2015 New Flyer XN40 technical service bulletins
34 technical service bulletins and manufacturer communications cover the 2015 New Flyer XN40.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Instructions for replacing a CNG decal to comply with New York State regulations
- Technical Instruction describing how to inspect and install new headlamp harness if required.
- Technical Instruction describing how to remove and replace the front suspension air springs
- Service Manual Bulletin
- Technical Service Information Bulletin describing changes to the Cummins ISLG, L9N, ISB6.7G and B6.7N...
- Technical Instruction describing how to remove and replace the drivers barrier upper door frame assembly.
- This Technical Service Information Bulletin Decsribes How to Inspect and Reroute as Required the Cummins...
- This Maintenance Instruction Describes How to Remove and Replace Exhaust Compartment Harness Heat Shield.
- This Maintenance Instruction Decribes How to Replace the Surge Tank Low Coolant Level Sensor.
- This Maintenance Instruction Decribes How to Update Battery Equalizer Programming.
- This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg...
- This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation...
- This Service Manual Bulletin provides new inspection and replacement requirements for the coolant hoses...
- This Service Manual Bulletin provides new information on how to check for proper chain tension, as...
- This Parts Manual bulletin provides information on the part numbers of the engine lift brackets
- This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
- This Service Manual Bulletin provides a procedure for venting the tanks when the solenoid valve is stuck...
- Technical Instruction to inspect and replace solenoid valves if found defective.
- Technical instruction for amerex display module and firmware validation
- Technical instruction to rewire the voltage regulator power supply from the battery side to the load side...
- Technical instruction to correct installation of steering gearbox mounting plate.
- Technical instruction to rewire voltage regulator power.
- Technical instruction to rework heat exchanger cabin loop line and routing.
- Technical instruction - rework gas detection system wiring routing - specifically equipped vehilces
- Technical instruction - inspect rear bumper and re-torque mounting hardware if required - specifically...
- Technical instruction to incorporate an additional pressure protection valve (PPV) to the emergency brake...
- Technical instruction to inspect front mask support bracket bond and repair if required on specifically...
- Technical instruction to reconfigure voltage sense connection wiring on specifically equipped vehicles
- Sec. 579.5
- Technical instruction to replace surge tank low coolant level sensor.
- Technical instruction to inspect street side driver's exterior mirror snap bushing.
- Technical Instruction to Remove and Reinstall Driver's Barrier with Loctite.
- Technical Instruction to Add PPV valve to Parking Brake Optional Emergency Release System for New York State.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 New Flyer XN40?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history