2007 New Flyer D40LFR problems

What is wrong

New Flyer Industries Ltd (New Flyer) is recalling certain 2006 L40LFand DE60LF transit buses, 2006-2007 C35LF, C40LFR, D35LF, D40LFR, D60LFR, DE40LF and DE40LFR transit buses, and 2005-2007 C40LF, D40LF, D60LF, DE60LFA, GE40LF, 2007 D35LFR, and DE60LFR transit buses. These vehicles are equipped with MAN V8-65L axle beams that may have cracks on the upper and/or lower surface, which, over time can cause the axle beam to fail.

Risk

Failure of the front axle beam can cause a loss of vehicle control, increasing the risk of a crash.

Remedy

New Flyer will notify owners, and dealers will inspect the axle beams and determine a repair, as necessary, free of charge. The recall began on March 10, 2017. Owners may contact New Flyer customer service at 1‑204‑224‑6706. New Flyer's number for this recall is R17-002.

Recall number 17V130000 · Recall details

What is wrong

New Flyer is recalling certain model year 2004-2011 transit buses, models: C35LF, C40LFR, D35LFR, D40LF, D40LFR, D60LF, D60LFA, D60LFR, DE35LFA, DE40LF, DE40LFA, DE40LFR, DE60LF, DE60LFA, DE60LFR, and XDE40. The drive shaft access panel may have insufficient strength or be not properly secured to the floor. If the drive shaft fails, debris from the driveshaft failure may enter the passenger compartment through the panel.

Risk

If debris resulting from drive shaft failure enters the passenger compartment, it may result in injury to the bus occupants.

Remedy

New Flyer notification to owners on 01/03/2013. Dealers will install a steel plate under the access panel on affected buses, free of charge. Owners may contact New Flyer at 1‑204‑224‑6706 for more information.

Recall number 12V591000 · Recall details

What is wrong

New flyer is recalling certain model year 2007-2011 low floor transit buses produced from may 24, 2007, through march 1, 2011 and equipped with teeter lever assemblies. There is insufficient engagement between the teeter lever base and the cam plate.

Risk

Failure of the teeter lever assembly will cause the rear side exit door to operate improperly. A passenger leaning on or forced against the door could fall through the door and sustain injuries.

Remedy

New flyer is working with the manufacturer of the teeter lever assemblies, vapor bus, to repair the affected buses free of charge. Please see vapor bus defect report 11e-010. The safety recall began on april 29, 2011. Owners may contact vapor bus at 1‑847‑777‑6450 or new flyer customer services at 1‑204‑934‑4874.

Recall number 11V237000 · Recall details

What is wrong

New flyer is recalling certain model year 2004-2009 transit buses. These models have an inspection panel located above the drive shaft in the passenger compartment flooring for easy inspection and removal of the drive shaft. This panel may not be of sufficient strength to prevent foreign matter from entering the passenger compartment in the event of a drive shaft failure.

Risk

Failure of the drive shaft access panel to maintain passenger compartment integrity could result in injury or death.

Remedy

Dealers will incorporate an energy absorbing honeycomb material to the underside of the access panel. This service will be performed free of charge. The safety recall began on march 10, 2010. Owners may contact new flyer at 204‑934‑4874.

Recall number 10V089000 · Recall details

What is wrong

New flyer is recalling certain model year 2002 through 2009 transit buses manufactured between may 2002 and september 2009 equipped with luminator horizon LED side destination signs. The connector board can corrode due to an accumulation of moisture under the connector.

Risk

A short could occur, possibly causing smoke and fire.

Remedy

New flyer will notify owners and repair the buses free of charge. The safety recall began on october2, 2009. Owners may contact new flyer customer services at 1‑204‑934‑4876.

Recall number 09V367000 · Recall details

What is wrong

Certain buses have stainless steel hydraulic lines with 90º flange fittings which are subject to failure due to errors in both the design and manufacture of these lines.

Risk

Failure of these lines, located in the engine compartment, could result in a vehicle fire.

Remedy

New flyer will remove these lines and replace them with a previously proven design of flexible lines. The recall began on january 15, 2008. Owners may contact new flyer at 1‑204‑982‑8400.

Recall number 08V010000 · Recall details

Investigation has not identified a defect.there have been no reported complaints relating to this issue since 2006. See closing report for further details.

EA09010

Odi is closing this preliminary evaluation and opening an engineering analysis (ea09-010) to further identify and evaluate the vehicle environment and brake system factors that may be causing or contributing to extended stopping distance performance in certain vehicles.

PE09012