The worst 2006 Oshkosh S-Series problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 2
Parking brake
- What is wrong
- On certain trucks equipped with bendix sr-7 spring brake modulating valves, the internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button.
- Risk
- This could delay or failure in applying the parking brakes which could result in a vehicle roll away, increasing the risk of a crash.
- Remedy
- Oshkosh is working with bendix to repair these vehicles (please see 07e-037). Bendix will install a check valve repair kit for the affected sr-7 spring brake modulating valve free of charge. The recall began on october 19, 2007. Owners may contact bendix at 440‑329‑9000 and oshkosh at 1‑920‑235‑9151.
Recall number 07V320000 · Recall details
Power train: driveline
- What is wrong
- On certain trucks equipped with arvinmeritor axle assemblies, the torque rod tower has a nonconforming location and weld. The weld can crack, leading to the tandem axle losing its anchor point, causing the driveline to bend to an angle outside its operating perimeters.
- Risk
- In turn, this can result in the driveline breaking or forcing the engine to stop. It is also possible for the tandem axle to drop to the ground and turn under the vehicle creating a condition that might include loss of vehicle control, which could result in a crash.
- Remedy
- Dealers will inspect the torque towers on the rear tandem and, if cracks are found, the torque tower will be rewelded according to instructions. Oshkosh has telephoned all owners in september 2006, advising them that until the torque tower is rewelded, owners should inspect for cracks at the base of the torque towers on the rear tandem on a weekly basis. The recall began on january 15, 2007. Owners may contact oshkosh at 1‑920‑233‑9427.
Recall number 06V390000 · Recall details
Technical service bulletins for the 2006 Oshkosh S-Series 8
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- This bulletin provides instruction for installing a hydraulic system charge pump filter.
- This bulletin provides information on updating hydraulic hose clamping below the cab to match current...
- This bulletin provides instruction for replacing the water pump impeller due to corrosion
- This bulletin provides information for vehicle owners that have a Dana series 172 or 175 rear axle without...
- This bulletin provides instruction for replacing the mixer pump PTO shaft, mixer pump input yoke, and...
- This bulletin provides instructions for bolting the water tank mounting feet to the water tank if the...
- This bulletin provides instruction for checking electrical connections at various critical locations
- This bulletin provides instruction on replacing the frame ground stud nut located at the rear of the...
Compare the 2006 Oshkosh S-Series
Other model years
Questions about the 2006 Oshkosh S-Series
Is the 2006 Oshkosh S-Series reliable?
Owners have filed 0 complaints about the 2006 Oshkosh S-Series.
What is the most common problem with the 2006 Oshkosh S-Series?
There are not enough complaints to tell.
How many recalls does the 2006 Oshkosh S-Series have?
2 recalls, covering parking brake and power train.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Oshkosh S-Series?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history