Driver side inner door latch broke when trying to open door normally. Could not get out of car. Door latch mechanism made of poor quality plastic. Not strong enough to prevent braking.
2007 Mercury Milan body complaints
Page 2 of 2: complaints 11 to 17 of 17, newest first, as owners wrote them.
Tl* the contact owns a 2007 mercury milan. The contact stated that the dashboard became warped and began to rise upward, near the front passenger's side air bag housing. The vehicle was inspected by an authorized dealer and they informed the contact that the entire dashboard would need to be replaced. The vehicle had not been repaired. The approximate failure mileage was 45,000. Updated 4/1/13
Tl* the contact owns a 2007 mercury milan. The contact stated that she attempted to close the driver front door but the door latch failed. The contact had to hold the door shut in order to drive to the dealer for inspection. The dealer stated that a piece within the latch system had failed and needed to be replaced. The defective part was unknown. The vehicle was not repaired .the manufacturer was notified and a complaint was filed. The failure mileage was 37,000. The VIN was not available.
Front passenger side door latch malfunction. Door would not close. Had to duct tape door to get to destination. One passenger who was seat belted, but still a great safety hazard.
While driving and going around a turn, exiting a parking lot the passenger side door flew open. After that the door would not latch shut. At this time the door must be held shut while driving.
The passenger side front door flew open while driving. The door was in locked position and opened while going around a curve in the road. Passenger was wearing seatbelt so no injury occurred. Attempts were made to close door, however it opened under slightest of pressure, even when locked. Door was tied closed with rope and taken to dealership for repair. The latch assembly on the door was found to be broken and replaced.
2007 mercury milan purchase new july 2007. Car kept in garage most of the time. October 2007 car was parked outside in rain. Owner noticed that the passenger side of the floor (front and back) carpets were saturated. No windows or doors were accidentally left ajar. Owner kept checking car after car washes and passenger floor was continually wet after washing. Car went back to dealership and it was discovered that there was a weld burn through under cowl. The burn through was in a valley allowing water hitting the outside of the car to travel inside the car behind the glove compartment and into the car. Dealer stuck silicone on the site and said "here you go". Car had less than 4000 miles on it at that time. Owner was not satisfied. Carpets were finally replaced and there was mold growing underneath the carpet on the passenger side and there is visual rusting in the seat track and the driver's seat bracket also had rust forming. How many other vehicles made that same day in kansas city missouri (february 20, 2007) also have a weld burn through and no one knows it yet?
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Mercury Milan?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history