1996 Kenworth T600 recalls
There are 5 safety recalls on record for the 1996 Kenworth T600, covering 23,996 vehicles in total across all the models in each campaign. Newest first.
All recalls
Suspension: front: control arm: lower arm
- What is wrong
- Vehicle description: vehicles equipped with 54" rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker. The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.
- Risk
- Failure of the lower sway arm attaching bolts could result in loss of vehicle control.
- Remedy
- Dealers will replace the lower sway arm brackets. Owner notification began march 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.
Recall number 01V051000 · Recall details
Electrical system: wiring: front underhood
- What is wrong
- Vehicle description: heavy duty trucks equipped with caterpillar 3406e engines. The routing of the electrical and fuel lines can cause chaffing of the wiring harness on the fuel line.
- Risk
- This chaffing can cause fuel leakage and a potential for a fire in the engine compartment.
- Remedy
- Dealers will inspect, adjust, and repair, if necessary, the fuel line and electrical harness.
Recall number 98V129000 · Recall details
Suspension: front: hub
- What is wrong
- Vehicle description: heavy duty trucks equipped with design level 1, rockwell ff980 series front axle. The front axle hub flange can develop cracks due to high stress levels.
- Risk
- Cracks in a hub flange can result in a wheel separation.
- Remedy
- Dealers will remove and replace the front hubs with an improved design level 2 hub.
Recall number 97V196003 · Recall details
Suspension: rear
- What is wrong
- Vehicle description: heavy duty trucks equipped with kenworth airglide 200 rear suspension. Due to materials used in the sway bar arms and studs as well as the stud plating material, stress corrosion cracking and bending fatigue can occur in the rear suspension sway bar arms and studs causing the stud to fail prematurely.
- Risk
- This could cause a loss of steering control increasing the risk of a vehicle crash.
- Remedy
- Dealers will replace the arm assembly manufactured from a different material. New studs will be installed with different threads and different finish.
Recall number 97V139000 · Recall details
Exterior lighting: turn signal: switch
- What is wrong
- The wires that correspond to the vehicle's rear turn signals were reversed when installed in the electrical connector.
- Risk
- This condition will cause the rear turn signals to flash opposite from the direction intended by the driver increasing the risk of a vehicle accident.
- Remedy
- Dealers will inspect the turn signal switch and, if necessary, replace the turn signal switch.
Recall number 96V056000 · Recall details
Questions about the 1996 Kenworth T600 recalls
How do I check if my 1996 Kenworth T600 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1996 Kenworth T600 have?
5, covering suspension, electrical system and exterior lighting.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Kenworth T600?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history