1996 Mercury Grand Marquis technical service bulletins
119 technical service bulletins and manufacturer communications cover the 1996 Mercury Grand Marquis.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Ford/lincoln mercury: certain 1992-2001 model year crown victoria, grand marquis, and town car vehicles...
- Extended coverage program 05N04 - extended coverage for composite intake manifold
- Remote keyless entry (RKE) - service tips
- New transmission cooler flusher - service tips
- New service part - number 5 needle bearing and race kit - 4R70W transmission - service tip
- Climate control a/c service tech tips
- Lamp-brake-invadvertent disabling of brake shift interlock
- Transfer service tips for the front wiper motor mount bracket and depressed park output arm
- Some vehicles may exhibit an intake manifold crossover (first runner) coolant seepage condition
- Some engine assemblies with aluminum cylinder heads repaired in-vehile have been found to leak coolant...
- Engine oil system priming procedures, service tips for reports of premature engine failure
- Parts and procedure to reduce the potential of fuel tank punctures during rare and extremely high-speed...
- Brake shift interlock
- Some vehicles may exhibit heater core leaks
- Information regarding transmission fluid usage charts
- Some vehicles may exhibit a fead belt jump-off toss
- Some vehicles built 04/15/2000 or earlier equipped with a keyless entry system may exhibit an inoperative...
- Information on replacing fuel tank strap bolts
- Subject regarding engine oil recommendations for use in 2001 vehicles - sae 5W-20 motor oil
- Subject regarding contamination from prior transmission concerns or excess wear may be trapped in the...
- Subject regarding climate control - eatc - blower motor control service tips
- Information on programming remotes after driver door module replacement
- Some vehicles may exhibit a bang / popping noise heard from the exhaust system during cool-down
- Some vehicles may exhibit an inoperative keyless entry pad
- Brief information regarding vehicles that exhibit yellowing of the headlamps
- Subject regarding keyfob programming information - service replacement drivers door module
- Some vehicles may exhibit yellowing of the headlamps
- Information regarding the new transmission cooler flusher- service tip
- Information on replacing and / or repairing malfunctioning (door, ignition and decklid) locks
- Subject on a wire harness terminal repair kit available for repairing electrical wiring harnesses
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Service information for musty and mildew type odors coming from the air conditioning / heating system
- Information on identifying non-approved / alternate refrigerants which could cause safety, and performance...
- Information on the new flush and fill tool available through rotunda
- Some vehicles may exhibit a bang popping noise heard from the exhaust system during cool-down
- Conditions with the brake lamps inadvertently disabling the brake shift interlock
- Information designed to aid in the diagnosis, testing and repair of noise, vibration and harshness (NVH)...
- Experiencing a whine / buzz type noise in the speakers of the entertainment radio or two-way radio on...
- Ford motor company has released a private labeled material to be used for iron particle / acid rain...
- Experiencing a delayed or no 2-3 upshift, primarily when the transmission is cold on vehicles with ford...
- Subject regarding door trim panel replacement - service tip
- Ford motor company now recommends sae 5W-30 viscosity grade for servicing any ford gasoline-powered...
- Information regarding reprogramming powertrain control modules (PCMS)
- A vibration / noise felt in steering wheel on right turns.
- Concerns regarding the front seat feeling loose on some vehicle
- Ford motor company has released a new electrical grease ( F8AZ - 19G208-AA ) to reduce the possibility of...
- Some vehicles may exhibit a hard start / long crank, cold start stall, cold rough idle concern
- For all vehicles with lighting control module concerns that require a module replacement, the technican...
- For all vehicles with drivers door module concerns that require a module replacement, the technician must...
- For all vehicles with drivers seat module concerns that require a module replacement, the technician must...
- For all vehicles with remote keyless entry concerns that require a module and / or transmitter (keyfob)...
- All vehicles with antilock brake module concerns that require a module replacement, the technician must...
- Mass air flow (maf)- sensor contamination- service tip
- Information regarding replacement and / or repairs on any lock component
- Experiencing a " buzzing " or " rattling " noise from the exhaust system
- Experiencing a torque converter clutch shudder or vibration
- Information on a new transmission fluid usage chart
- Information on tire company telephone numbers for customer assistance
- A new silicone gasket and sealant
- Information on a buzzing or rattle noise from the exhaust system
- A squealing and / or moaning noise may be heard from the rear brakes during light to medium brake applications
- The anti-lock brake system ( ABS ) may activate under false ABS conditions
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Some vehicles may cycle when brakes are applied on rough roads or on an incline while making a sharp turn
- Service tip information regarding elimination of sanding rotors and drums
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- Availability of hub-mount brake rotor machining equipment
- Some vehicles may stall when decelerating or when turning with no diagnostic trouble codes ( dtcs) stored...
- Subject regarding revised remote keyless entry (RKE) system
- Vehicles may experience torque converter clutch shudder or vibration
- Information concerning vibration-shudder under light to moderate acceleration above 56 km/h (35MPH) in 3RD...
- Experiencing squealing and / or moaning noise from the rear brakes during light to medium brake applications
- Subject regarding the availability of hub-mount brake rotor machining equipment
- Some vehicles may stall during deceleration and / or turning with no diagnostic trouble codes (DTCS) store...
- Some vehicles may experience a lean right condition
- Diagnostic instructions for a/c mode failure
- Additional instructions when diagnosing a/c mode failure
- Fuel economy- customer expectations versus vehicle usage
- Interior- leather seat cleaning procedure- service tip
- Fluid- transmission fluid usage charts
- Woodgrain trim part numbers for door trim panels and power seat controls are incorrect in parts catalog
- Air conditioning- R-134A tracer dye installed in a/c system and three o-ring spring lock couplers- service tip
- Rear brake squeal/groan
- Explanation of calibration codes
- Inadvertent ABS activation on smooth dry pavement
- Effective immediately the 4.6L 2V engine assembly for the vehicle is available as a ford quality renewal...
- Center locking wheel covers, a clicking noise heard at low speeds check the torque on the locking bolt
- Rear brake squeak/groan
- Inadvertent ABS activation on smooth dry pavement
- 4.6L 2V engine assembly for vehicles is available as a ford quality renewal assembly
- Wind noise from the front door area on affected vehicles
- Wind noise from the front door area at varying speeds and conditions on affected vehicles
- A white stress mark in the door scuff plate
- White stress mark in the door scuff plate, replace with new level part
- Whine/noise from rear axle between 50-65 mph
- Transaxle - torque converter replacement guidelines and torque converter/transaxle cooling system cleaning...
- Powertrain control module -reprogram powertrain control module (PCM) - service procedures - service tip
- Wiring - electrical diode identification and service replacements
- Torque converter - leak test procedure - service tip
- 12V power point, on right hand side of instrument panel, restricting hot air from the floor duct - new...
- Check engine light, code P030X, with no driveability complaint
- Wire wheel cover center ornament separates from the backing plate
- Light to moderate axle noise (axle whine) at 50 to 65 mph (80 to 105 kph) during accels, decels or cruise
- Windshield and interior glass - fog/film
- Brakes - elimination of sanding rotors and drums - service tip
- Long crank - sticking idle air control (IAC) valve - vehicles built from 11/1/94 through 3/30/96 -stall -...
- Mass air flow sensor - replacement as an assembly - service tip
- Vehicles equipped w/ an aode or 4R70W trans has a concern of shudder from the transmission torque...
- Groan noise from the rear brakes, usually noticed on light brake use
- For concerns of stalling, reflash PCM w/ 1996 calibration (R11 level)
- Firestone P235 tires may exhibit a high frequency vibration at 65-75 mph
- Complaint of a buzz/vibration felt in the steering wheel while turning (usually more noticeable turning right)
- Information for when diagnosing concerns w/ factory installed cellular phones
- Temp
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because...
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Mercury Grand Marquis?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history