Brake vacuum pipe check valve broke apart, resulting in a loss of braking power and check engine fault. Car was not drivable after incident.
2006 Saab 9-3 brakes complaints
Page 2 of 2: complaints 11 to 31 of 31, newest first, as owners wrote them.
On cold startup the vehicle has no power assisted brakes. This has lead to numerous occasions where you get in the car and begin to back out and nearly hit another vehicle. It takes nearly a minute after startup of the vehicle before it is safe to put it in gear.
Found my cap to my brake reservoir cracked open like a tin can above the threads. The plastic literally split in two. The cap still could be twisted on and off easily, but would no longer prevent brake fluid from escaping. Cap will be replaced with a new one. I have heard similar complaints from people with my car possibly related to the heat generated by the turbo. 2006 saab 9-3 aero 2.8l v6.
Intermittent brake failure. More noticeable at cold starts pulling out forward or backward. Brake pedal goes to the floor with very little braking power. Very dangerous to drive and we parked the car and contacted the dealer. They have now had the car for 4 weeks and are waiting on a part from the factory. This is a very dangerous situation on this car and could very easily result in an accident with injuries or death. I am a male and it was all I could do to get the car stopped on at least 2 occasions. I had to use the emergency brake on one occasion to avoid a collision. This car has 32,000 miles on it. The dealer said the problem was a vacuum line on the brake booster but the replacement must come from saab. I am not sure if this will resolve the problem or not.
2006 saab aero v6, at a cold start and while backing out of the driveway, the brake pedal goes very hard and the car will not stop for 15 -20 ft.
Similar issue to the federal safety agency defect investigation # pe08005. Loss of brake power assist after a cold start up and reversing. The vehicle is very hard to stop, requiring high pedal pressure, until the car has warmed up for ~30 seconds. This has occurred numerous times over the past 6 months. It is more prominent after sitting for several days. Also while driving on the road, when a bump is hit while brakes are applied, brakes make a metal-on-metal grinding sound and the braking action does not work until additional pressure is applied. This also happened when braking on slippery road conditions such as snow or rain. This caused a near accident when my car did not stop for another 10 feet than intended and entered an intersection on a red light.
Tl*the contact owns a 2006 saab 9-3. While driving approximately 50 MPH, the power steering failed. Immediately, the brake and accelerator pedals failed to respond and the engine stalled without warning. The engine failed to restart after several attempts. Roadside assistance was called to the scene and the vehicle was towed to an authorized dealer for inspection. The technician stated that the failure was related to the idling within the computerized system. The vehicle was taken back to the dealer on two separate occasions for identical failures. The technician stated that the failures were related to the temperature sensor, which was replaced. The failure continued and the vehicle is currently being repaired. The VIN was unknown. The failure mileage was 40,000 and current mileage was 40,550.
Loss of brake power assist after a cold start up. The vehicle is very hard to stop, requiring high pedal pressure, until the car has warmed up for ~30 seconds. This has occurred numerous times over the past 6 months.
Car will not stop when in reverse after morning start-up. No braking power in reverse even at idle. Problem has been addressed 3 times by dealership. Car in again for same problem only 5 days after previous "fix" in shop again now almost 2 weeks as of today.
On cold start, my hydraulic brakes fails to operate.
I own a 2006 saab 9-3 aero sport combi. Two weeks ago, after the vehicle had been parked for 24 hours, I started the vehicle and placed the gear shift in reverse. The vehicle started rolling out of the drive way. The brake pedal was rock hard at the top of the stroke. It took me nearly 75 feet to stop the vehicle. The vehicle was traveling at 2-3 MPH. The vehicle is currently at the dealership because the brake booster is back ordered. This is the third time the vehicle has been in the shop for this complaint. Each time the aux. Brake booster was replaced.
When a bump is hit while brakes are applied, brakes make a metal-on-metal grinding sound. When steering wheel is turned after braking (pulling into or out of parking space) metallic clicking sound is heard. Brakes work better after car is warmed up.
Loss of brake power assist after a cold start up. The vehicle is very hard to stop, requiring high pedal pressure, until the car has warmed up for ~30 seconds. This has occurred numerous times over the past 6 months. The car has been left with 2 different dealers on several occasions, to allow them to observe and diagnose the problem. They have never been able to duplicate it. I have given the dealers info about the current the federal safety agency investigation (pe08005) pertaining to this same complaint for this model car from several other sources, and noted that earlier models of this car were recalled for a (possibly) similar defect.
Tl*the contact owns a 2006 saab 9-3. On three occasions, when applying the brakes, the pedal extended to the floor. The failure was noticed while driving 3 MPH. The vehicle did not stop. She pumped the brakes and the vehicle eventually stopped. On the third occasion, she ended up in the middle of an intersection before the vehicle stopped. The dealer currently has the vehicle. The contact stated that she was experiencing the same failure as mentioned in the federal safety agency campaign id number pe08005 (service brakes, hydraulic:power assist:vacuum service brakes, hydraulic: power assist:vacuum:hoses, lines/piping, and fittings). The current mileage was 15,300 and failure mileage was 15,000. Update 04-02-08 *bf the dealer replaced the mast cylindere. Updated
My 2006 saab 9-3 aero has a series of unpredictable braking motions. I have had the braking sensor assembly replaced - however brake pressure and control are unpredictable. Letting up on the brake slowly results in a loss of all brake pressure in a non-progressive fashion. There are also times that only by pushing the brake pedal all the way down to the stop that the car can be held in place when idling.
Intermittent loss of brake power assist on cold start, giving very hard pedal. Recovers with several pumps of brake pedal, or several seconds of idle time. Began about mid-june, 2007, and was reported to dealer. Behavior is not consistent, and may vary with weather conditions. Barely avoided a low-speed accident in a parking deck first time it happened. Car taken to dealer specifically to identify / repair problem on 11-7-07. Dealer response has been positive, but unable to locate specific problem. Dealer found that other saab 9-3 aero (v6) models exhibited similar characteristic, including brand new 08. Further pursuit with saab got negative response, as dealer was unable to find the problem, and reported the car "normal" in that it behaved as other similar models on cold start. I then reported to a saab owner website, and responses from others LED to coverage of current the federal safety agency investigation pe08005.
Fear of accident coming from brake booster continuing to go bad in my car. Brake will stiffen and not stop car - will only slow down. Car has been looked at 5 times since nov. 2006 for this condition. Gm will not do anything but replace the part and it has failed numerous times, replaced 2 times after complaints.
The ABS system was not working correctly for the first 6 months that I owned the car. This caused the rear brakes to be partially engaged all the time when the car was driven. It was so bad that you could hear and smell the brakes scraping. The dealer said it was all right to drive the vehicle. I took them approx. 6 months to get the correct parts to repair the problem. All the time the brakes were rubbing which caused them prematurely wear out. I have never in my life had rear brakes wear out in 15k miles. One of two things has happened. The ABS caused the pads to wear out or they had bad brake pads to begin with.(note: my other saab has 30k miles on it and still has it's original rear brakes).
Tl*the contact owns a 2006 saab 9-3. The contact discovered that his brakes failed shortly after starting the vehicle when he placed the vehicle in reverse to back out of his parking space. When the transmission is shifted from park into reverse or drive before the engine has been warmed up, the brakes do not work to slow the vehicle and the brake pedal feels rock hard. To stop the vehicle the contact shifted the transmission into park. Brake function appeared to return to normal after the engine warmed up. This failure has occurred on four separate occasions. At 15,383, the contact struck another vehicle when the brakes failed while reversing out of a parking space. The crash occurred at low-speed approximately 2mph and no one was injured. The contact's vehicle was scratched but there was no apparent damage to the other vehicle. Dealer replaced electric vacuum pump multiple times under warranty. Contact claims faulty vacuum check valve caused brake booster to leak and electric vacuum pump to run too long and burn out. The contact pursued remedy under lemon law and the vehicle was repurchased by saab on january 7, 2008.
Tl*the contact owns a 2006 saab 9-3. While reversing the vehicle at 4 MPH, the contact depressed the brake pedal and the vehicle did not stop. He had to stand on the brake pedal in order to stop the vehicle. The failure occurred approximately six times and only when driving in reverse. The vehicle was taken to the dealer on september 24, 2007. The contact believed that the vehicle should be included in the federal safety agency campaign id number 05v236000 (service brakes, hydraulic:power assist:vacuum:hoses, lines/piping, and fittings). The current and failure mileages were 13,000.
22 june 07 rear brakes replaced, noticed on initial driving that brake pedal would 'bottom out' , brakes would make metal on metal sound, and vehicle slow to stop. 13 july 07 vehicle returned to dealer with brake complaint, hand brake adjusted. 17 aug 07 vehicle returned to dealer with same above complaint, vacuum booster pipes and non-return valve replaced 5 sep 07 vehicle returned to dealer with same complaint, vacuum pump pipe assembly replaced again. 10 sep 07 vehicle returned to dealer with same complaint, no problem found. As of this date brakes continue to malfunction on initial startup, once brakes have been used for several stops they appear to start working more correctly.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Saab 9-3?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history