle, let it warm up for 5 minutes then took off. As I was leaving parking lot I pulled in clutch as I came to a stop sign. At this time the engine rpms dropped to zero and the engine stalled/died. I pulled off to the side of the road and started the motorcycle again. I returned to the parking lot and re tested what would happen when I pulled in the clutch. This time engine rpms dropped very low but the bike did not stall. I ended up making it home with no more problems that day. Since that experience the motorcycle stalls when I first start riding it and pull in the clutch. This mostly happens when the motorcycle has been sitting in the sun for some time. After riding for a few minutes and going through gears the problem goes away. It has not happened yet at higher gears, just in first and maybe second gears. The problem does not happen in the morning (when the air is colder and the motorcycle has been in the garage). Engine idle is set properly. On a motorcycle, an engine stalling unexpectedly and for no obvious reason is extremely dangerous. The ability to "get out of the way" is of utmost importance when stopped on a motorcycle.
My 2013 kawasaki ninja 300 is stalling randomly from just pulling in the clutch at speed. It extremly dangerous for a motorcycle as it can cause loss of control. My dealer says its a known issue but kawasaki has not fixed this problem yet.
I am an experienced motorcycle rider with 26+ years and roughly 150,000 miles riding experience. Had driven new ex300 approximately 5 miles without incident, was slowing at a stop light to make a right-hand turn. I had shiften back into 1st gear, almost stopped (about 2 or 3 miles per hour) when the light turned green. I did not realize that the engine on the motorcycle had stalled, released the clutch and hit the throttle to make the turn. As the engine had stalled, the bike came to an almost instant stop. Minor injury twisting my left ankle as I had to pop my legs off the pegs to prevent myself from from wiping out as the bike's rear tire locked up and I had already started to throw my weight to go into a right-hand turn. Checking the internet, I've found this is a very common problem with this specific year/model of motorcycle.
Related recalls
No recalls on record for this model year.
Questions about the Kawasaki EX300 stalling
Which Kawasaki EX300 years have engine stalls while driving problems?
The model years with the most reports are 2013 (11 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Kawasaki EX300?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history