?emergency window latches are not operational, break very easily and do not relatch once opened ?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) ?constant fog light replacement.
2014 Stallion 900 seat belts problems
10 complaints (31% of all complaints for this car). Typical mileage when it fails: 4,334.
- owner complaints
- 10
- of this car's complaints
- 31%
- typical mileage
- 4,334
- crashes
- 0
- recalls
- 0
Which part fails
Owners did not name a specific part.
At what mileage
Complaints by mileage at the time of the problem.
0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+
Related recalls
No recalls on record for this model year.
Related investigations
Seat Belt Buckle Inoperative
The Office of Defects Investigation (ODI) was in contact with a fleet that experienced multiple incidents of driver and passenger seatbelt buckle assemblies failing to unlatch.The seatbelts, manufactured by Taizhou TIANDA Rope and Belt Co, are original equipment on certain Stallion 900 motorcoaches.Preliminary evaluation suggested that two significantly different buckle assembly designs exist for a single part number 67RB1-04021.At the time of this investigation, failures appear to be limited to the earlier design. Shortly after opening this investigation, Taizhou Tianda Rope & Belt Co. Ltd decided to recall the earlier design buckles with safety recall 15E-016.An information request letter was not delivered before the recall was announced.Based on this action by the manufacturer, this investigation is closed.The ODI reports cited above can be reviewed at www-odi.the federal safety agency.dot.gov/owners/Searchreference under the following identification (ODI) numbers: 10631019, 10632409, 10633199 and 10633213.
PE15004
What 2014 Stallion 900 owners say
Most recent owner complaints, unedited.
Emergency window latches are not operational, break very easily and do not relatch once opened driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) constantly replace fog light bulbs constantly replace head light bulbs
Driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) rear heater inoperable heater switches for rear heat were never installed upon arrival code #1 all buses were delivered w/ no regen switches.
Passenger seatbelts keep getting stuck ( do not unlatch to open and sometimes do not retract) rear heater inoperable heater switches for rear heat were never installed upon arrival code #1 all buses delivered w/ no regen switches.
?emergency window latches are not operational, break very easily and do not relatch once opened ?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) ?constantly replace fog lights.
?emergency window latches are not operational, break very easily and do not relatch once opened ?passenger seatbelts keep getting stuck ( do not unlatch to open and sometimes do not retract) ?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts).
?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) ?consistent wipe issues, continuously had to reset inverters & replace 24 volt relays (made us remove 2 pieces from circuit board d4+r9) ?passenger seatbelts keep getting stuck ( do not unlatch to open and sometimes do not retract).
?driver's seat was allowed to go too far back & is located too low when adjusting seat it was going back it was cutting all air lines & wiring, height adjust mechanism is inoperable (had to install a screw to keep it steady) ?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) ?consistent wipe issues, continuously had to reset inverters & replace 24 volt relays (made us remove 2 pieces from circuit board d4+r9).
?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (replaced with aftermarket belts) ?consistent wipe issues, continuously had to reset inverters & replace 24 volt relays (made us remove 2 pieces from circuit board d4+r9) ?driver's seat was allowed to go too far back & is located too low when adjusting seat it was going back it was cutting all air lines & wiring, height adjust mechanism is inoperable.
?consistent wipe issues, continuously had to reset inverters & replace 24 volt relays buses had to stay staionary at randon locations because the wipers did not work in rain (made us remove 2 pieces from circuit board d4+r9) ?driver seat belts get stuck only retract sometimes / belt cover causes belt to be inoperable (was forced to replace with aftermarket belts) ?driver's seat was allowed to go too far back & is located too low when adjusting seat it was going back it was cutting all air lines & electrical wiring, making height adjust mechanism is inoperable.
Questions about the 2014 Stallion 900 seat belts
Does the 2014 Stallion 900 have seat belts problems?
Owners have filed 10 complaints about the seat belts of the 2014 Stallion 900, 31% of all its complaints.
At what mileage do 2014 Stallion 900 seat belts problems start?
The typical (median) mileage in owner complaints is 4,334 miles.
Was there a recall on the 2014 Stallion 900 seat belts?
There is no recall for this problem on this model year.
Other 2014 Stallion 900 problems
Lights 13Body 12Visibility 11Seats 7Electrical 2Engine 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2014 Stallion 900?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history