The worst 2018 Kenworth T440 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 5
Service brakes, air: supply: reservoir/tank
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2009-2021 Kenworth C500, 2012-2021 Kenworth T440, 2009-2015 Kenworth T660, 2015-2024 Kenworth T680, 2009-2024 Kenworth T800, 2009-2020 Kenworth T370, 2014-2023 Kenworth T880, 2011-2016 Kenworth T470, 2023 Kenworth T480, and 2009-2019 Kenworth W900 vehicles. The air tanks have an insufficient volume of air for the brake system. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 121, "Air Brake Systems."
- Risk
- Insufficient air volume can reduce braking performance and increase the risk of a crash.
- Remedy
- Dealers will install the correct volume air tanks, free of charge. Owner notification letters were mailed August 12, 2024. Additional owner notification letters were mailed October 27, 2025. Owners may contact PACCAR customer service at 1‑425‑828‑5888. PACCAR's number for this recall is 24KWD.
Recall number 24V145000 · Recall details
Steering: critical fasteners
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2018-2020 Kenworth T270, T370, T440, T470, T660, T680, T880, T800, W900, W990; and 2018-2020 Peterbilt 330, 337, 348, 365, 367, 389, 520, 567, and 579 vehicles. The Dana D-Series axle steer arm fasteners that attach the steering arm to the steering knuckle may fail.
- Risk
- Fastener failure can result in a loss of steering control, increasing the risk of a crash or injury.
- Remedy
- Dealers will replace and torque the steer arm fasteners, at no charge. Owner notification letters were mailed November 8, 2022. Owners may contact Kenworth customer service at 1‑425‑828‑5888 and Peterbilt customer service at 1‑940‑591‑4220. PACCAR's numbers for this recall are 22 PBB and 22 KWB.
Recall number 22V277000 · Recall details
Electrical system: wiring
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2016-2022 Peterbilt 567, 579, 2021-2022 Peterbilt 536, 2017-2021 Kenworth T880, 2016-2022 Kenworth T680, 2018-2020 Kenworth T440, 2020 Kenworth T270, and 2021 Kenworth T280 vehicles. The methane detection system will not function if the system loses power.
- Risk
- The operator may be unaware of a system malfunction or the presence of excessive methane levels, increasing the risk of injury or fire.
- Remedy
- Dealers will re-wire the warning alarm, free of charge. Owner notification letters were mailed December 1, 2022. Owners may contact Peterbilt customer service at 1‑940‑591‑4220, and Kenworth customer service at 1‑425‑828‑5888. PACCAR's numbers for this recall are 21KWH and 21PBN.
Recall number 21V00N000 · Recall details
Fuel system, diesel: fuel injection system: fuel rail
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2018-2021 Peterbilt 337, 348, 365, 367, 520, 567, Kenworth T270, T370, T440, T470, T800 and T880 vehicles. The sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak.
- Risk
- A fuel leak in the presence of an ignition source increases the risk of a fire.
- Remedy
- Dealers will inspect the rail threads and fuel lines, and replace the rail as necessary, free of charge. Owners may contact PACCAR customer service at 1‑425‑828‑5888 (Kenworth) or 1‑940‑591‑4220 (Peterbilt). PACCAR's numbers for this recall are 21KWC and 21PBD.
Recall number 21V391000 · Recall details
Power train: clutch assembly
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain 2018-2019 Peterbilt 337, 348, 365, 367, 389, 567, 579 and 587 trucks and 2018-2019 Kenworth C500, T270, T370, T440, T660, T680, T800, T880 and W900 trucks equipped with automated manual transmissions. An internal component in the clutch assembly may fail, possibly resulting in unintended vehicle movement.
- Risk
- Unintended movement of a vehicle can increase the risk of a crash.
- Remedy
- PACCAR will notify owners, and dealers will update the transmission control module, free of charge. The recall began February 23, 2019. Owners may contact PACCAR customer service at 1‑940‑591‑4220. PACCAR's numbers for this recall are 18PBE and 18KWH.
Recall number 18V931000 · Recall details
See all 5 recalls for the 2018 Kenworth T440
Defect investigations
Quarter Fender Failures
The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE21-015) based on one Vehicle Owner Questionnaire (VOQ) and supporting fleet reports. The reports indicated that the subject quarter fenders were prone to cracking and/or separation.After a comprehensive review of the data related to the quarter fender failures on the subject vehicles, ODI did not identify the existence of a safety-related defect trend. Quarter fender failures resulted in a warranty claim rate less than one percent (<1%) of the total vehicle population. All separations, including those due to tread separations, road hazards, etc., accounted for less than point one percent (<0.1%) of the total vehicle population.ODI discovered that the minimum recommended gap between the top of the quarter fender and the bottom of the trailer was not known or being followed. The optional quarter fenders were supplied by Fontaine Spray Systems (FSS), who recommended a two inch (2) gap. ODI analyzed the claim data using a calculated gap. A calculated gap using the top of the quarter fender flap and assuming the trailer is level with the top of the fifth wheel hitch was necessary, as PACCAR doesn't know specifically what trailer a purchaser will couple to the tractor. It is safe to assume no trailers on the market extend below the upper fifth wheel plate, but many do provide additional clearance over the wheels where the quarter fenders are located. ODI determined that 94 percent of warranty claims and 84 percent of separations violated FSS' recommendation.ODI confirmed that the VOQ vehicle and the fleet report vehicles also violated FSS' recommended gap. In one fleet the gap was negative point three inches (-0.3).PACCAR has updated its vehicle specification process and issued a customer advisory notice to existing owners. In light of the low rate of reported failures and separations, further use of agency resources does not appear to be warranted. The closing of this investigation does not constitute a finding by the federal safety agency that no safety-related defect exists. The agency reserves the right to take further action if warranted by the circumstances.
PE20015
Technical service bulletins for the 2018 Kenworth T440 21
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Replaced obsolete SRT codes with updated SRT codes.
- Kenworth: Dealers should check the chassis list and SIR weekly for VIN changes
- Safety recall
- Info Only
- Safety Recall â Interim Notification
- Due to major data carriers phasing out 3G networks, chassis currently utilizing first generation Peoplenet...
- Fix-As-Fail – Due to undersupply issues, only a limited supply of Diesel Exhaust Fluid (DEF) sensors are...
- Safety Recall â Cummins Fuel Rail Leak â the federal safety agency ID: 21V391 / TC: 2021-323, Cummins...
- Information Only – Windshield washer pumps have a high No Trouble Found rate
- Fix-As-Fail
Compare the 2018 Kenworth T440
Other model years
Questions about the 2018 Kenworth T440
Is the 2018 Kenworth T440 reliable?
Owners have filed 0 complaints about the 2018 Kenworth T440.
What is the most common problem with the 2018 Kenworth T440?
There are not enough complaints to tell.
How many recalls does the 2018 Kenworth T440 have?
5 recalls, covering service brakes, air, steering and electrical system.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2018 Kenworth T440?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history