The worst 2008 Mack Mru problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 5
Parking brake
- What is wrong
- Mack Trucks, Inc. (Mack) is recalling certain 2008-2019 TerraPro (MRU) and 2019-2022 TerraPro (TE) vehicles. A brake control valve air leak into the attached exhaust hose can create excessive back pressure, causing the parking brake to release unexpectedly.
- Risk
- The unexpected release of the parking brake may allow the vehicle to rollaway, increasing the risk of a crash.
- Remedy
- Dealers will remove the exhaust tube and fitting from the valve, free of charge. Owner notification letters were mailed February 8, 2022. Owners may contact Mack customer service at 1‑800‑866‑1177. Mack's number for this recall is SC0433.
Recall number 21V953000 · Recall details
Electrical system
- What is wrong
- Mack Trucks is recalling certain model year 2008-2009 GU, LEU, and MRU trucks, manufactured from December 12, 2007, through May 8, 2008 and equipped with a certain focal mounted retarder control box. The control box may lose its electrical ground.
- Risk
- If the control box loses ground, it may have localized overheating. This could lead to a vehicle fire.
- Remedy
- All affected vehicles were sold to one customer that has already been notified. An official owner notification letter will be mailed to the one customer in early November 2012. Mack will replace the suspect control box on the affected vehicles, free of charge. Owners may contact Mack Trucks at 1‑800‑866‑1177.
Recall number 12V519000 · Recall details
Electrical system
- What is wrong
- Mack trucks is recalling certain model year 2008-2012 mru and leu heavy trucks manufactured from january 3, 2007, through february 3, 2011. The electrical circuitry in these vehicles may not provide adequate overcurrent protection.
- Risk
- In the event of an electrical overage, the fuse that should prevent the over current from reaching the mirror switch circuit may fail, such that the mirror switch can overheat. An overheated switch could cause a vehicle fire.
- Remedy
- Dealers will install a relay harness to prevent the mirror switch from overheating. They will also inspect the mirror switch and if signs of overheating are shown, replace that switch. All inspections and repairs will be performed free of charge. The safety recall began on june 30, 2011. Owners may contact mack trucks at 1‑800‑866‑1177.
Recall number 11V212000 · Recall details
Service brakes, air
- What is wrong
- Mack is recalling certain model year 2008 through 2011 gu and mru model vehicles manufactured with a front tow glad hand option. The actuation and release timing of the vehicles exceeds the limit which fails to conform to the requirements of federal motor vehicle safety standard no. 121, "air brake systems."
- Risk
- If the brakes do not perform as they should, a vehicle crash could occur.
- Remedy
- Mack will notify owners and repair the vehicle free of charge. The safety recall began on february 1, 2011. Owners may contact mack at 1‑877‑800‑4945.
Recall number 10V404000 · Recall details
Exterior lighting
- What is wrong
- On certain trucks, the daytime running lights (drl) module may contain a suspect metal-oxide-semiconductor field effect transistor (mosfet) that could overheat.
- Risk
- If the transistor overheats, it could possibly result in a vehicle fire.
- Remedy
- Dealers will replace the suspect drl module free of charge. The recall began on october 31, 2007. Owners may contact mack trucks at 1‑800‑528‑6586.
Recall number 07V478000 · Recall details
See all 5 recalls for the 2008 Mack Mru
Defect investigations
Vehicle Roll Away
On April 1, 2020, following information received from the Office of Defects Investigation (ODI) network of fleet contacts, ODI opened PE20-003 to investigate reports of vehicle roll away in certain model year (MY) 2008-2020 Autocar and Mack refuse trucks equipped with certain Bendix PP-1 push-pull pneumatic park brake control valves with a pipe-away exhaust configuration. Prior to ODIâs investigation,[KK(1]Â Bendix Commercial Vehicle Systems LLC (Bendix), the subject component manufacturer, published two related technical service bulletins (TSBs): Bendix Push-Pull Type Control Valves Service Data SD-03-3611 Rev. 007 (2019-03) and Bendix PP-1 & PP-8 Park Control Valve Wear and Replacement Notice Technical Bulletin TCH-003-056 (2019-11-20). ODI sent Information Request (IR) letters to motor vehicle manufacturers Autocar LLC (Autocar) and Volvo Trucks North America/Mack Trucks, Inc. (Volvo/Mack) and motor vehicle equipment manufacturer Bendix. IR response data from all three manufacturers was analyzed and cross-referenced to gain further understanding. To date, ODI is aware of 5 vehicle roll-away incidents related to the alleged defect condition in the subject vehicles equipped with the subject components, resulting in 4 crashes and 1 injury. On December 9, 2021, Volvo/Mack notified the agency of a safety recall (21V953) to address a safety defect in certain MY 2008-2019 TerraPro (MRU) and MY 2019-2022 TerraPro (TE) trucks originally equipped with the subject components. [KK(2]Â On January 1, 2023, Autocar notified the agency of a safety recall (23V023) to address a safety defect in certain MY 2008-2020 ACX (Xpeditor), MY 2012-2020 ACMD (Xpert), MY 2010-2020 ACTT (Xspotter), MY 2008-2010 WX and MY 2008-2010 WXLL trucks. Volvo/Mack and Autocar's recall remedies involve removing the vent line fitting threaded into the exhaust port of the subject PP-1 valve. [VD(3]Â Both Autocar and Mack have stopped equipping new refuse trucks with park control valves using the exhaust pipe-away configuration. After discussions between ODI and Bendix concerning ways to prevent new PP-1 valves from being sold and installed with a potential for the exhaust to become restricted, Bendix will take the following actions: 1) issue a letter to all original equipment (OE) customers with important safety information warning them about the safety risk of attaching plumbing to the exhaust port when the subject component is used as a park control valve; and 2) affix a warning label on all aftermarket parts warning not to install pipe-away exhaust port plumbing. In view of the recalls being conducted by Volvo/Mack and Autocar, and the actions taken by Bendix, ODI has closed this Preliminary Evaluation. The closing of this investigation does not constitute a finding by the federal safety agency that a safety-related defect does not exist in equipment or other model or MY vehicles that have not been recalled. The agency reserves the right to take further action if warranted.
PE20003
Technical service bulletins for the 2008 Mack Mru 174
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
Compare the 2008 Mack Mru
Other model years
Questions about the 2008 Mack Mru
Is the 2008 Mack Mru reliable?
Owners have filed 0 complaints about the 2008 Mack Mru.
What is the most common problem with the 2008 Mack Mru?
There are not enough complaints to tell.
How many recalls does the 2008 Mack Mru have?
5 recalls, covering parking brake, electrical system and service brakes, air.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Mack Mru?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history