2008 Nissan Rogue technical service bulletins
101 technical service bulletins and manufacturer communications cover the 2008 Nissan Rogue.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Wiring harness repair information
- Certification label and VIN plate replacement service information
- CAN communication codes – diagnostic tips and guidelines
- CAN communication – network diagnostic flow chart
- Vehicle key not detected / authenticated, engine will not start
- Windshield cracking
- Removing foreign material from the window glass
- Window glass warranty information
- Diagnosis of vehicle pull (DRIFT) and/or steering wheel off-center
- 12 volt battery testing for in-service vehicles service information
- Silicone-based lubricant or grease CAN damage electrical components service information
- Intelligent key replacement or swapping between vehicles
- ABS/vdc CAN diagnosis information
- Wheel bearing collision damage
- Abnormal noise, vibration and/or binding feeling from rear differential
- Nissan AWD models; abnormal noise, vibration and/or judder from rear differential
- CAN communication – network diagnostic flow chart
- DTC P0456 caused by evap leak at vent control valve o-ring
- Strut and shock absorber replacement guidelines
- Voluntary service campaign 2008
- Expiration Notification – Wheel Valve Stem Nut Campaign Summary In 2009, Nissan launched a Voluntary...
- VOLUNTARY SERVICE CAMPAIGN ROGUE, MURANO, cube®; WHEEL VALVE STEM NUT Service Campaign ID # P9241 is no...
- This SKU is a Suspension Ball Joint
- Nissan; vibration and/or noise when making low speed turns
- Nissan; DTC P0456 caused by evap leak at vent control valve o-ring
- Nissan; fuel tank is extremely difficult to fill
- OBD II evap
- Nissan; vibration and/or noise when making low speed turns
- Nissan; vibration and/or noise when making low speed turns
- Nissan; fuel tank is extremely difficult to fill
- Rust around rear license lamp finisher if you confirm
- Nissan; DTC P0456 caused by evap leak at vent control valve o-ring
- Nissan; fuel tank is slow or difficult to fill
- Altima, sentra, and rogue; CVT fail-safe condition service information
- Reduced performance due to CVT fluid temperature protection logic this bulletin applies only to specified...
- IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location
- Service information
- Service information
- Summary to be provided on a future date.
- Service information
- If you confirm
- Service information
- If you confirm
- Service information
- Service information
- Service information
- Service information
- Nissan: on certain vehicles, a voluntary emission recall campaign is being conducted and the engine...
- Nissan: some vehicles may experience reduced performance caused by the CVT fluid temperature protection logic
- Service information
- Nissan: the main harness to body harness connectors is experiencing electrical corrosion issues
- If you confirm
- IF YOU CONFIRM A rattle coming from the exhaust center tube heat shield, and a heat shield spot weld is...
- Nissan: SRS precautions during service;improper maintenance, including incorrect removal and installation...
- Service information
- Nissan: exterior lamp fogging
- Nissan: a loose fuel fill cap is the cause of evap leak dtcs (P0442, P0455, P0456) stored on some vehicles
- Service information
- Aftermarket chroming of nissan alloy wheels not approved or authorized and strongly discouraged
- Nissan Original Equipment or Genuine Accessory Alloy wheels, along with their finish coating (clear,...
- Service information
- Service information
- If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear)
- As part of an enhanced emissions test for Inspection & Maintenance (I/M), some States may require the...
- Nissan: lock/unlock request button on outside handle does not respond
- Service information
- Service information
- If you confirm
- SERVICE INFORMATION A new updated front brake rotor service part is available for the Applied Vehicles in
- Service information
- Nissan: bulletin regarding diagnosis of ABS/vdc wheel speed sensor
- Nissan: if continuously variable transmission (CVT) fluid temperature rises above a certain threshold, it...
- Nissan: if for any reason the engine harness is replaced, during the replacement of the harness, install a...
- Nissan: ECM replacement procedures with consult III plus
- Nissan: door lock/unlock inoperative with intelligent key
- Nissan: oil is leaking from the upper end of the engine oil cooler
- Nissan: fuel gauge does not read full, or slow to respond
- Nissan service campaign: recall to apply a seal and special grease to help prevent the front outside door...
- Nissan: tire pressure monitoring system (TPMS) warning light on/flashing
- Nissan: vent control valve replacement. when replacing the evap canister vent control valve for reason:...
- Nissan: 2008 rogue
- Trailer light wiring
- Nissan: xenon head lamp service
- Nissan: grinding/knocking noise from rear when turning. there is a grinding or knocking noise or vibration...
- Nissan: DTC P0444 (evap canister purge volume control solenoid valve circuit open is stored).
- Nissan: MIL on w/DTC P0840, P0845, P0744, P1777
- Nissan service campaign: there is a subtle rattle noise that is coming from the transmission at low speeds
- Nissan service campaign: wheel valve stem nut
- Nissan: affected vehicles has CVT fluid and that is discolored and/or has unusual odor
- Nissan: the 12 volt battery is an important part of the vehicle electrical system and is required to stay...
- Nissan; special automatic transmission fluid requirement. 2004 to current nissan vehicles. nj
- DTC for variable valve timing control function. all 1996-2007 nissan vehicles with variable valve timing,...
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Nissan Rogue?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history