2005 Mack CX recalls

What is wrong

Mack is recalling 34,269 my 1999-2005 cx and my 2004-2008 cxn trucks. The headlight switch may prematurely fail resulting in inoperative or intermittent headlights.

Risk

The head lights may not operate properly which could result in intermittent or no headlight function. This could impair a driver's visibility, increasing the risk of a crash.

Remedy

Dealers will replace the headlight switch. The recall began on february 27, 2009. Owners may contact mack at 1‑800‑528‑6586.

Recall number 08V688000 · Recall details

What is wrong

On certain trucks equipped with aset AC model engines, the engine as configured with an external exhaust gas recirculation system makes servicing the fuel injection lines difficult when using traditional tools. Therefore, it is possible for fuel leaks to develop when removing and installing the fuel injection lines.

Risk

A leak in the fuel injection line may spray fuel on the hot surfaces of the exhaust gas recirculation system, which could result in an engine fire.

Remedy

Dealers will replace the fuel injection lines free of charge. Note: this recall supersedes a previous campaign conducted in 2006 (please see 06v392). The recall began on september 11, 2007, with subsequent mailings every six weeks until april 2008. Owners may contact mack at 800‑528‑6586.

Recall number 07V401000 · Recall details

What is wrong

On certain trucks, a leak in the aset AC fuel injection line may spray fuel on the exhaust gas recirculation pipes that carry hot exhaust gases .

Risk

This could potentially result in an engine fire.

Remedy

Mack has issued a stop work on this campaign under further notice (2-22-2007). The remedy does not adequately address the issue on all vehicles. Mack will re-release the recall in the near future. (please see the federal safety agency no. 07v159/mack recall no. Sco323 for vehicles that have had this repair already performed.) this recall has been superseded (please see 07v401/sc0324).

Recall number 06V392000 · Recall details

What is wrong

On certain heavy duty class 8 trucks equipped with holland air suspension systems, a transverse beam casting may fracture under normal loads. If a casting breaks when the vehicle is traveling on a roadway there is the potential for pieces of the casting to become projectiles and the suspension's transverse beam may drop down low enough to contact the road surface.

Risk

This will cause sparks that could potentially ignite and cause a fire.

Remedy

Dealers will inspect and replace the defective transverse beam assemblies. The recall began on august 19, 2005. Owners may contact mack trucks at 610‑709‑2131.

Recall number 05V312000 · Recall details

What is wrong

On certain heavy duty class 8 diesel trucks equipped with aset AC engines, the location of the fuel inlet hose may result in overheating or abrasion of the hose, which may lead to a premature failure.

Risk

If the hose fails, fuel can be sprayed on the exhaust manifold, which could potentially lead to an engine compartment fire.

Remedy

Dealers will repair and replace the fuel inlet hose free of charge. The recall began on february 14, 2005. Due to some quality and supply issues with parts to support this safety recall, owners may have been informed during april 2005,that the safety recall was on hold. These issues have now been resolved. For owners who have not had their vehicle(s) repaired, contact a mack parts and service center immediately to schedule an appointment to have your vehicle(s) repaired. Owners may contact mack trucks at 610‑709‑2131.

Recall number 05V015000 · Recall details