Tl* the contact owns a 1996 mercury sable. While driving at various speeds, a squeaking noise was heard under the vehicle, especially when slowing down, making turns, and reversing. The vehicle was taken to an independent mechanic where it was diagnosed that the cradle and subframe bushing were corroded and needed to be replaced. The vehicle was not repaired. In addition, while driving at certain speeds and making right or left turns, the steering wheel seized. The vehicle was not repaired. The manufacturer was not notified of the failures. The approximate failure mileage was 80,000.
1996 Mercury Sable: grinding or squealing brakes
5 of the 302 complaints about the 1996 Mercury Sable describe grinding or squealing brakes.
- owner complaints
- 5
- of this car's complaints
- 2%
- recalls
- 1
Is there a fix? There is 1 recall and 12 service bulletins for this area of the car. See below
Grinding or squealing brakes by model year
What owners say
When driving and upon making left or right hand turns consumer heard a grinding noise coming from front end. Contacted dealer, dealer noted that right hand tie rod failed at 25 thousand miles. Also, left hand side tie rod failed at 44 thousand miles due to poor or no lubication. Tie rods have been replaced. Please provide any further details.
Power steering failure resulting in grinding noise.
Problem with power steering, causing grinding sound.
When steering wheel is turned to the right grinding noise occurs.
Service bulletins that may apply
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Some vehicles may cycle when brakes are applied on rough roads or on an incline while making a sharp turn
- Service tip information regarding elimination of sanding rotors and drums
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- Availability of hub-mount brake rotor machining equipment
- Subject regarding the availability of hub-mount brake rotor machining equipment
- Residual brake pressure on the rear brakes of a 1996-1997 taurus or sable, make sure to support the rear...
Related recalls
Service brakes, hydraulic: brake fluid low warning: lamp
- What is wrong
- The brake system fluid level indicator lamp switch can malfunction. This does not comply with fmvss no. 105, "hydraulic brake systems."
- Risk
- Consequence of non-compliance: if the switch malfuntions, the brake system warning lamp will either remain illuminated continuously or fail to light as intended when the fluid level falls to a certain level. In either case, the vehicle operator would not be warned of a low brake fluid level condition.
- Remedy
- Dealers will replace the brake system fluid level indicator lamp switches.
Recall number 96V016000 · Recall details
Questions about the 1996 Mercury Sable grinding brakes
Is grinding or squealing brakes a common problem on the 1996 Mercury Sable?
5 of 302 owner complaints about the 1996 Mercury Sable (2%) mention grinding or squealing brakes. The model year with the most reports is 2002.
Is there a recall or service bulletin for this on the 1996 Mercury Sable?
There is 1 recall and 12 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1996 Mercury Sable
Jerking 14Stalling 11Transmission failure 10Headlights 8Overheating 8Sudden acceleration 8Engine failure 7Slipping 7ABS 6Check engine light 6Fire or smoke 6Fuel pump 6Power steering loss 6Door locks 5Seat belt 5Steering noise 5Won't shift 5Wipers 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Mercury Sable?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history