1999 Navistar 9300 recalls
There are 3 safety recalls on record for the 1999 Navistar 9300, covering 14,064 vehicles in total across all the models in each campaign. Newest first.
All recalls
Visibility: windshield wiper/washer: linkages
- What is wrong
- Vehicle description: heavy duty trucks equipped with dana/sprague windshield wiper assemblies. The knurled pivot shaft (which operates the windshield wiper arm) is welded to a lever, which connects to linkage from the wiper motor. The weld at the pivot shaft to lever can fail.
- Risk
- Should a failure occur during inclement weather on the driver's side while the vehicle is in motion, the operator's vision would be partially obscured.
- Remedy
- Dealers will inspect the wiper system, conducting a "stall" test to validate the integrity of the weld. All wiper assemblies failing this test will be replaced.
Recall number 99V102000 · Recall details
Suspension: front: wheel bearing
- What is wrong
- Vehicle description: class 8 heavy duty truck chassis equipped with 16,000 lb., 18,000 lb., or 20,000 lb. Heavy duty steering axles. The inner wheel bearing cone for the steering axle wheel hub assembly does not properly fit onto the navistar steering axle spindle assembly. Improper fit of the bearing to the spindle increases the stress levels to the steering axle spindle which could cause spindle failure.
- Risk
- If the spindle fails, a loss of driver control could occur, increasing the risk of a vehicle crash.
- Remedy
- Dealers will remove the left and right hub/drum assemblies from the steering axles and replace the inner wheel bearing cones and cups.
Recall number 99V014002 · Recall details
Power train: driveline
- What is wrong
- Vehicle description: heavy duty trucks equipped with spicer spl170 55mm center bering package. The end yoke retaining nut can loosen.
- Risk
- If this condition occurs, the drive line can vibrate and separate from the vehicle, causing vehicular damage, or personal injury, or both.
- Remedy
- Dealers will remove the 55mm center bearing package and coupler shaft, and replace it with a new coupler shaft and a 60mm center bearing package. An interim remedy can be implemented by placing a spot weld on the coupling shaft threads until parts are available.
Recall number 98V290000 · Recall details
Questions about the 1999 Navistar 9300 recalls
How do I check if my 1999 Navistar 9300 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1999 Navistar 9300 have?
3, covering visibility, suspension and power train.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1999 Navistar 9300?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history