2005 Thomas MVP Ef problems

What is wrong

Daimler trucks is recalling 243,435 my 1995-2008 thomas built school buses manufactured between january 1994, and march 10, 2008. (additional buses have been added to this recall campaign. Please see supplemental report no. 4) the emergency exit door handle begins corroding around the securing roll pin and square drive mechanism causing the protective finish to chip and flake. Continued corrosion and pitting weakens the handle. Handles weakened by corrosion may break while trying to open the door from the exterior.

Risk

In the event of an emergency, a person on the outside of the bus may break the door handle trying to open the emergency exit potentially delaying evacuation and increasing the risk of personal injury to the vehicle's occupants.

Remedy

Daimler trucks will notify owners and will replace the handles with a more robust handle free of charge. Repairs will be performed by thomas built buses dealerships. The recall began on august 18, 2008, and notification for the revised population is expected to begin on or about april 29, 2009. Owners may contact thomas built at 336‑889‑4871.

Recall number 08V087000 · Recall details

What is wrong

Certain 2001 through 2008 thomas built fs-56, er, mvp er, hdx, and mvp ef school buses manufactured from october 23, 2000, through january 24, 2006, equipped with tyco pc board and type ii auto reset circuit breakers. Type ii auto reset circuit breaker temperatures may exceed the rating of the tyco pc board causing the boards to melt potentially resulting in a vehicle fire.

Risk

A vehicle fire can occur possibly resulting in a crash.

Remedy

Thomas built will notify owners and repair the buses by replacing the type ii auto reset circuit breakers with manual circuit breakers, and the jumper cable. The recall began on march 28, 2008. Owners may contact thomas built customer support office at 336‑889‑4871.

Recall number 07V544000 · Recall details

What is wrong

Certain 2004 and 2005 freightliner van, motor home, shuttle bus, and school bus chassis manufactured between january 2004 and may 2005. Erratic voltage supply to the fuel lift pump causes premature wear of the pump. This premature wear could result in fuel lift pump failure and in some cases may cause an engine stall condition.

Risk

Should the engine stall, a vehicle crash could occur.

Remedy

Cummins will notify the owners of the freightliner and thomas built vehicles and will repair the engines by emc recalibration and replacement of the fuel lift pump at no charge to the customer. Owners may contact cummins assistance center 1-800-diesels (1‑800‑343‑7357) or freightliner at 1‑800‑547‑0712.

Recall number 05V469000 · Recall details

What is wrong

Certain 2002-2005 my thomas built minotour, conventional, mvp-er, er, hdx, and mvp-ef model school buses manufactured between january 8, 2002, and march 8, 2005, equipped with specialty mfg "5" series stop arms originally sold in or currently registered in states other than the following states: alaska, colorado, connecticut, delaware, idaho, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, montana, nebraska, nevada, new hampshire, new jersey, new mexico, new york, north dakota, ohio, oregon, pennsylvania, rhode island, south dakota, tennessee, utah, vermont, virginia, washington, west virginia, wisconsin, wyoming, and the district of columbia. In extremely cold weather, the microswitches used internally to position the stop arm sign in the open and closed positions may malfunction, causing the sign to open or close in an improper position, or to not open at all.

Risk

Should the stop arm not perform properly, a child or pedestrian may be endangered by passing vehicles should the motorist not stop at the correct location.

Remedy

For those buses operated in or near any of the states listed above, thomas built is encouraging the bus owners to obtain the replacement switch. For those buses operated in the warmer states, dealers will replace the switch upon owner request. For those customers who request the remedy, thomas built will replace the original switch with a switch pack that is not sensitive to extreme cold weather and will inspect to ensure the microswitch heater wiring is properly connected. The recall began on september 14, 2005. Owners may contact thomas built's customer support office at 336‑889‑4871.

Recall number 05V347000 · Recall details

What is wrong

Certain 2002-2005 my thomas built minotour, conventional, mvp-er, er, hdx, and mvp-ef model school buses manufactured between january 8, 2002, and march 8, 2005, equipped with specialty mfg "5" series stop arms originally sold in or currently registered in the following states: alaska, colorado, connecticut, delaware, idaho, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, montana, nebraska, nevada, new hampshire, new jersey, new mexico, new york, north dakota, ohio, oregon, pennsylvania, rhode island, south dakota, tennessee, utah, vermont, virginia, washington, west virginia, wisconsin, wyoming, and the district of columbia. In extremely cold weather, the microswitches used internally to position the stop arm sign in the open and closed positions may malfunction, causing the sign to open or close in an improper position, or to not open at all.

Risk

Should the stop arm not perform properly, a child or pedestrian may be endangered by passing vehicles should the motorist not stop at the correct location.

Remedy

Thomas built will notify its owners and replace the original switch with a switch pack that is not sensitive to extreme cold weather and will inspect to ensure the microswitch heater wiring is properly connected free of charge. The recall began on september 14, 2005. Owners may contact thomas built's customer support office at 336‑889‑4871.

Recall number 05V340000 · Recall details

The office of defects investigation opened this preliminary evaluationafterbecoming aware that fleets were having handle failures on the rear emergency door exit.the failure resulted in the door handle separating from thedoor latch mechanism.when the handle fails, the rear emergency exit door can not be opened from outside the bus.the failure results from corrosion of the exterior door handle around the securing roll pin and square drive latch mechanism, causing the protective finish to chip and flake.continued corrosion weakens the handle and eventually the handle may break while trying to open the exit door.odi was concerned that during an emergency, a person outside of the bus would break the door handle while trying to open the emergency exit door,potentially delaying evacuation of the bus.under the safety recall, the aluminum handles will be replaced with a more robust handle.the recall action resolves the issues raised by this investigation. Accordingly, this investigation is closed.

PE07054