The worst 2015 Victory Vision Tour Abs problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 1
Power train: manual transmission
- What is wrong
- Polaris Industries, Inc. (Polaris) is recalling certain model year 2015 Victory Cross Country, Cross Country Eightball, Cross Country Tour, Gunner, Hammer Eightball, High-Ball, Magnum, Vision Tour ABS and Vegas Eightball motorcycles manufactured August 11, 2014, to September 2, 2014. The affected motorcycles may have been manufactured with the transmission shift drum detent roller spring incorrectly installed.
- Risk
- If the roller spring is incorrectly installed, the transmission may not shift as intended, potentially causing the operator to lose control, increasing the risk of a crash.
- Remedy
- Polaris has notified owners, and dealers will inspect and repair the transmission, free of charge. The recall began on October 9, 2014. Owners may contact Polaris customer service at 1‑888‑704‑5290. Polaris' number for this recall is V-14-03 A/B.
Recall number 14V596000 · Recall details
See all 1 recalls for the 2015 Victory Vision Tour Abs
Defect investigations
Motorcycle steering lockup
This Preliminary Evaluation (PE14006) was opened after the federal safety agency became aware of alleged steering lockup involving Victory Vision motorcycles built by Polaris Industries, Inc. (Polaris).This issue has been the subject of numerous online forum posts by the filer of VOQ 10534733.Both the VOQs and forum posts (from all sources) formed the foundation of our investigation. The subject motorcycles are equipped with a two-piece, plastic, front fender.The back half (the all-black portion in the photo below) is secured to the fork with a single fastener on each side.It is secured to the front half of the fender with two plastic pushpins.The back half of the subject 2-piece fender is alleged to cause steering lockup when it partially separates and becomes wedged in the lower faring.We have expanded the PE's original scope to include the MY2014 and 2015 Visions because (1) these bikes came on-line after we opened this investigation and (2) the subject fender remains unchanged.Since its introduction in May, 2007, Polaris has produced 7,337 Visions (and trim derivatives).In the 8 years since, we are aware of 35 incidents of partial fender separation wherein the fender wedged in the lower fairing opening.None of the incidents involved a crash.During testing, with the fender both wedged in the lower fairing and with it pinned in the seam joining the right and left lower fairing halves, we noted a ?notchy? steering feel but no steering lock-up.At no time was steering control lost in either circumstance (wedged and/or pinned).When the front forks were rotated at angles greater than 10 degrees, and vehicle speed was, by necessity, below 10mph we noted an increase in steering effort that was easily manageable.This is consistent with the results of Polaris? testing where steering effort increased at steering angles beyond ten degrees.Such steering angles were only reasonably obtainable at speeds below ten mph.Polaris concluded that a fender separation of the type owners allege, does not represent an unreasonable risk to motor vehicle safety, but does compromise owner satisfaction.Consequently, on April 28, 2015, Polaris advised the agency that it decided to undertake a consumer satisfaction campaign to improve fender durability on all MY 2008-15 Victory Vision motorcycles regardless of mileage, time in service, or ownership status.Owners will receive notification of this campaign by June 20, 2015.A copy of Polaris' April 28, 2015 letter to us about this program is in the public file for this PE.In light of the low risk to motor vehicle safety as a result of displaced fenders, and Polaris?s actions to reduce the likelihood of fender interference through a consumer satisfaction campaign, further use of agency resources does not appear to be warranted.The closing of this investigation does not constitute a finding by the federal safety agency that no safety-related defect exists.The agency reserves the right to take further action if warranted by the circumstances.For additional detailed information on this investigation, see the attached closing report.The ODI complaints cited above can be reviewed at www-odi.the federal safety agency.dot.gov/owners/Searchreference under the following (ODI) numbers: 10534913, 10535066, 10430546, 10469285, 10468997, 10592181, 10585428, 10534743, 10597031, 10535938, 10594160, 10594161, 10606364
PE14006
Technical service bulletins for the 2015 Victory Vision Tour Abs 7
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- A stop ride means the consumer must not operate their vehicle until the repair is complete.
- Electrical system
- This Team Tip is being released to dealers to provide information regarding the required transition to...
- This Voice of Victory has been released to clearly define Victory Motorcycle’s expectations when filing a...
- Victory mc: TSB has an owner notification letter
- Victory mc: at time of manufactured, detent arm return spring of the shift ratchet assemblies, was...
Compare the 2015 Victory Vision Tour Abs
Other model years
Questions about the 2015 Victory Vision Tour Abs
Is the 2015 Victory Vision Tour Abs reliable?
Owners have filed 0 complaints about the 2015 Victory Vision Tour Abs.
What is the most common problem with the 2015 Victory Vision Tour Abs?
There are not enough complaints to tell.
How many recalls does the 2015 Victory Vision Tour Abs have?
1 recall, covering power train.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 Victory Vision Tour Abs?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history