2000 Mazda MPV brakes problems

Filed Feb 4, 2021 · Brakes, Engine · CA

The federal safety agency 01v382000 manufacturer campaign # 0520a 12/20/2001 remedy available dx brake lines and valves. As vehicle is in operation front suspension shakes very bad about 35mph to 50mph does not feel safe to drive on hwy.

Filed Oct 30, 2009 · Brakes · 122,000 miles · CA

Tl*the contact owns a 2000 mazda mpv. He stated that the rear brake pads were wearing prematurely. There was a recall on the brakes; however, his VIN was not included in the federal safety agency campaign id number: 01v382000. The brake pads were replaced accordingly. The manufacturer refused to take any liability for the recall repairs. The VIN was not available. The failure and current mileages were under 122,000.

Filed Apr 26, 2006 · Brakes · 24,816 miles · PA

Vehicle: 2000 mazda mpv lx VIN: [xxx] mileage at incident: 24,816 I am the original owner of this vehicle, purchased in august, 1999 my wife was backing the van out of our garage, and when she placed he foot on the brake pedal to slow her backing, a snapping noise occurred and the brake pedal went all the way to the floor. Complete loss of braking ability. Luckily no crash or injuries involved. I had the vehicle repaired at a local monroe muffler brake shop (cost $343). The master cylinder had failed... Completely. Again, complete failure of the hydraulic braking system. *nm updated 07/16/2012

Filed Mar 1, 2005 · Brakes · 36,000 miles · NY

While applying the brake from 56-60 MPH the brake pedal got hard, and the vehicle experienced extended stopping distances before it v was able to stop. Vehicle was taken to a repair shop, and mechanic determined that they could not find anything wrong. Dealer was not notified.

Filed Nov 5, 2003 · Body, Brakes · NY

Consumer states while vehicle was parked with the emergency parking brake on, the vehicle started to move forward. *ak the gear shift would stick in park or move by itself, the right rear door would open while the vehicle was in motion and failed to close properly, and one of the seat belts was installed backwards. *scc

Filed Feb 4, 2003 · Brakes · 70,000 miles · GA

When excelerating on the initial depression of the pedal, car will not excelerate, seems 'stuck'. For the car to move you must depress the pedal further which results in a sudden high speed exceleration, in a jumping fashion. This is true in drive or reverse. When mazda dealer service rep. Was contacted she said there had been several problems reported to that dealership of the same nature but not recalls or service bulletins have been reported.

Filed Sep 18, 2002 · Brakes · VA

Whenever vehicle is put it in reverse it makes a noise. Took vehicle to the dealer on three different occasions, and was unable to locate cause of problem, the consumer believes the brake system may be the problem.

Filed Feb 12, 2002 · Brakes · NJ

While driving could step on the brakes pedal and experience an extended stopping distance. Had received recall notice 01 v 382 000 from manufacturer. Please provide more information.

Filed Jan 31, 2002 · Brakes · SC · crash

Consumer stated when the brakes were applied at 65mph while exiting off a ramp, there was extended stopping distance which resulted in a collision.*ak

Filed Jan 17, 2002 · Brakes · NY

Clocking noise when brakes applied at low speed, moving forward or backwards. No recall or design for the brakes attachment pad clips which are causing the clocking noise.