2008 Tesla Roadster technical service bulletins

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

• Jun 11, 2014 Service bulletinTesla: the high voltage interlock loop (HVIL) diagnostic guide
• Jun 5, 2013 Service bulletinTesla: when removing the battery pack these procedures need to be followed in order to ensure proper...
• Jun 5, 2013 Service bulletinTesla: due to isolation of model s high voltage, a monitor is installed in battery to ensure no electrical...
• Jan 27, 2012 Service bulletinTesla motors: during the shipment of battery pack sheets, residual coolant may leak effecting shipping...
• Nov 22, 2011 Service bulletinTesla: during normal operation of vehicle, aps cable grommet CAN become dislodged
• Nov 22, 2011 Service bulletinTesla: information regarding the motor and pem fans where certain types of weather conditions, such as...
• Nov 22, 2011 Service bulletinTesla: information provided in regards to assembling a new sealed bearing dual pem/motor fan that is...
• Jul 25, 2011 Service bulletinTesla motors: roadster 2010-2011
• Aug 18, 2010 Service bulletinTesla: there are revised torque specifications for the bolts on the battery pack cover
• Dec 22, 2009 Service bulletinTesla: floor mats were not anchored to the floor
• Oct 15, 2009 Service bulletinTesla: inspection, prevention and repair of battery pack water ingress from the aps grommet
• Jul 24, 2009 Service bulletinTesla: different transmission fill procedure for transmissions with low fill plug levels
• Jun 5, 2009 Service bulletinTesla: upgrade for all vehicles equipped with 1.5 power trains.
• Jun 2, 2009 Service bulletinTesla motors: transmission vent retrofit
• May 28, 2009 Service bulletinTesla: some vehicles have been identified where the rear hub flange bolts have been undertorqued
• Apr 8, 2009 Service bulletinTesla: front/rear hub upright assembly
• Apr 8, 2009 Service bulletinTesla: potential no start condition or failed heater operation due to faulty components in ptc heater board
• Feb 20, 2009 Service bulletinTesla: leak point around door hinge
• Dec 22, 2008 Service bulletinTesla: bent pins on the compressor controller connector of HVAC 400V controller
• Dec 16, 2008 Service bulletinTesla: water ingress inspection
• Oct 15, 2008 Service bulletinTesla vehicle: isolation failures inside HVAC heater module
• Jun 13, 2008 Service bulletinTesla vehicle: incorrect bonding process may cause some painted charge doors to separate from mounting plate.
• May 28, 2008 Service bulletinTesla vehicle: bulkhead grommet dislodged
• May 14, 2008 Service bulletinTesla vehicle: tolerances to 14 pin connector on the TCM could cause a faulty connection and water ingress.