Tl*the contact owns a 1994 lincoln town car. The ABS warning light illuminated. When the contact depressed the brake pedal and attempted to stop, the vehicle failed to stop completely. The contact had to apply excessive force to the brake pedal, apply the emergency brake, and place the vehicle in neutral in order for it to stop. Occasionally, he has to open the vehicle door and apply the emergency brake at a certain angle. Additionally, brake fluid is leaking into the vehicle and onto the brake pedal. He was informed that the primary and secondary cups may have leaked through the brake booster. The contact has been denied assistance from several dealers, emergency service mechanics, and an independent mechanic. The speed was unknown. The failure mileage was 237,576 and current mileage was 295,350.
1994 Lincoln Town Car: ABS light or ABS activating
7 of the 155 complaints about the 1994 Lincoln Town Car describe ABS light or ABS activating.
- owner complaints
- 7
- of this car's complaints
- 5%
- recalls
- 3
ABS light or ABS activating by model year
What owners say
Vehicle parked for 2 hours. Owner noticed smoke coming from under hood after returning. Hood was raised and flames shot out. Flames extinguished. Vehicle towed to dealer. Mechanic determined cause was ABS pressure sensor switch.*ak * referenced in ea02-025
An electrical short or shock in wiring harness caused air bag light to be illuminated on dash. Also, front ABS brakes were inoperable. Consumer has contacted dealer. Please provide any further details.
The car has ABS brakes. When the brakes get wet, thevehicle pulls to the left.
The ABS system has failed. The pedal goes to the floor and the car will not stop. Please describe. Tt
Abs, driving vehicle at speed 35 MPH, brakes locked up, vehicle slid at 5:00 position, hitting a parked vehicle. Tt
Abs braking system failed resulting in an accident. Tt
Service bulletins that may apply
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Some vehicles may cycle when brakes are applied on rough roads or on an incline while making a sharp turn
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- Availability of hub-mount brake rotor machining equipment
- Subject regarding the availability of hub-mount brake rotor machining equipment
- Brakes - elimination of sanding rotors and drums - service tip
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because...
Related recalls
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Improper installation of the rear brake line at the point at which the extended brake line first bends and extends over the left rear wheel area of the frame. If not installed with sufficient clearance, chafing of the brake line can occur in an area adjacent to the rear floor pan.
- Risk
- The rear brake line can leak or rupture resulting in reduced braking capability, loss of rear brakes, and/or loss of brake fluid reserves in the master brake cylinder.
- Remedy
- Dealers will inspect the brake line for proper installation and/or damage and replace as necessary. Also a protective boot or sleeve over the brake line will be installed.
Recall number 95V133000 · Recall details
Service brakes, hydraulic: foundation components
- What is wrong
- The nuts and bolts that attach the rear brake adaptor to the axle housing flange can loosen and eventually separate. If one or more of the nuts come off the bolts, damage to the parking brake assembly or to the antilock brake system (ABS) sensor and sensor ring (if so equipped) will occur. If all four nuts on one end of the axle come off the bolts, damage to the brake hydraulic line or the parking brake cable can occur.
- Risk
- Occurrence of any of these conditions can result in a loss of braking capability and possible accident.
- Remedy
- Dealers will inspect and, if needed, install new bolts. If any of the fasteners are disconnected, the parking brake and ABS components will be inspected and serviced.
Recall number 94V152000 · Recall details
Service brakes, hydraulic: pedals and linkages
- What is wrong
- The brake pedal push rod retainer (hairpin clip) may be missing or not properly installed on the service brake pedal. This can cause disengagement of the brake pushrod and loss of braking ability.
- Risk
- Loss of braking ability can result in a vehicle accident.
- Remedy
- Dealers will inspect and, if necessary, replace the retainer.
Recall number 94V129000 · Recall details
Questions about the 1994 Lincoln Town Car abs
Is ABS light or ABS activating a common problem on the 1994 Lincoln Town Car?
7 of 155 owner complaints about the 1994 Lincoln Town Car (5%) mention ABS light or ABS activating. The model year with the most reports is 1995.
Is there a recall or service bulletin for this on the 1994 Lincoln Town Car?
There are 3 recalls and 9 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1994 Lincoln Town Car
Fire or smoke 25Adaptive cruise 11Ball joint 10Headlights 7Tire blowout 6Brake failure 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Lincoln Town Car?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history