The worst 2001 Pierce Custom Chassis problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 2
Suspension: front: control arm
- What is wrong
- On certain fire trucks equipped with an independent front suspension, a pitman arm might fracture under severe load caused by three loading conditions. In all cases, the front axle must be turned full left or right while (1) simultaneously backing up and braking hard, (2) driving one wheel over or against a curb or (3) steering the front axle full left or right when the vehicle is stationary with the service brake applied. These are all low or no -speed events.
- Risk
- Such a break could lead to the suspension losing one of its anchor points, thereby potentially causing loss of vehicle control without prior warning which could result in a crash.
- Remedy
- Dealers will replace the original pitman arms with pitman arms made of higher strength material. The recall began on october 29, 2007. Owners may contact pierce at 920‑832‑3000.
Recall number 07V470000 · Recall details
Steering: linkages: tie rod assembly
- What is wrong
- On certain fire trucks with tandem steer axles. The trw tie-rod on the rear-most axle of a tandem axle is restrained from rotational movement by a pair of anti-rotation seals located at the ball socket joints. These anti-rotation seals will compress over time. If the anti-rotation seal allows too much motion, the seals can deteriorate, allowing contact between the ball socket and the ball shaft. This metal-to-metal contact will transmit forces into the tie-rod tube, causing fatigue failure initiating at the root of the female treads.
- Risk
- Failure of the tie-rod will allow one of the wheels to swing to the limit of its steering stop, potentially causing a loss of vehicle control, increasing the risk of a crash.
- Remedy
- Dealers will replace the tie rod. Notification to owners began november 7, 2003. Owners should contact pierce at 1‑888‑974‑3723.
Recall number 03V380000 · Recall details
Technical service bulletins for the 2001 Pierce Custom Chassis 40
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- All Roto Rays are warranted to the purchaser for twenty-four months from the date of service against...
- This bulletin covers the proper start-up and shut-down procedures, using the battery and ignition switches
- We are excited to share several updates to our Husky 3 foam system
- As a product improvement, Whelen has updated the design of the Pierce 600 Marker/Turn Light, while...
- Depending on custom chassis configuration, the oil check level plug and sight glass may prove difficult to...
- To improve the fitment and operational reliability of manual window cranks by installing a fabricated...
- IMMI, the creator and supplier for Rolltek and other Supplemental Restraint System (SRS) products, is...
- Due to the larger size of the PACCAR engine and smaller frame rail design, space constraints within the...
- This bulletin provides a procedure by which to validate Command Zone device software versions in Pierce...
- This bulletin provides a procedure by which to apply a software update to applicable Command Zone devices...
Compare the 2001 Pierce Custom Chassis
Other model years
Questions about the 2001 Pierce Custom Chassis
Is the 2001 Pierce Custom Chassis reliable?
Owners have filed 0 complaints about the 2001 Pierce Custom Chassis.
What is the most common problem with the 2001 Pierce Custom Chassis?
There are not enough complaints to tell.
How many recalls does the 2001 Pierce Custom Chassis have?
2 recalls, covering suspension and steering.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2001 Pierce Custom Chassis?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history