Check a VIN

2007 Kenworth T2000 brakes problems

10 complaints (83% of all complaints for this car). Typical mileage when it fails: 194,002.

owner complaints
10
of this car's complaints
83%
typical mileage
194,002
crashes
0
recalls
2

Which part fails

Owners did not name a specific part.

At what mileage

Complaints by mileage at the time of the problem.

0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+

Kenworth T2000 brakes problems in other years

1999200120062007

Related recalls

Service brakes, airReported June 30, 2009 · 3,423 vehicles affected
What is wrong
Kenworth is recalling 3,423 my 2004-2009 t2000, t800,t600, w900 and t660 vehicles. Increased brake excitation in a certain vehicle configuration which includes bendix drum brakes, wide base low profile single tires, and an ag400 or ag460 rear suspension, due to its unique brake clocking and cam tube length, can cause fatigue and cracking to brake assembly components.
Risk
Cracking can cause a complete fracture of the cam tube, which could increase stopping distance and decrease parking brake hold capability.
Remedy
Dealers will inspect the rear axle brakes assembly, replace cracked rear axle brakes assembly components where required, and install cam tube support brackets on all rear axle wheel ends free of charge. The recall is expected to begin or before july 25, 2009. Owner may contact kenworth at 1‑425‑828‑5440.

Recall number 09V239000 · Recall details

Service brakes, airReported March 9, 2007 · 65 vehicles affected
What is wrong
Certain trucks fail to comply with the brake timing regulatory requirements of federal motor vehicle safety standard no. 121, "air brake systems." the brake valve was moved to the opposite rail, increasing the length of the air line, which in turn increased the wheelbase requiring a dual relay valve system. The vehicles were manufactured with a single valve system.
Risk
If stopping distance was limited, a vehicle crash could result.
Remedy
Dealers will convert the single relay valve to a dual relay valve system free of charge. The recall began on may 21, 2007. Owners may contact kenworth at 425‑828‑5440.

Recall number 07V090000 · Recall details

What 2007 Kenworth T2000 owners say

Most recent owner complaints, unedited.

Filed Sep 3, 2008 · Brakes, Suspension · 214,993 miles · MN

Truck pulled away from a dock. Lr brake chamber locked up and super single tire slid and then blew out. Service truck had to come and brake chamber was replaced. This replaced brake chamber is available at our warehouse. Update 10/01/08 *cw the axle locked up. Updated 10/02/08.

Filed Sep 3, 2008 · Brakes · 198,755 miles · MN

Brake chamber mounts cracked. Took to dealer and they replaced three brake chambers. (one was replaced in october 2007).

Filed Sep 3, 2008 · Brakes · 194,002 miles · MN

Found four brake chambers broken. Took to dealer and they replaced all four.

Filed Sep 3, 2008 · Brakes · 118,115 miles · MN

Left front drive axle brake chamber broken at mounting plate. Took to dealer and they replaced brake chamber.

Filed Sep 3, 2008 · Brakes · 186,087 miles · MN

Both front drive axle brake chamber mounts cracked. Took to dealer and they replaced both brake chambers.

Filed Sep 3, 2008 · Brakes · 187,101 miles · MN

Rear cover on left rear brake chamber broken. Took to dealer. They had to use torch to remove mounting studs to remove. Installed new brake chamber.

Filed Sep 3, 2008 · Brakes · 99,802 miles · MN

Both right hand drive brake chambers cracked. Took to dealer and they replaced both chambers.

Filed Sep 3, 2008 · Brakes · 119,195 miles · MN

Brake chamber fell off the axle- was hanging by hoses when service truck arrived to repair it at the 247 mile marker on hwy i94 in wi. Replaced complete chamber.

Filed Aug 21, 2008 · Brakes · 298,861 miles · MN

While driving to dealer left rear wheel brake assembly on front drive axel broke off of axel. Had truck been loaded and not bob tailing at the time this could have caused and accident as the failure rendered the brake totally in operative.

Filed Aug 21, 2008 · Brakes · 252,348 miles · MN

Two brake assemblies broke off axles and failed to stop vehicle in safe stopping distance. This has happened to 6 other known incidents in the last 6 months. The brake assemblies have to be rewelded to the axles of the vehicles before they can be operated again safely. This defect is on semi tractors carrying 80,000 lbs gross weight and they do not have safe stopping distance to avoid a crash with this defect.

Questions about the 2007 Kenworth T2000 brakes

Does the 2007 Kenworth T2000 have brakes problems?

Owners have filed 10 complaints about the brakes of the 2007 Kenworth T2000, 83% of all its complaints, more than any other problem.

At what mileage do 2007 Kenworth T2000 brakes problems start?

The typical (median) mileage in owner complaints is 194,002 miles.

Was there a recall on the 2007 Kenworth T2000 brakes?

Yes, 2 recalls: 09V239000, 07V090000. Check your VIN to see if your car still needs the free repair.

Other 2007 Kenworth T2000 problems

Suspension 2Steering 1Transmission 1

VIN decoder

See the problems and recalls for an exact car

Buying a used 2007 Kenworth T2000?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history