Abs and traction control light remain on 90% of the time I am driving. I have previously on two occasions had the left wheel bearing and hub assembly replaced at approximately $450.00. That is what the computer codes indicated. The first time the problem went away for a few months, but then it returned. The last time the problem went away for three hours. This disables ABS and traction control systems from operating. It is probably a short circuit or brake sensor problem. There should be a pontiac, government-mandated recall to correct this safety matter. Thank you.
Pontiac Bonneville abs comes on
80 of the 1,902 owner complaints about the Pontiac Bonneville describe aBS light or ABS activating, most of them for the 1993 model year.
- owner complaints
- 80
- worst model year
- 1993
- typical mileage
- 60,000
Is there a fix? There are 2 recalls for this area of the car. See below
By model year
Often reported together
Brake failure 19Grinding brakes 4Adaptive cruise 2Tire blowout 1Loss of power 1
What owners say
2001 bonneville ABS wheel hub assembly sensor failed and had to be replaced. *ts ***nar*** this part has been replaced four times. The consumer would experience erratic braking at low speeds. The first replacement of the right front assembly was at 16619 miles and the most recent replacement was done at 55030 miles. The vehicle's trunk release was inoperative. The dealer replaced the communication link and trunk release fuse. The front transmission mount was worn caused excessive movement. The dealer replaced the front transmission mount.
Over the past few days noticed that the brake pedal was traveling much farther than normal. Since this is my wife 's car, and I do not drive it much,thought that the back shoes were low since they had not been replaced in awhile. Purchased a new set and planned on installing. However the next day noticed that the brake light warning came on and the brake fluid was low. Topped up and light went out. I thought that the low level was do to the worn shoes which would make the level go down. However the level continued to go down as I drove. That meant a leak. Thought perhaps a wheel cylinder. All looked ok the problem : rusted out brake lines from the master cylinder to the ABS controller all in the engine compartment all four lines rusted two or more leaking!!! Continued use and hard braking would have cause no brake and surely and accident all four lines must be replaced these lines also go under the car to the back. Will have the dealer do have called gm and go no satisfaction car is a 1999 bonneville 113000 miles this should never happen . Poor quality steel and workmanship have owned cars with 300000 + miles and some 20 + years old with no problems like this. Why aren't brake lines stainless steel???
Dt: the contact stated there was something wrong with the stability system. The stability system light illuminated periodically, stating stability system active. When the light illuminated the vehicle vibrated and decelerated temporarily. Also, if the light illuminated when applying the brakes the ABS will activate. A local mechanic performed a diagnostic test , and said it was the stability system sensor in the steering column. To repair the vehicle they will have to replace this sensor.
Abs brake light came on while driving. Dealer installed a new brake module because of corrosion and a new connector because of corrosion. This is the same complaint that has come out with the gm suvs and trucks. It could be the same for the bonnevilles. Part numbers for brake module 12226953 $438.66, connector part # 12084595 cost $.63.
The consumers pontiac 2001 bonneville failed 3 separate incidents to the same ABS wheel hub assembly/senor. *bf the consumer requested reimbursement. The right front speed sensor corroded harness and a shorted sensor, the left front speed sensor was not reading correctly, the left front speed sensor was excessive, when the cruise control was engaged, there would be a 4 MPH variation in speed, the accelerator pedal would pivot and cause a squeaking noise and the ABS light illuminate repeatedly.
While driving,the driver noticed that the ABS brake, and the track off light appeared on the dashboard and remained on. The vehicle started shaking uncontrollably without warning. The driver was able to drive it to the dealer for inspection. The mechanic replaced the brakes pads,and rotor. The driver informed the mechanic this problem still occurred and has not been resolved. Please fill in additional information.
Intermittently ABS traction stability warning light illuminated on the dashboard. When this occurred the cruise control mode was inoperative. Dealership performed a diagnostic test the failure code indicated, don't drive the vehicle and service immediately ABS stability control failure. Dealership serviced the vehicle 4 times, only temporary fixes had been done, problem still exists.
Abs light came on, when applying brakes vehicle did not stop on wet pavement. Took vehicle to dealer who indicated that ABS computer malfunctioned.*aksensor failed also.
Consumer states the stability system had to be serviced 8 times, consumer stated the stability system is part of the ABS.*ak
Related recalls
Service brakes, hydraulic: foundation components
- What is wrong
- Vehicle description: passenger vehicles. Some of these vehicles have internal fluid leaks in the brake hydraulic control unit.
- Risk
- When the rear brake proportioning, antilock brake, traction control, or stability control feature is activated in some driving situations, the feature may not perform as designed.
- Remedy
- Dealers will inspect the ABS hydraulic modulator unit and if necessary, replace the hydraulic modulator.
Recall number 00V114000 · Recall details
Parking brake: conventional: mechanical
- What is wrong
- When applied, the parking brake lever assembly may release one or more teeth, reducing the cable load to the rear brakes.
- Risk
- Depending on the extent of the lever release and roadlevel. The parking brake may not hold the vehicle, allowing it to roll, whichcould result in an accident. Vehicle does not comply with fmvss 105.
- Remedy
- Replace parking brake lever assembly.
Recall number 91V167000 · Recall details
Questions about the Pontiac Bonneville abs
Why does the abs come on in the Pontiac Bonneville?
Owners who report it most often also describe brake failure, grinding or squealing brakes and soft or spongy brake pedal.
Which Pontiac Bonneville years have aBS light or ABS activating problems?
The model years with the most reports are 1993 (21 complaints), 1992 (19 complaints) and 1990 (11 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Pontiac Bonneville?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history