2008 Nissan 350Z transmission problems

Filed May 18, 2018 · Transmission · 70,000 miles · KY

I was driving my 08 350z (currently has 70k miles) on the highway approx 60 MPH when I attempted to downshift for my exit. The clutch pedal went down and stuck when I shifted out of 6th and the car wouldn't go into any gear. I missed the exit and pulled to the side of the highway and stopped. Turns out the slave cylinder that had been replaced 20k miles ago under recall had gone bad again! Even more impressive is that in 68k miles, I've had to have the slave replaced 2x, clutch replaced 3x, flywheel resurfaced 2x, flywheel replaced 1x, clutch master cylinder replaced 1x, multiple trans services, multiple times bleeding the clutch. All work done at dealer using oem parts. This is a known 350z defect and nissan should take responsibility for replacing the clutch system w/ an improved design before more people are injured or killed!

Filed Aug 21, 2016 · Transmission · 191,250 miles · NY

Csc failure 6 times. Failure occured in multiple places, on the highway, side streets, country road.

Filed Jul 25, 2016 · Transmission · 70,000 miles · TX

I purchased my 08 350z grand touring october 5, 2015 from hoy fox toyota in el paso tx. 3 days later it left me stranded. The clutch stayed to the floor and it wouldn't gear. They sold it to me saying it had a new clutch so I decided after test driving it to take it. I had to wait 30 days for my power train warranty to kick in so I can make a claim. Initially it was the master cylinder which was covered. However, that was not the case. Later they said I needed a whole new clutch kit for around 2800. Of course I don't have that amount of money. I purchased and exedy aftermarket clutch , flywheel and pressure plate as they told me to do. Took it home november 15 and it worked fine for several months. It then began to leak clutch fluid and clutch felt soft. I went back and they kept telling me to go to nissan. I paid for a diagnosis at viva nissan in el paso tx and the concentric slave cylinder was the issue. I had to go back and forth and try to get the help to fix this issue. I bought a slave cylinder online because I didn't know I had that part under warranty. I tried talking to them at dealership but no help until I made a bad review. They took the car in and they said no worries we will fix it. They replaced the slave cylinder and in 3 days once again it failed. Plastic nissan parts are no good. They get damaged easily and even new cars with less than 5000 miles need it all replaced. The only solution we all might have is a heavy duty slave cylinder from zspeedsports and its expensive. I've been reading so many cases and we all have the same issues. It's ridiculous what we have to go through and for nissan not to solve this issue immediately . I have no car and its at dealership once again for the third time. I have a case number 23013379. These vehicles need to be replaced and fixed. Too many cases and no help from dealership.

Filed Apr 19, 2013 · Engine, Transmission · 57,000 miles · TX

Clutch stuck to floor from slave cylinder going out.

Filed Apr 16, 2013 · Transmission · 36,000 miles · TN

While driving at speed pressed clutch pedal and it stayed on the floor accompanied by a very characteristic and strong burning smell, unable to change gears, car rendered inoperable. Safety hazard, stuck in gear at highway speeds.

Filed Feb 17, 2013 · Transmission · 27,863 miles · NV

Driving, push clutch in it stay on the floor, cannot shift, dangerous on the freeway, safety hazzard, there are numerous same problem with the 2008 350z nissan need to do a recall before someone get kill of this problem.

Filed Sep 10, 2012 · Transmission · 50,000 miles · CA

I was driving my 2008 nissan 350z on the freeway at about 65 MPH and when I stepped on the clutch to switch gears it was stuck on the floor and didn't come back up. The clutch was stuck in gear and I had to pull over and get it towed.

Filed Jun 28, 2012 · Transmission · 60,000 miles · NC

Tl* the contact owns a 2008 nissan 350z. While driving approximately 30 MPH, the clutch failed to respond when engaged. The brake pedal was applied with force and the vehicle came to a stop. The vehicle was towed to the residence. The contact inspected the vehicle and stated the slave cylinder would need to be replaced. The vehicle had not been repaired. The manufacturer was notified of the problem. The approximate failure mileage was 60,000.

Filed Jun 28, 2012 · Transmission · NC

The clutch slave cylinder has gone out on the vehicle 3 times since I have owned it. It has cost me over $500 each repair. Others have complained about this. The second time it went out was in a parking lot when I was going slow and the third time happened this morning when I left for work. This is ridiculous and all nissan wants to do is charge off the wall prices. I'm a master mechanic and the design of this whole system is ridiculous.

Filed May 27, 2010 · Transmission · 14,500 miles · TX

The vehicle is a 2008 350z roadster with 15,000 miles, and the transmission was replaced at around 7500 miles (under warranty) due to bearings that were broken. When the car is brought to mid-high revs in 1st/2nd gear, the clutch will disengage and fall to the floor. This is accompanied by a very strong burning smell (characteristic clutch burning smell) and is extremely damaging to the clutch and transmission. The clutch pedal has to be pulled up manually and is noticeably softer after this happens. This problem has happened 2-3 times in the past year. This problem was noticed in 2007 350z's and has continued into the 2008 350z's. The 350z mentioned in this report was manufactured in 10/07.