Terex C6000 recalls

There are 7 safety recalls on record for the Terex C6000, covering 3,281 vehicles in total across all the models in each campaign. Newest first.

Terex C6000 recalls by model year

2026 2 2025 2 2024 2 2023 2 2022 3 2021 3 2020 3 2019 2 2018 1 2017 1 2016 2 2015 2 2014 1 2013 1 2012 1 2011 1 2010 1 2009 1 2008 2

All recalls

Trailer hitchesReported October 2, 2026 · 100 vehicles affected

What is wrong: Ring Power Corporation (Ring Power) is recalling certain 2020 Terex General 65, 2020-2021 C6000, 2020-2022 C4000, and TC55 vehicles. The incorrect pintle hitch may have been installed without reinforced bracing, resulting in the rear bumper hitch plate bending.
Risk: The pintle hitch may fail, causing a loss of trailer control and increasing the risk of a crash.
Remedy: Ring Power will inspect, replace the pintle hitch, and install bracing. Damaged bumpers will be replaced. All repairs will be performed free of charge. Owner notification letters are expected to be mailed October 16, 2026. Owners may contact Ring Power's customer service at 904‑613‑0035. Ring Power's number for this recall is 23402.

Recall number 26V639000 · Recall details

EquipmentReported August 17, 2026 · 73 vehicles affected

What is wrong: Ring Power Corporation (Ring Power) is recalling certain 2019-2026 Terex C4000, C5000, C6000, and General 65 digger derrick trucks. An insufficient weld on the plate weldment may crack, causing the retaining pin to separate.
Risk: Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
Remedy: Ring Power will inspect and replace the weldment plate as necessary, free of charge. Owner notification letters are expected to be mailed September 2026. Owners may contact Ring Power's customer service at 1‑904‑737‑7730. Ring Power's number for this recall is UTC0001.

Recall number 26V534000 · Recall details

EquipmentReported March 19, 2026 · 2,303 vehicles affected

What is wrong: Terex South Dakota, Inc. (Terex) is recalling certain 2019-2026 General 65, General 80, General 95, C4000, C5000, and C6000 digger utility trucks equipped with pole guides. An insufficient weld on the plate weldment may crack, causing the retaining pin to separate.
Risk: Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
Remedy: Owners will inspect the plate weldment for any cracks or abnormal welds. Dealers or owners will replace the plate weldment as necessary, free of charge. Owner notification letters were mailed June 2, 2026. Owners may contact Terex's customer service at 1‑605‑882‑4000. Terex's number for this recall is SN737.

Recall number 26V167000 · Recall details

Equipment: mechanical: boom/crane/ladderReported December 2, 2022 · 431 vehicles affected

What is wrong: Terex South Dakota, Inc. (Terex) is recalling certain 2022 C4000, C5000, C6000, C7000, General, and Trans TL vehicles. A seam in the boom structure may have been improperly welded, causing the weld to crack.
Risk: A cracked weld may lead to the boom failing, increasing the risk of an injury.
Remedy: Dealers will replace or repair the boom, free of charge. Owner notification letters were mailed on February 8, 2023. Owners may contact Terex's customer service at 1‑605‑882‑4000. Terex's number for this recall is SN715.

Recall number 22V893000 · Recall details

EquipmentReported August 7, 2018 · 101 vehicles affected

What is wrong: Terex south Dakota, Inc. (Terex) is recalling certain 2015-2018 Terex C4000, C5000, C6000, and General digger derricks. The welds between the coupler and hex shaft may be undersized, causing them to fail and the auger to fall unexpectedly.
Risk: If the auger falls, it can increase the risk of injury to the user or bystanders.
Remedy: Terex will notify owners, and dealers will either repair the weld or replace the affected component, free of charge. The recall began October 3, 2018. Owners may contact Terex customer service at 1‑605‑882‑4000. Terex's number for this recall is SN665.

Recall number 18V520000 · Recall details

Suspension: front: springs: air suspension: springs/bagsReported March 16, 2016 · 131 vehicles affected

What is wrong: Terex South Dakota, Inc. (Terex) is recalling certain model year 2015-2016 C5000, C6000, General 80, RMX, TM100, and TM125 aerial devices, and digger derrick lifts installed on trucks manufactured August 4, 2015, to February 16, 2016. The suspension circuit can inflate the suspension air bags on the affected vehicles if the Master/PTO switch or ignition is turned off in the cab while the boom is in the raised position. This can cause the frame to rise, lifting the outriggers from the ground.
Risk: If the outrigger lifts off the ground, causing instability of the truck, it can increase the risk of injury to the operator.
Remedy: Terex will notify owners, and dealers will install a second outrigger enable relay, free of charge. The recall began on April 29, 2016. Owners may contact Terex customer service at 1‑800‑982‑8975. Terex's number for this recall is SN636.

Recall number 16V154000 · Recall details

EquipmentReported May 4, 2009 · 142 vehicles affected

What is wrong: Terex telelect, inc. Is recalling 142 my 2008 c4000, c5000, c6000, c7000, and general digger derrick utility trucks manufactured between september 11 and december 20, 2008, equipped with eaton 25vq hydraulic pumps. Poor adhesion of the bronze material and the steel surface of the flex plate used in the 25vq section may lead to delamination of the bronze from the plate.
Risk: Failure of the pump will make the unit inoperable and possibly leave the operator or load suspended which could result in personal injury or death.
Remedy: Terex will notify owners and repair the vehicles free of charge. The recall began on july 31, 2009. Owners may contact terex utilities warranty department at 1‑605‑884‑3892.

Recall number 09V149000 · Recall details

Questions about the Terex C6000 recalls

How do I check if my Terex C6000 has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the Terex C6000 have?

7, covering trailer hitches, equipment and suspension.

VIN decoder

See the problems and recalls for an exact car

Buying a used Terex C6000?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history