The worst 2019 Kenworth T270 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 5
Steering: critical fasteners
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2018-2020 Kenworth T270, T370, T440, T470, T660, T680, T880, T800, W900, W990; and 2018-2020 Peterbilt 330, 337, 348, 365, 367, 389, 520, 567, and 579 vehicles. The Dana D-Series axle steer arm fasteners that attach the steering arm to the steering knuckle may fail.
- Risk
- Fastener failure can result in a loss of steering control, increasing the risk of a crash or injury.
- Remedy
- Dealers will replace and torque the steer arm fasteners, at no charge. Owner notification letters were mailed November 8, 2022. Owners may contact Kenworth customer service at 1‑425‑828‑5888 and Peterbilt customer service at 1‑940‑591‑4220. PACCAR's numbers for this recall are 22 PBB and 22 KWB.
Recall number 22V277000 · Recall details
Fuel system, diesel: fuel injection system: fuel rail
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2018-2021 Peterbilt 337, 348, 365, 367, 520, 567, Kenworth T270, T370, T440, T470, T800 and T880 vehicles. The sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak.
- Risk
- A fuel leak in the presence of an ignition source increases the risk of a fire.
- Remedy
- Dealers will inspect the rail threads and fuel lines, and replace the rail as necessary, free of charge. Owners may contact PACCAR customer service at 1‑425‑828‑5888 (Kenworth) or 1‑940‑591‑4220 (Peterbilt). PACCAR's numbers for this recall are 21KWC and 21PBD.
Recall number 21V391000 · Recall details
Service brakes, air: antilock: ABS warning light
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2008-2019 Peterbilt 330, 335, 337, 340, 348, 365, 367, 384, 386, 387, 388, 389, 567, 579 and 587 vehicles and 2008-2020 Kenworth T170, T270, T370, T660, T680, T800, T880, and W900 vehicles equipped with NAMUX Software. In the event that the Anti-lock Brake System (ABS) loses battery and/or ignition power to the controller, the dash warning light for the ABS may not illuminate to warn the driver of the loss of ABS. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems," and 136, "Electronic Stability Control System on Heavy Vehicles."
- Risk
- If the driver unknowingly operates the vehicle without the ABS functioning, there would be an increased risk of a crash.
- Remedy
- PACCAR will notify owners, and dealers will update the NAMUX software within the cab control module, free of charge. PACCAR issued owners an interim notification on June 4, 2020. The recall began May 26, 2020. Owners may contact Kenworth customer service at 1‑425‑828‑5888 or Peterbilt customer service at 1‑940‑591‑4220. PACCAR's number for this recall is 20pbc AND 20KWB.
Recall number 20V199000 · Recall details
Power train: clutch assembly
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2018-2019 Peterbilt 337, 348, 365, 367, 389, 567, 579 and 587 trucks and 2018-2019 Kenworth C500, T270, T370, T440, T660, T680, T800, T880 and W900 trucks equipped with automated manual transmissions. An internal component in the clutch assembly may fail, possibly resulting in unintended vehicle movement.
- Risk
- Unintended movement of a vehicle can increase the risk of a crash.
- Remedy
- PACCAR will notify owners, and dealers will update the transmission control module, free of charge. The recall began February 23, 2019. Owners may contact PACCAR customer service at 1‑940‑591‑4220. PACCAR's numbers for this recall are 18PBE and 18KWH.
Recall number 18V931000 · Recall details
Power train: axle hubs
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2019 Kenworth T270 and T370 vehicles. The rear hub axle nut on these vehicles may have been over tightened, possibly causing bearing failure or a fire.
- Risk
- Bearing failure can cause wheel separation, increasing the risk of crash.
- Remedy
- PACCAR will notify owners, and dealers will disassemble the rear hub assembly, and install new bearings and re-assemble the hub, free of charge. The recall began June 22, 2018. Owners may contact PACCAR customer service at 1‑918‑259‑3258. PACCAR's number for this recall is 18KWC.
Recall number 18V359000 · Recall details
Technical service bulletins for the 2019 Kenworth T270 20
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Replaced obsolete SRT codes with updated SRT codes.
- Kenworth: Dealers should check the chassis list and SIR weekly for VIN changes
- Bogie Crossmember Torque Value Update
- Info Only
- Safety Recall â Interim Notification
- Due to major data carriers phasing out 3G networks, chassis currently utilizing first generation Peoplenet...
- Fix-As-Fail – Due to undersupply issues, only a limited supply of Diesel Exhaust Fluid (DEF) sensors are...
- Safety Recall â Cummins Fuel Rail Leak â the federal safety agency ID: 21V391 / TC: 2021-323, Cummins...
- Information Only – Windshield washer pumps have a high No Trouble Found rate
- Fix-As-Fail
Compare the 2019 Kenworth T270
Other model years
Questions about the 2019 Kenworth T270
Is the 2019 Kenworth T270 reliable?
Owners have filed 0 complaints about the 2019 Kenworth T270.
What is the most common problem with the 2019 Kenworth T270?
There are not enough complaints to tell.
How many recalls does the 2019 Kenworth T270 have?
5 recalls, covering steering, fuel system, diesel and service brakes, air.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2019 Kenworth T270?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history