2012 Prevost H3-45 technical service bulletins
188 technical service bulletins and manufacturer communications cover the 2012 Prevost H3-45.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- The gasket thickness was increased from 1.5 mm to 3 mm to prevent interference between the collar ends,...
- Sway bar collars improvement
- Sway bar collars improvement
- H3 lavatory fan retrofit kit
- Kit power steering tank convertion cummins to zf with D13 engine
- Improved bearings are now available to replace the original bearings used on some Prevost vehicles idler...
- Electric fan drive cooling system conversion with bosch alternator
- ELECTRIC FAN DRIVE COOLING SYSTEM CONVERSION WITH DELCO REMY ALTERNATOR. REVISION : i Note added regarding...
- Steering gateway.
- Air Tanks Draining Sequence
- Air Tanks Draining Sequence
- Air Tanks Draining Sequence
- Halogen to LED fog light replacement kit
- Tag axle hub flange - alternate cap screw
- STEERING GATEWAY, revision A : Cancel watch dog removal from EFD part of the instruction
- STORAGE AND STARTUP GUIDELINES : part number updates
- Steering gateway
- Central HVAC merv filters installation
- H3 series envirocare - ions air sanitizer
- Bosch HD10 alternator diagnostic guide
- Diesel Exhaust Fluid ( DEF ) Contamination In Fuel System, Inspection And Repair – From US10 to newer...
- Lavatory compartment sliding door latch improvement
- Ront & tag axle – unitized hub bearing end play verification and replacement
- Eberspacher preheater installation
- Sound Selector replacement, VSS04 to VSS05; When replacing a vehicle sound selector model VSS04 with a new...
- H3 series envirocare - ions air sanitizer rev a
- Central HVAC merv filters installation reva
- Storage and startup guidelines
- Tie rod 610052 first installation instructions
- Prevost aware adaptive cruise braking (ACB) – FLR10 to FLR21 radar sensor upgrade applicable to: H3 series...
- Introducing a new engine coolant into prevost service center network
- Volvo i-shift transmission replacement - difference between connections at the top of the oil filter housing
- Rev A: Mention added concerning DDC Series 60 engine SCA requirement
- Introducing a new engine coolant into service
- Revision : A Torque value reduced
- Engine oil & filter change intervals - volvo D13 engine, from US10
- Lavatory fan retrofit kit
- H3 driver’s partition lite installation
- Sigma passenger seats partition kit
- Storage and startup guidelines
- Engine Exhaust Gas Recirculation Differential Pressure
- Jerky, noisy or hard to turn steering gearbox
- Electric fan drive cooling system conversion with delco remy alternator
- Electric fan drive cooling system conversion with bosch alternator
- Storage and startup guidelines
- Plexiglass Shield Behind Driver H3 Series
- Prevost vehicle disinfection procedure
- Hand sanitizer dispenser installation
- Prevost vehicle disinfection procedure
- Storage and startup guidelines - all prevost vehicles & volvo 9700
- Repair instructions to address fault codes P029800
- Repair instructions to address fault codes P052400 Engine Oil Pressure Too Low
- Repair instructions to address fault codes P256000 Engine Coolant Level Low
- Added: Power cables for L.H. side alternator & fan drive breaker box
- Repair instructions to address fault codes P207F-00
- Repair instructions to address fault codes P207F-00; P20EE-00
- Repair instructions to address fault codes P021700 Engine Coolant Over Temperature Condition
- This instruction sheets explains how to replace the fuel tank on H-series vehicles
- Revision : Mention added in the instruction sheet stating to disable "Prime"
- Revision : Mention added stating to disable Prime.
- This instruction Sheet explains how to install a seatbelt cutter in the driver's area
- This Instruction sheet explains how to perform an Electric Fan Drive Cooling System Conversion with Delco...
- This instruction sheet explains how to install the electric fan drive cooling system conversion kit with...
- This instruction sheet explains how to replace halogen fog light to led's
- The intent of this procedure is to guide you through the steps required to program a MCM especially for...
- This instruction sheet explains how to relocate the wheel chair lift parcel rack fan
- This Instruction Sheet explains how to perform the first installation of Tie Rod 610052 on Prevost...
- Electric fan drive cooling system conversion with bosch alternator - H3 series US10 cooling system
- Electric fan drive cooling system conversion with delco remy alternator
- MP-1000 multimedia player installation
- Vehicles identified below are compatible with a new tie rod design
- This instruction sheet explains how to install the Tie Rod 610052.
- Wheel fender stainless steel protector
- This instruction sheet shows how to install a flap over the diesel filling cap.
- This instruction sheet shows how to replace kneeling level sensor #21643575 by sensor #22194741.
- This instruction sheet explains how to install Delco Remy Alternators
- This instruction sheet explains how to convert H3 SERIES US10 vehicles equipped with Bosch Alternators to...
- This instruction sheet explains how to install a GM Glove box Lock on H-Series vehicles
- This instruction sheet explains how to install an ELD interface kit on Pre-OBD Prevost Vehicles equipped...
- This instruction sheet explains how to install a flap over the diesel filling cap
- This Instruction sheet explains how to replace the ?MASTER ID? WITH ?MCM? Module
- This procedure explains how to program a MCM especially for the control of the electric fan drive, as...
- This instruction sheet explains how to convert H3 SERIES US10 vehicles equipped with Bosch Alternators to...
- This instruction sheet explains how to convert H3 SERIES US10 vehicles (equipped with Delco Remy...
- This instruction sheet explains how to install and adjust drag link # 660699
- This instruction sheet explains how to replace fenders made of fiber glass with Aluminium
- This Instruction sheet explains how to replace the "MASTER ID WITH MCM" Module
- This Service Center Instructions explains how to install the Prevost Ultimate Entertainment System
- This instruction sheet explains how to install hatches with fan on H3 vehicles.
- This Maintenance Information presents information about the Bitzer A/C compressor oil change interval and...
- This insruction Sheet explains how to insall the Bosch HD10 24v-150a Alternator Conversion Kit ? Twin...
- This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternators
- This Maintenance Information presents guidelines to help with the diagnosis of the Bosch HD10 alternators
- This Mainteannce Informaiton presents the latest engine oil & filter change intervals for the Volvo Engine
- This internal instruction explains how to bench program the FMS gateway module used in the ELD (Electronic...
- This instruction sheet explains how to optimise the operation of the lavatory fan
- This Maintenance Information explains how to inspect the Fuel Tank Cradle Mounting Screws on a yearly basis
- This instruction sheet explains how to install the Volvo Electronic Logging Device (ELD)
- This conversion kit explains how to to disable the ACB radar.
- This conversion kit explains how to remove TGW1 from vehicles using Tech Tool, no manual VDA changes needed
- This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? Module
- This instructions sheet explains how to program a Wabco Smart Trac ABS ECU.
- This instruction sheet explains how to install latest radio models
- This Instruction Sheet explains how to install a wheel fender stainless steel protector
- This instruction sheet explains how to use the Bosch HD10 24V-150A Alternator Conversion Kit
- This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternator.
- This Instruction Sheet explains how to add Sunshade Switches on the Dashboard
- Use this procedure for the removal and installation of the twin Bosch HD10 (120A or 150A) Alternators.
- New aramid cord poly-v belts are now available to replace the polyester cord alternator belts previously...
- Explains that improved bearings are now available to replace the original bearings used on some Prevost...
- This maintenance information describes the steps to be followed on your computer to add the volvo engine...
- When replacing a vehicle sound selector model VSS04 with a new sound selector model VSS05, an interface...
- This Instruction Sheet does explain how to proceed to the Fuel Tank Replacement, from # 031868 tank by...
- The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new...
- This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? MODULE
- Use this maintenance information procedure to resolve an undesired behaviour on 2008-2012 vehicles
- This Instruction sheet explains how to prevent AC Copper Pipes Chaffing at Engine Bulkhead
- This Maintneance informations presents an improved harness and wiring modification procedure to avoid...
- On the vehicles affected by
- This procedure explains how to perform a STARTER REMOVAL AND INSTALLATION, and does apply to Melco 105P70...
- Bendix M-32QR ABS modulator valve replaced by new M-40QR valve.
- This Maintenance Information explains how to run a n Air Conditionning performance test
- This Instruction Sheet explains how to assemble the BENDIX FLR10 AND FLR20 RADAR SENSOR ALIGNMENT TOOL
- This Maintrenance infomration explains that the Castrol Syntrans oil isn?t fully approved for 500 000...
- New aramid cord poly-v belts are now available to replace the polyester cord alternator belts previously...
- This Maintenance Information reminds Prevost customers that cleaning products designed for external...
- This Instruction sheet explains how to replace MASTER ID? WITH ?MCM? MODULE
- On the independent front suspension level valve linkage of the vehicles affected by
- This Maintenance Information does explain how five year old vehicles and older should be subjected to a...
- This Maintenance Information explains how to perform an inspection of the vehicle power cables
- This instruction sheet explains how to use the Bosch HD10 24V-150A Altenrator Conversion Kit
- On the vehicles affected by
- This Maintenance Information presents an improved differential breather kit, identical to the one now used...
- On the vehicles affected by this special bulletin, add a 3 amp diode to the corresponding 24CO circuit to...
- On the vehicles affected by
- On the vehicles affected by
- On the vehicles affected by
- A new software version (v1.06) is available to update the CANtrak (Tire Pressure Monitoring System) module
- On the vehicles affected by
- This Instruction Sheet explains how to replace 562489 Dimmer, using kit #069136
- On the vehicles affected by
- Prevost: turbo inspection and replacement required for X3-45 coaches, XLII-45 entertainer, X3-45 vip...
- On the vehicles affected by
- On the vehicles affected by
- On the vehicles affected by
- On the vehicles affected by
- This Maintenance Information explains that on some post EPA 2010 vehicles, it is possible for the combined...
- When replacing a vehicle sound selector model VSS04 with a new sound selector model VSS05, an interface...
- This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced...
- This Maintenance Information explains that hose clamps with a smaller diameter are available to increase...
- On the vehicles affected by
- Prevost: a corrective measure is required due to bolts loosen by being tightened to part made of rubber,...
- On the vehicles affected by
- Check the presence of error code PPID 329 on dashboard
- On the vehicles affected by
- On the vehicles affected by
- Prevost: warranty information provided regarding availability of an auxiliary coolant tank, when main...
- On the vehicles affected by
- On the vehicles affected by
- On the vehicles affected by
- This Instruction Sheet explains how to replace power relay p/n 561991 with improved power relay p/n 564218...
- Prevost: information being provided regarding the replacement of dipstick on certain coaches
- Prevost: corrective measure for the EGR valve is necessary because of the unnecessary presence of o-rings,...
VIN decoder
See the problems and recalls for an exact car
Buying a used 2012 Prevost H3-45?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history