Twice in the same manner my 2014 Ram has sucked the fan shroud through the radiator. When under load (towing under the weight maximum) and moving at highway speeds 60-70 MPH, the fan shroud softens to a point where it is pulled in by the fan and slung through the radiator causing debris and immediate leakage and power loss, effectively stopping the vehicle. This fault has occured twice the same way in the last two years and according to forums is a continuous problem with the trucks
2014 Ram 2500 transmission problems
62 complaints (18% of all complaints for this car). Typical mileage when it fails: 47,968. 5 crashes reported.
- owner complaints
- 62
- of this car's complaints
- 18%
- typical mileage
- 47,968
- crashes
- 5
- recalls
- 1
Which part fails
- Automatic transmission: control module (TCM/PCM/tecm)2
- Driveline: driveshaft1
- Automatic transmission1
At what mileage
Complaints by mileage at the time of the problem.
Ram 2500 transmission problems in other years
Related recalls
Power train: automatic transmission: lever and linkage: column shift
- What is wrong
- Chrysler (FCA US LLC) is recalling certain 2016-2017 Ram 3500 Cab Chassis with a Gross Vehicle Weight Rating (GVWR) of less than 10,000 lbs, 2011-2017 Ram 3500, 4500 and 5500 Cab Chassis vehicles, 2009-2017 Ram 1500 and 2010-2017 Ram 2500 and 3500 pickup trucks, all equipped with a column shifter. Pushing the brake pedal for prolonged periods when the vehicle is running and in PARK may cause the Brake Transmission Shift Interlock (BTSI) pin to stick in the open position. With the pin in the open position, the transmission can be shifted out of PARK into any gear without pushing the brake pedal or having the key in the ignition.
- Risk
- Being able to shift the transmission without pushing the brake pedal and/or without a key in the ignition can increase the risk of an unintended vehicle rollaway that may result in personal injury or a crash.
- Remedy
- Chrysler will notify owners, and dealers will update the vehicle software, inspect the BTSI, and, as necessary, replace it, free of charge. The recall began February 26, 2018. Owners may contact Chrysler customer service at 1‑800‑853‑1403. Chrysler's number for this recall is T79.
Recall number 17V821000 · Recall details
Related investigations
Post Recall Remedy Brake Transmission Shift Interlock (BTSI) Failure
The Office of Defects Investigation (ODI) has received 14 Vehicle Owner Questionnaire (VOQ) reports and 6 EWR Death & Injury (D&I) reports describing post recall remedy failures of the brake transmission shift interlock (BTSI) system in certain Model Year (MY) 2013-2018 RAM pickup trucks.The subject vehicle models include 1500, 2500, 3500, 4500, and 5500 trucks equipped with a column mounted shift lever.The failures of the BTSI described in the VOQs occurred on vehicles that had all previously been repaired under recall 17V‑821 or 18V‑100.Both recalls address a potential condition which can cause the BTSI locking pin to become stuck allowing the transmission to be shifted out of Park without depressing the brake pedal and/or without having a key in the ignition.Shifting the transmission out of Park when not having the brake pedal depressed can result in a vehicle rollaway. ODI is opening this Recall Query (RQ) to review the effectiveness of the 17V‑821 and 18V‑100 recall remedies, understand the root cause of additional vehicle rollaway incidents, and identify any other possible root cause that may affect the performance of the BTSI system. To review the ODI reports cited in the Opening Resume ODI Report Identification Number document, go to
RQ25003
What 2014 Ram 2500 owners say
Most recent owner complaints, unedited.
Stuck in fourth gear Check engine light illuminated
Upon starting the trucks engine, putting the transmission in gear (either Reverse or Drive), at idle engine speed (approx 700-800 rpm) or very low (near idle speed) the trucks engine starts to surge from idle then drops down to 500 rpms with a voltage drop (5V) too. It will do this a couple of times and then the trucks engine dies (engine stops) while in gear and no codes are shown on the CEL or saved in the vehicle control module. When I put the transmission in Park, the trucks engine restarts without a problem. But when I go to Drive or Reverse gear it then will do it again. The truck sounds like the engine brake is being applied causing the engine to lug/bog down. The torque converter has been inspected and replaced. The fuel pump/lifter has been replaced. The batteries have been replaced. The fuel filters have been serviced; the crank case breather has been serviced. The emissions controls equipment (EGR valve) have been serviced/cleaned. Knowing that my trucks engine can cut out/die at anytime at low rpms, poses a safety hazard. Knowing that the truck can do this without a code being throw feels unsafe.
The contact owns a 2014 Ram 2500. The contact stated while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was taken to an independent mechanic where the mechanic reset the check engine warning light. The contact proceeded to drive the vehicle to the residence. The contact stated that while driving, the gear shifter independently shifted from drive to neutral. The contact noticed a metallic clicking sound that came from the engine compartment. The contact stopped and parked the vehicle into a nearby parking lot. The contact turned the vehicle off and restarted the vehicle and was able to shift the gear shifter into drive. However, the contact continued to notice the clicking sound. The vehicle was towed to an independent mechanic. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 129,000.
The contact owns a 2014 Ram 2500. The contact stated that the transmission seized, and the gear shifter was stuck in park(P). No warning light was illuminated. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 54,000.
The contact owns a 2014 Ram 2500. The contact stated while her husband was driving approximately 40 MPH, the transmission shifted independently into neutral(N). The contact stated there was no warning light illuminated. The driver was able to park on the side of the road and shifted the vehicle into park(P). The contact stated then experienced the failure within 20 minutes. The contact stated that her husband was able to continue driving to his destination. The contact called the local dealer and made them aware of the failure. The vehicle was not diagnosed or repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 51,700.
When putting the truck in Gear to go in reverse, the gear shifter on the steering column came loose from the column and fell out. This exposed the column and it was found that an aluminum bracket holding the gear shift had broken in half. Truck could not be put in park to shut off engine.
The contact owns a 2014 Ram 2500. The contact stated that while driving at 20 MPH, he temporarily released the accelerator pedal and when he depressed it again the vehicle failed to respond. There were no warning lights illuminated. The contact stated that he veered to the side of the road. The contact stated that after he disconnected and reconnected the battery terminals, he was able to restart the vehicle and the accelerator pedal responded when depressed. The vehicle was taken to the dealer who diagnosed that the accelerator sensor needed to be replaced. The contact stated that the accelerator sensor was replaced; however, the failure reoccurred five times. The manufacturer was not notified of the failure. The vehicle was not repaired. The approximate failure mileage was 230,000.
The part that failed the first time was transmission module. We were 12-13 hrs from home when 2500 tried to engage 4wd while truck was moving approx 55 mph. While pulling horse trailer. It tried to engage 3 times during repetitive stops along narrow highway. Truck was making loud grinding noise during the attempts to engage 4wd while moving. Truck failure on highway with NO shoulder with NO option but to stop put whole rig in danger of collision. After internet research we pulled appropriate fuse & drove into park. Upon return home 2500 was driven to Russell Barnett Dodge for inspection and repair. Cost to us $721.05 due to no warranty. 4wd service lite appeared while trying to engage. After repair, and approx 200 miles later during an out of state trip pulling horse trailer, the 2500 service lite appeared, and the truck tried to engage 4wd at 65 mph on interstate highway with the same noise. Again pulled fuse and continued trip. We have logged each event with Ram corporate and obtained case numbers. They did not feel this was a safety issue, was not covered under warranty, and our responsibility. So the first repair did NOT work and failed again 2nd time. Ram still would not cover repair & dealer repair shop is saying it’s a different module. But all symptoms were identical from first event. We feel this is a safety issue - on highways pulling a trailer and potentially becoming a moving obstacle for other drivers if the truck had engaged 4wd at high speed.
Tl* the contact's parents owns a 2014 ram 2500. The contact stated that while driving at various speeds, the vehicle stalled without warning. The contact stated that the vehicle was restarted and resumed normal operation. The contact had taken the vehicle to northwest jeep chrysler dodge ram (10600 sw canyon rd, beaverton, or 97005) on multiple occasions where the transmission mount and transmission were replaced. Despite the repairs, the failure persisted. The manufacturer was not notified of the failure. The vehicle was not repaired and remained in the possession of the dealer. The failure mileage was approximately 74,000.
Questions about the 2014 Ram 2500 transmission
Does the 2014 Ram 2500 have transmission problems?
Owners have filed 62 complaints about the transmission of the 2014 Ram 2500, 18% of all its complaints.
At what mileage do 2014 Ram 2500 transmission problems start?
The typical (median) mileage in owner complaints is 47,968 miles.
Was there a recall on the 2014 Ram 2500 transmission?
Yes, 1 recall: 17V821000. Check your VIN to see if your car still needs the free repair.
What year does the Ram 2500 have bad transmission?
The Ram 2500 model years with the most transmission complaints are 2018 (75 complaints), 2016 (64 complaints) and 2014 (62 complaints).
Other 2014 Ram 2500 problems
Steering 87Engine 64Electrical 42Suspension 37Acceleration 32Fuel system 31Brakes 22Airbags 17Body 16Tires 13Wheels 11Seat belts 7Lights 5Driver assistance 4Visibility 3Locks 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2014 Ram 2500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history