1992 Lincoln Town Car recalls
There are 4 safety recalls on record for the 1992 Lincoln Town Car, covering 4,111,532 vehicles in total across all the models in each campaign. Newest first.
All recalls
Vehicle speed control
- What is wrong
- On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.
- Risk
- This could result in an underhood fire.
- Remedy
- Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected october 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on august 13, 2007, and mailing completed by september 19, 2007. Owners may contact ford at 1‑888‑222‑2751.
Recall number 07V336000 · Recall details
Electrical system
- What is wrong
- Vehicle description: passenger vehicles. The speed control deactivation switch can develop a resistive short in the electrical circuit that could potentially result in an underhood fire. A fire is possible both when the vehicle is running and when the vehicle engine is off. Also, the short could disable the speed control system or cause the brake light fuse to open.
- Risk
- A fire can originate in the left front underhood area.
- Remedy
- Dealers will install a new speed control deactivation switch and connector shell. Owner notification began may 20, 1999.
Recall number 99V124000 · Recall details
Suspension: front: control arm: lower ball joint
- What is wrong
- Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint can weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.
- Risk
- If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.
- Remedy
- Dealers will replace the lower control arm ball joints (2).
Recall number 98V322000 · Recall details
Latches/locks/linkages: hood: latch
- What is wrong
- The secondary hood latch may not engage when the hood is closed.
- Risk
- In the event the primary hood latch releases or is not properly latched when the vehicle is in motion, the hood could fly up obstructing the operator's vision, and increasing the potential for a vehicle accident.
- Remedy
- Dealers will replace the hood latch assembly.
Recall number 95V151000 · Recall details
Questions about the 1992 Lincoln Town Car recalls
How do I check if my 1992 Lincoln Town Car has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1992 Lincoln Town Car have?
4, covering vehicle speed control, electrical system and suspension.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1992 Lincoln Town Car?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history