2017 Mercedes-Benz Gle technical service bulletins
85 technical service bulletins and manufacturer communications cover the 2017 Mercedes-Benz Gle.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Update software of AIR BODY CONTROL (ABC) control unit
- Seat kinetics for front passenger seat not available on vehicles without SA code 275
- MBUX multimedia system: High-frequency interference noise from speakers
- Vehicle is temporarily unable to be locked or unlocked using Keyless-Go
- Comand
- MBUX multimedia system: The central display turns dark, interference noise emitted from speakers
- Seats cannot be adjusted because of low battery voltage
- Audio 20: Apple CarPlay displays pixelated image
- Seats cannot be adjusted due to low battery voltage
- Fault message "SRS
- Corrosion at electrical connecting point between front bumper and interior (X174/1)
- Fault codes P054A00 or P054C00 activate the engine diagnosis warning lamp
- Shift Quality 3-2 and/or 2-3 shift
- Noises from seat climate control/ seat ventilation
- Check Front Left Underbody, Rework if Necessary
- Info-Call/S24H-Call/MB Contact: Change of language setting at customer request
- Broken sliding sunroof operating switch in the overhead control panel
- Audio 20: Symbols in the status line in the central display can overlap
- Cracking noises at doors in area of window frame
- Height adjustment of electric steering column adjustment sticks at top end stop
- Warnings without obvious
- Height adjustment of electric steering column adjustment does not operate
- High-frequency whistling noise when driving at high speeds
- B-pillar trim chafed through at height of seat belt outlet
- Odor in passenger compartment
- Update HERMES control unit software
- Fault message "AIRMATIC" or "Active Curve System" in instrument cluster
- AIRMATIC fault message in instrument cluster
- Vehicle does not start, battery discharged.
- Comand
- Instrument cluster: Always boots in main menu (trip/total mileage) / Last mode inoperative
- Direct starting/ ECO start/stop inoperative and fault code B21059A current and stored in CBC (front SAM)
- Instrument cluster: HOLD indicator continues to be lit for a few seconds although the vehicle is moving
- Correct Torque of Front Left and Right Torsion (Stabilizer) Bar Linkage Nut
- Squeaking noises from area of front axle brake
- Service: Service display implausible
- Replace Fasteners for Rear Axle Camber Adjustment
- Starter battery discharged due to excessively high quiescent current
- Distronic distance control
- BR166 and BR292
- Pop-up roof: Glass roof jams or cannot be opened, drive unit makes rattling noises
- Comand
- Garmin MAP PILOT: Traffic information service and possibly voice control inoperative after navigation...
- Parking Pilot picture in COMAND display blurred
- Message "SOS
- Message in instrument cluster "Collision Prevention Assist Inoperative"
- Engine indicator lamp lights up and/or PreSafe, Blind Spot Assist and Distronic error messages in...
- Installing Electric Trailer Brake Controller
- Headlamps fogged
- Mbrace i-call may not complete
- The electric seat adjustment and/or the seat heater/seat ventilation or rear monitor is nonfunctional
- Belt holder/ retaining tab on side paneling in trunk is broken
- ACTIVE CURVE SYSTEM malfunction in instrument cluster in combination with the following fault codes in the...
- Rumbling noises from the area of the front axle.
- Brake linings on rear axle exhibit differential wear
- A production fault means that the telematics DVD A 166 827 14 00 cannot be used
- Cracking noises or squeaking noises at the doors in the area of the window frame while driving, especially...
- Apple products (iPhone or iPod) are not charged via the serial USB interface of the COMAND Online control...
- Sound system: Intermittent loss of sound after engine start
- The complete headliner can no longer be replaced for loose headliner magnets
- Cracking, clunking noise when braking the vehicle to a stop or when moving off, when the suspension...
- The rear seat heating cannot be activated when the customer has set the ambiance illumination to "Neutral"...
- Engine diagnosis warning lamp active
- The liftgate can no longer be opened when the ambiance illumination is set to stage 1 or 2.
- Oil spray or fouling on the ACTIVE CURVE SYSTEM is not related to leakage of the hydraulic pump.
- The key is not recognized in the electronic ignition switch, the vehicle cannot be started and/or the...
- Engine diagnosis warning lamp lights up
- Thumping noises from front axle when driving over bumps on road.
- Engine diagnosis warning lamp lights up. Fault code 20B91B, 20B913 (The output for the heating element of...
- Since 12/2012 (model 166) and since 06/2013 (model 242) the glass breakage loops are no longer in the side...
- Thumping noises at the front axle when driving over road bumps
- Single, throttle lift-off, clunking noise from the side shaft when starting off (audible at the wheel)
- 1. In vehicles up to VIN 166 ### #A 097760 without code 803, the following fault code is logged in the...
- Engine diagnosis warning lamp activated
- A flapping/rattling noise can be heard from the area of the center console towards the rear.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2017 Mercedes-Benz Gle?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history