Dt*: the contact stated while traveling 30 MPH in dry road conditions, the ABS light illuminated when the brake pedal was depressed. Also, the brake pedal went to the floorboard, and stopping distance was increased. The vehicle was taken to an independent repair shop who performed a diagnostic, but could not determine the problem. The brake pads were replaced, but the problem recurred 5 months later while traveling 30 MPH. The dealership was contacted, but never returned a call. The contact expressed concern that the ABS system was defective, and could a pose serious risk if the problem recurred in heavy traffic.
Oldsmobile Cutlass abs comes on
60 of the 1,326 owner complaints about the Oldsmobile Cutlass describe aBS light or ABS activating, most of them for the 1995 model year.
- owner complaints
- 60
- worst model year
- 1995
- typical mileage
- 20,000
Is there a fix? There are 3 recalls for this area of the car. See below
By model year
Often reported together
Brake failure 11Grinding brakes 4Stalling 2Premature wear 2Loss of power 2Won't start 1Seat belt 1
What owners say
Abs light comes on very frequently when hitting a bump in the road or making a turn. Has done so since the car was purchased and has been in numerous times about problem, having several parts relating to ABS and brakes replaced.
The ABS check light remained on, which the owner's manual indicated that the brakes may not operate properly. Consumer contacted manufacturer.*ak the brake lights failed and a wire within the steering column broke.
Bridgestone tire tred separation causing $2000 in right front fender damage plus radio antenna damage, ABS senser damage, etc. Sent tire and copies of paper work to firestone, but they denied the clain. The tire was still in warentee. I am having the tire returned from firestone. No damage has been fixed yet. Thank goodness, the car is drivable.
Brake pads have been replaced more than once per year. Calipers have been replaced two or three times. Vehicle will not do an emergency stop. It takes a long distance to stop normally. The ABS does not work properly. Mechanics say this is common on this vehicle.
While driving ABS warning alarm chime came on, and the warning light illuminated on the dashboard. Also, brake pads and rotors were continuously replaced because of excessive wear. This was as a result of ABS module sensor failure.
The ABS light came on intermittently. This problem occurred before the warranty expired. The consumer was told that the problem could not be diagnosed unless the light was on. The consumer is concerned that the brake will not work when attempting to stop the vehicle. The vehicle was taken back to the dealer who informed the consumer that they would have to pay for the repairs because the vehicle was no longer under warranty. *ak *ts
Abs light comes on at random times, usually during a turn, but no adverse conditions occur. When diagnosed, it was stated that the speed sensor was bad. I have had both front speed sensors replaced about 3-4 times under warranty, and since the warranty has run out, I just deal with the light. I just brought it in for this problem about 6 weeks ago, and again the computer diagnostics said that it was a speed sensor. This problem has existed since I bought the car.
When the consumer applied the brakes, the ABS failed, which caused the vehicle to experience extended stopping distance. *jb also, consumer would like to add that the front seat recliner mechanims do not lock into position and can allow for seat occupants to be thrown forward into the steering column, dash, windshield during a crash. Mjj
I have had several electrical problems with this vehicle. The ABS sensor has been replaced, fuses are continuosly blowing, several electrical wires have been replaced in the shift column, the turn signal switch had to be replaced because it was corroded, the battery has been replaced 4 times. Also the low coolant light flashes intermitently even though the radiator and tank are full. He ABS light has been on for at least a year and the mechanic is unable to find the cause. Brakes are in working order and all sensors are good. Now I am having difficulty starting on hot days, the starter clicks but the engine will not start, after several tries it will then start( about 5 tries), and today I seem to be having problems with the transmission. While entering an intersection from a stop sign I lost power. The engine was running at a top of 2rpm's and could not get over 10 miles per hour. The mechanic still need to give a diagnosis on this latest problem but siad it may be a circuit problem since touching the underhood driver side circuit box caused the car to stall and restart.
Related recalls
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The rear wheel brake hose(s) can contact the rear suspension components causing the brake hose(s) to wear through.
- Risk
- This condition can cause loss of brake fluid and eventual loss of the vehicle braking system increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect for proper brake hose position and replace those hoses in an incorrect position with new hoses and correctly routed.
Recall number 95V061000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The brake lines can contact the transmission mounting bracket of the frame side rail. The lines can wear through resulting in loss of brake fluid, and eventual loss of half the vehicle braking system.
- Risk
- A leak in the hydraulic brake line will cause a loss of one half the vehicle braking system and extended braking distances which can result in an accident.
- Remedy
- Dealers will inspect for proper brake line clearance and reposition the brake lines. Brake lines found to have indentations will be replaced.
Recall number 94V211000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The brake hoses were manufactured incorrectly, and do not comply with fmvss 106, "brake hoses."
- Risk
- The improperly manufactured brake hoses can causereduced brake effectiveness and/or uneven braking, which could result in anaccident.
- Remedy
- Replace the right front brake hose assembly on ciera and century models, and both rear brake hoses on cavalier and sunbird models.
Recall number 93V121000 · Recall details
Questions about the Oldsmobile Cutlass abs
Why does the abs come on in the Oldsmobile Cutlass?
Owners who report it most often also describe brake failure, grinding or squealing brakes and engine stalls while driving.
Which Oldsmobile Cutlass years have aBS light or ABS activating problems?
The model years with the most reports are 1995 (12 complaints), 1994 (9 complaints) and 1992 (8 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Oldsmobile Cutlass?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history