While driving and applying brakes, vehicle experiences extended stopping distance.
1994 Oldsmobile Bravada brakes complaints
Page 2 of 3: complaints 11 to 40 of 66, newest first, as owners wrote them.
There is a sevice bulletin about this & I would like to know what to do. No safety defect listed in summary.
Kelsey hayes ABS brakes failed, fixed and failed the following month feb/2000.
While driving at about 45 MPH consumer tried to avoid hitting a deer, slammed on brakes and vehicle did not slow down. A friend scanned the vehicle and found that the hydraulic electrical control unit needed working on, and speed sensors needed to be looked at.
When applying the ABS brakes pedal becomes very hard and resists application, causing extended stopping distance. Cause unknown. Dealer cannot identify the problem. Please give any further details.
When appyling ABS brakes on wet pavement pedal goes to the floor, causing extended stopping distance. Please give any further details.
Vehicle is experiencing stopping problems with the antilock brake system.
When the brakes were applied on wet pavements pedal went to the floor, resulting in extended stopping distance which caused a collision. Dealer has been notified.
Wiper swicth smoked - replaced - now wipers come on when using turn signal/ ABS brakes lock at low speed while turning on bumpy road/ front disc brakes replaced 3 times in 78,000 miles
Ongoing / intermittent problem with ABS brake. When applied pedal would go down to the floor and slowly rise back up. After returning, consumer would have to pump brake pedal to get vehicle to stop. This poses a danger of a vehicle collision.
No summary listed for above vehicle.
Abs brakes engaged entering intersection and failed to stop car. Luckily no approaching traffic. They have engaged in similar way 3 times in total.
When putting vehicle into reverse and appling the brakes, the brakes grind.
Braking system malfunctioned, causing extended stopping distance. Also, windshield wipers come on when using the turn signal, or if the vehicle goes over any bumps. Please provide further information.
Brake speed sensor would lock and vehicle would accelerate. Would take away the braking ability of the vehicle when it was needed.
When applying the ABS brakes in normal braking conditions pedal resists and becomes hard, resulting in extended stopping distance, cause unknown. Please give any further details.
While trying to stop vehicle brake pedal doesn't lose pressure. But when applying brakes, vehicle just keeps rolling and has to coast to a stop. Dealer has been contacted, and has been unable to locate the problem. *ak
Without warning the brakes failed, the pedal went all the way down and I barely avoided a rear-ender
Front brake disk failed.
Intemittently when the brakes are applied the pedal becomes hard, causing the vehicle surge. The dealer is inspecting the vehicle.
Since vehicle was purchased had been in & out dealer for ABS brakes. They fail to stop vehicle properly. Make a lot of noise when applied. Brake pedal goes to the floor. Also premature wear of left front brake pads.
Anti lock brakes engage preventing regular braking.
Abs brakes failed.
Abs brakes failed.
When the brakes are applied the pedal goes to the floor, causing a loud pop, resulting in extended stopping distance. The dealer has replaced some parts of the braking system.
Vehicle is experiencing numerous brake problems (pads, cylinders, lines, rotors, spindles and the overall system).
Anti lock brakes have to be replaced continuously and do not stop vehicle.
Brake pedal is hard with extended stopping distance.
Anti-lock brakes fail to stop vehicle efficiently, causing a collision.
Anti lock brakes fail temporarily on occasions.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Oldsmobile Bravada?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history