2015 New Flyer XD60 technical service bulletins
34 technical service bulletins and manufacturer communications cover the 2015 New Flyer XD60.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Instructions to replace current k-member with an upgraded casting design.
- Thermo-King has issued a Service Bulletin (SB866-1) related to the clutch bearing maintenance on their...
- Instructions to Service to remove bypassed engine calibration from ECM and replace DEF sensor as required.
- Instructions to Service to incorporate a PLC Update to prevent interlock activation when CAN speed...
- This Instruction to Service (ITS) decribes the inspection procedure required to inspect the upper bulkhead...
- Technical Instruction describing how to mechanically fasten the Engergy Guide System (EGS) support...
- This is a technical service instruction describing how to weld/repair cracks as required at Diesel Exhaust...
- This Service Manual Bulletin Identifies a New Requirement for Bolt Replacement in the Artic Joint Support...
- This Service Manual Bulletin Provides Updated Preventive Maintenace Interval for the Crankcase Breather...
- This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg...
- This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation...
- This Maintenance Instruction Describes How to Install New Articulation Joint Panel Cosmetic Caps.
- This Service Manual Bulletin provides new inspection and replacement requirements for the coolant hoses...
- This Service Manual Bulletin provides new information on how to check for proper chain tension, as...
- This Maintenance Instruction Describes How to Add Re-enforcement Brackets to the Existing Air Accessory...
- This Parts Manual bulletin provides information on the part numbers of the engine lift brackets
- This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
- This Maintenance Instruction describes an inspection of ZF center axle hub/rotor bolt torque.
- This Service Manual Bulletin provides a correction for the information regarding the replacement of the...
- Service Manula Bulletin provides revised OEM information on the exhaust, after treatment System and DEF tank.
- Technical instruction to modify articulation joint bellows assembly clearance.
- Technical instruction to add pressure protection valve at the spring/parking brake emergency release tank.
- Technical instruction to rewire the voltage regulator power supply from the battery side to the load side...
- Technical instruction to correct installation of steering gearbox mounting plate.
- Technical instruction to remove and rework articulation joint bellows assembly on specifically equipped...
- Technical instruction to inspect front mask support bracket bond and repair if required on specifically...
- Technical instruction to reconfigure voltage sense connection wiring on specifically equipped vehicles
- Sec. 579.5
- Technical instruction to inspect street side driver's exterior mirror snap bushing.
- Technical instruction to remove and replace defroster heater blower resistor.
- Technical Instruction to Rotate Current Sensor.
- New flyer: information regarding the wheel flange and lower radius road to axle installation whereby...
- New flyer: 2010 epa or newer engines and mini-hybrid cooling system buses with isolated pipe clamps may...
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 New Flyer XD60?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history