I purchased my 1999 Plymouth Prowler in August of 2022. I was told that it has a recall on the front suspension lower ball joints that was issued on 03/28/2003. I contacted a dealership for an appointment to get it fixed and they said they would order the ball joints. They also said it takes a special tool to replace them of which they did not have and the would not purchase on. I contacted another dealer and was to the same thing. I can’t get anyone to fix it. What can I do. I looked on line and the tool cost about $75.00.
1999 Plymouth Prowler: ball joint or control arm failure
8 of the 18 complaints about the 1999 Plymouth Prowler describe ball joint or control arm failure.
- owner complaints
- 8
- of this car's complaints
- 44%
- recalls
- 1
Is there a fix? There is 1 recall for this area of the car. See below
Ball joint or control arm failure by model year
What owners say
Tl* the contact owns a 1999 plymouth prowler. While the vehicle was being serviced for regular maintenance, the mechanic noticed that the front lower ball joints were fractured and needed to be replaced. The vehicle was repaired a few years back for the same failure under a manufacturer recall. The manufacturer was notified of the failure. The vehicle was not repaired. The approximate failure mileage was 72,000.
Tl*the contact owns a 1999 plymouth prowler. The vehicle was repaired under recall 03v034000 suspension, front control arm, lower arm in 2003. On december 31, 2009 while he was driving on the highway at approximately 65 MPH and entering an exit the lower control failed. He took the vehicle to the dealer who stated that he would be responsible for the repair cost. The vehicle is inoperable. The VIN was not available. The current and failure mileages were 30,000.
The dealership was unable to perform the lower control arm ball joint recall 03v-034000,the brake system lamp recall 99v-245000, the frame strength recall 99v-313000, and the gear shift position lighting recall 98v-104000 because the parts haven't been available. This has been going on for over 3 years.
The consumer was informed no parts were available regarding the recall for the lower control arm.
1st. Thing I noticed a couple of months ago was the steering of the car was getting harder and harder to control, and I was hearing cracking and popping noises comming from the front end but I nor anyone else who also heard the noises could tell just where they were comming from , and I own a car lift but evan after many many inspections I could never see anything wrong or out of place , I was told that my steering rack was making a lot of noise so I had and alinement done and was told that I did have ( something wrong ) but they did not no what it was either , so after discussing this with my dealer on 8-7-02 and making an appointment for a new steering rack to be installed on 8-19 -02 , but on 8-8-02 at 7:50 am and driving over a bridge on north 14th. Street the left lower ball joint came appart and let the left front wheel and tire assy. Fly off but still attatched from the upper ball joint and brake line but bouncing vilently against the ground and body untill I could quit sliding down the bridge and stear the car around the corner and off of the main street , I called my dealer and later requested that the stresses upper ball joint be replace as well as the right lower ball joint but was told they would not do that , I am very worried that what happened on the left side will soon happen on the right side and I dont want to go through this again , I was only going 35 MPH and driving in town but what would happen on the interstate at 75 MPH , I now think of it as a ticking time bomb ready to go off at any time and the driving experiance wont be the same anymore .
Left lower ball joint snapped, and could have caused an accident. Cause unknown. Dealer notified.
While driving 2 MPH and without warning, the lower right ball joint broke causing the right wheel to fall off, no accident occurred. *ak
Related recalls
Suspension: front: control arm: lower arm
- What is wrong
- On certain passenger vehicles, the lower control arm ball joints may experience a loss of lubrication that can result in accelerated wear and possible separation from the steering knuckle.
- Risk
- A ball joint that has separated may result in loss of directional control.
- Remedy
- Dealers will replace the front lower control arm ball joints with modified assemblies. Owner notification began on april 4, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1‑800‑853‑1403 or check on-line at http://www.chrysler.com/webselfservice/chrysler/index.jsp
Recall number 03V034000 · Recall details
Questions about the 1999 Plymouth Prowler ball joint
Is ball joint or control arm failure a common problem on the 1999 Plymouth Prowler?
8 of 18 owner complaints about the 1999 Plymouth Prowler (44%) mention ball joint or control arm failure. The model year with the most reports is 1999.
Is there a recall or service bulletin for this on the 1999 Plymouth Prowler?
There is 1 recall and 0 service bulletins for the same area of the car. Check them below with your VIN.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1999 Plymouth Prowler?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history