Tl* the contact owns a 2008 subaru wrx. The contact stated that while driving 10 MPH, the clutch pedal made a popping sound. The vehicle was taken to the dealer for diagnosis where it was stated that the clutch pedal bracket needed to be replaced. The vehicle was repaired but the problem persisted. The approximate failure mileage was 102,000.
2008 Subaru WRX transmission complaints
Page 3 of 3: complaints 41 to 48 of 48, newest first, as owners wrote them.
After having the car for a few weeks I noticed the clutch pedal started making noises. I investigated and found that the clutch master cylinder was moving a lot for a part that should not move. I did a little research online and on forums and found that many other owners of the vehicle had similar problems. The welds on the firewall have cracked. It cause my brake pedal to shift whenever I depress the clutch pedal. It also has gotten so bad that shifting into gear at any speed over the 3400 RPM range becomes very difficult and in some case impossible! I drive to and from work 60 miles a day 5 days a week and have not modified the car in any way since I purchased the vehicle. The winter season is coming up and this will be my first winter with the car. I would hope the cold weather does not make the situation worse but is highly likely! This issue has caused stopping and shifting problems. I would not like this issue to cause a possibility that something can go wrong during this upcoming winter to make my car fail drastically in performance and land me in a hospital or worse. Please I advise you to address this issue as many other owners of this vehicle are having the same problems. Others have attempted to re weld but found that it is costly and only a temporary fix until it breaks again.
About a year ago I started hearing a creaking noise. Only recently the noise had gotten worse so being a mechanic myself I decided I would take a few days and remove my dash board to pinpoint the noise since it had gotten worse lately. After removing the dash I could clearly see that the pedal assembly was bolted to a thin bracket that was welded to the main body frame. When I removed the pedals the bracket just fell right out. No weld was holding my clutch and brake pedal. I was amazed that the assembly never fell off while I was driving it for a year. Mind you the clutch was original and modifications was a simple air cleaner. I decided to rescuer it to the frame with machine nuts and bolts. After I assembled it there was still play in the pedal assembly and only a few weeks later the noise had returned. I guess the bracket needs to be secured better but this is why I'm concerned. One the noise is unbearable and two it's just not safe it could brake off again the move the brake pedal enough to cause someone to miss the pedal and accelerate into an accident.
I was sitting in traffic when I pushed down on clutch pedal and realized I had no clutch. I had to rev car to 2,500 RPM to put in gear to drive. Then every time I came to a stop the car felt wired to stop. As I looked by my feet I noticed my clutch and brake pedal was moving quite freely to side to side. It was to late in day to take car to dealer and being a mechanic I checked car out myself. That's when I saw that the bracket that is welded to my firewall broke completely off. After dealing with subaru and the dealer for a week now I have to pay $500 to have them fix the car as a courtesy they said. There are hundreds of complaints of this issue and what if I was on the highway and had to stop suddenly when this happened. I could have caused a major accident. Why do I have to pay to fix the flaw in the structural integrity of my vehicle that can cause an accident!
My clutch pedal has been clicking at the extent of depressing the pedal since I bought the car from a subaru dealership two years ago. I didn't think much of it because of how regularly it happened. About a month ago, it started to get louder and also began squeaking. I took it to a nearby dealership and they informed me it was probably a cracked weld on the firewall, which they had seen before. My car is just out of warranty, but they would not fix the problem even though it had been happening long before the warranty expired. The dealership quoted me $1,200 - $1,500, which is outrageous for something that is apparently a known issue with this model subaru. I learned that this is a well documented issue and I am going to take my case up with subaru.
Problem started with a squeaking/clicking when the clutch was depressed. Recently the whole clutch/brake assembly shifts down and to the left about 1/4-1/2" when the clutch is depressed. Looking up the problem, I see I have the same issue as many owners, the welds that hold the assembly to the firewall have broken free. Now it is difficult to shift at times.
The clutch pedal on my 2008 impreza wrx feels gritty and makes a loud creaking noise every time it's depressed. When I investigated the noise, I noticed that the entire clutch pedal bracket assembly (attached to the forward firewall) shifts approx 1/4 inch every time the clutch pedal is depressed. I found that the three spot welds securing the clutch pedal bracket to the forward firewall were broken. From the outside of the firewall, just under the windshield wipers, I saw the spot welds pulling away from the firewall every time the clutch pedal was depressed. This allows the entire clutch pedal bracket assembly to move, causing the creaking noise. If the bracket completely separates from the firewall, the clutch may become completely inoperative - especially dangerous while driving.
Welds holding pedal assembly to firewall are broken, squeaking clutch, very hard to get into gear, break pedal moving when using clutch.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Subaru WRX?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history