Kenworth K100E recalls
There are 3 safety recalls on record for the Kenworth K100E, covering 15,590 vehicles in total across all the models in each campaign. Newest first.
Kenworth K100E recalls by model year
All recalls
Exterior lighting
- What is wrong
- Certain trucks equipped with trailer connections fail to comply with the requirements of federal motor vehicle safety standards (fmvss) no. 121, "air brake systems," and no. 108, "lamps, reflective devices, and associated equipment." the supplier removed a rubber grommet from the trailer light line connector. The vehicles are experiencing corrosion at the 7-way trailer connection. This causes intermittent flashing/flickering of the trailer lights.
- Risk
- This could cause an electrical short and/or possible fire hazard.
- Remedy
- Dealers will install the missing grommet on all affected chassis. If a connector is found defective, it will be replaced with a new connector. Owner notification is began on march 14, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5440.
Recall number 03V045000 · Recall details
Suspension: rear
- What is wrong
- Rear axle stabilizer (sway) bar may not have been properly heat treated.
- Remedy
- Replace the stabilizer bar.
Recall number 91V044000 · Recall details
Service brakes, air
- What is wrong
- Air brake system was modified by adding a longer air line between the ABS solenoid and the transfer tee to simplify manufacturing. This modification caused the trucks to be in non-compliance with fmvss 121, brake timing test.
- Risk
- The mistimed brake and ABS system may cause the truck tofail the stopping distance requirement of the fmvss, which may lead to anaccident.
- Remedy
- Remove the extra length of air line and install the transfer tee at the ABS solenoid.
Recall number 91V043000 · Recall details
Questions about the Kenworth K100E recalls
How do I check if my Kenworth K100E has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the Kenworth K100E have?
3, covering exterior lighting, suspension and service brakes, air.
VIN decoder
See the problems and recalls for an exact car
Buying a used Kenworth K100E?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history