Altec discovered that one of the fasteners used to attach the rear shear plate on the subbase of the unit...
Altec technical service bulletin SIL 728 for 2013 Altec AT37-G and 2013 Altec AT40-G.
- Bulletin number
- SIL 728
- Component
- Equipment adaptive/mobility
- Summary
- Altec discovered that one of the fasteners used to attach the rear shear plate on the subbase of the unit to the chassis can contact the chassis u-bolt. The fastener can be a huck bolt or a bolt and nut. Movement of the u-bolt can possibly cause damage to the huck bolt or bolt and nut resulting in the fastener being broken off. Altec requires the customer to perform an inspection of rear shear plate on the subbase to determine if huck bolts or bolts and nuts were installed. This inspection should be completed no later than 90 days after the receipt of this SIL. Use the inspection Procedure beginning on Page 2. If huck bolts are present, contact Altec to perform the repair, or send the vehicle to local service center.
Vehicles covered
- Altec AT37-G 2013 2013
- Altec AT40-G 2013 2013
VIN decoder
See the problems and recalls for an exact car
Buying a used Altec AT37-G?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history