1) heater: almost caused elec. Fire, stopped working, now needs motor replaced; 2) ABS failed on snowy roads causing single-vehicle accident to front left of vehicle; 3) recall on fuel vent hose, will replace; 4) front rt. Lap belt will not pull out (stuck) needs repair/replaced; 5) oil filter's very very low location on undercarriage front, caused damage to filter, all oil spilled out while operating vehicle pulling out of driveway, ran over snow left by road commission plow, caused damage to rod bearings, and engine, vehicle currently out of commission awaiting repairs, $500 collission deductible.
1995 Mercury Villager: ABS light or ABS activating
14 of the 367 complaints about the 1995 Mercury Villager describe ABS light or ABS activating.
- owner complaints
- 14
- of this car's complaints
- 4%
- recalls
- 0
Is there a fix? 24 service bulletins cover this area of the car. See below
ABS light or ABS activating by model year
- 20012
- 20001
- 19971
- 19963
- 199514
- 19943
- 199310
What owners say
Abs hydraulic actuator failed. Yh
The ABS braking system malfunctioned, causing the vehicle to lock up, resulting in an accident. Dealer replaced the ABS sensor. *ak
The ABS brake unit leaks fluid, cause unknown. Dealer is replacing ABS unit. Please provide details.
Strong smell of gasoline in passenger compartment while refueling. Also ABS brakes lock up/fail in panic stop.
Abs brake failure, applied the brakes on wet surface, pedal went the floor, impact 12:00 position speed 8mph, hitting a concrete post.
Owner has ABS brakes, she states that there has been excessive work done on brakes with no satisfaction, she also notes that dealer put in new material in brakes.
When applying the ABS brakes, the calipers seized, causing the vehicle brakes to lock up.
Consumer states that she has replaced braking system on this vehicle (5) times within the last year. ( 2 ) sets on back and (3 ) on the front. The system has ABS.
When driving downhill the brakes locked up, this happened on normal road conditions. The whole brake system has been replaced twice in (20) months. Vehicle has ABS.
Abs; when applying the brakes it has a metal to metal grind which you can fill in the brake pedal and steering wheel. Please describe details.
Abs system failure, partial loss of braking ability, pedal went to the floor without stopping vehicle. Tt
Service bulletins that may apply
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Rear brakes are binding or overheating after having been serviced
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Service tip information regarding elimination of sanding rotors and drums
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- The rear brakes may bind or overheat after having been recently serviced
- Experiencing a squealing or grinding noise from either the front or rear brakes when the customer lightly...
- Availability of hub-mount brake rotor machining equipment
Related recalls
No recalls on record for this model year.
Questions about the 1995 Mercury Villager abs
Is ABS light or ABS activating a common problem on the 1995 Mercury Villager?
14 of 367 owner complaints about the 1995 Mercury Villager (4%) mention ABS light or ABS activating. The model year with the most reports is 1995.
Is there a recall or service bulletin for this on the 1995 Mercury Villager?
There are 0 recalls and 24 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1995 Mercury Villager
Fuel smell 51Grinding brakes 14Seat belt 11No deployment 9Wipers 9Door locks 8Fuel leak 8Stalling 8Transmission failure 8Check engine light 7Loss of power 7Brake failure 6Engine failure 6Fuel pump 6Fire or smoke 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Mercury Villager?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history