2025 Volkswagen ID.4 technical service bulletins
161 technical service bulletins and manufacturer communications cover the 2025 Volkswagen ID.4.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Water Migration under RAPGARD® during PDI
- Condensation and or water droplets visible on inside of exterior light lenses
- Condensation
- Installation of the service parts listed in the table below requires an ID.S compound update.
- Do Not replace the Electric Drive Power and Control Electronics -JX1- before performing the update outlined in
- Installation of Battery Regulation Control Module -J840-, -SX7-, -SX8-.
- Additional Information for DC/DC Converter Replacement
- Another Bulletin, or Parts catalog notice leads to
- Safety Related Inquiry and Reporting
- Programming instruction.
- Steps to take if DTC P0AA500 (DA:008C)
- Heat Sensative Trouble Shooting Explanation.
- This special notice is to inform dealers to return the parts listed if it meets the criteria provided.
- Battery charger control unit software update
- Brake rotor resurfacing
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Diagnosis of low insulation resistance in the High-Voltage (HV) wiring.
- Battery Checking Procedure before replacement
- Warranty Alignment Worksheet
- Replacement instruction
- Checking Installation and calibration
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Subject: Get ready for your Over-the-Air software update
- Replace the rear Electric Drive Power and Control Electronics -JX1- with Three-Phase Current Drive -VX54-...
- Inquiries
- Difference between Component fluid leakage and seepage
- Update Programming of Seat Module
- Update Programming for Memory Seat Module
- Important Step when replacing Battery Cell Modules
- Replace Battery Regulation Control Module Kit -J840- / -SX7- / -SX8
- Condition is normal due to cold fresh air and humidity
- Moisture Accumulation
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Oil leak from Cylinder Head Cover;
- Customer reports that the vehicle performed an unwarranted Autonomous Emergency Braking (AEB).
- Diagnostic DTC's with symptom codes stored in Battery Regulation Control Module -J840
- Instruction for overly sensitive pinch protection.
- Reset Parameterization of door control module
- Flushing H.V. Battery before opening
- Determine H.V. Battery Health & Remaining Capacity
- Programming a new Information Electronics Module -J794
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Paint color and/or finish of the engine compartment may not match the exterior paint color
- The federal safety agency has issued an urgent warning regarding counterfeit replacement airbag inflators...
- Oil leak from Cylinder Head Cover;
- Guided Fault Finding Requirement for Component Replacement
- This special notice is to inform dealers to return the parts listed and only order the successor parts...
- Inspecting Cooling system for proper installation to prevent restrictions
- Oil leak from Cylinder Head Cover;
- The OUE7 code has been applied to vehicles that will be receiving an over-the-air update to software level...
- Email communication to customers who have consented to download SW 3.8.11 that the SW is ready to install...
- Clearing DTC B101C07
- DTC B203400
- Oil leak from Cylinder Head Cover;
- Assessment of Damage to steering wheel leather
- 12V BatteryTesting, Charging and Required Documents before replacement.
- How to handle a suspected paint flaw during PDI
- Oil leak from Cylinder Head Cover;
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Software Version Management
- High Voltage batter cannot be charged
- Battery Check Process before replacement
- How to perform Component Measurement Process
- Ready” mode cannot be established and High-volt
- Oil leak from Cylinder Head Cover;
- Diagnosis for Excessive Current Draw.
- Oil leak from Cylinder Head Cover;
- Alignment Submission Form
- H.V. Battery Hints, Tips & Suggested Practices
- Clears Codes & Adaption Drive Test Drive
- Vehicle Software (SW Level 5.4.3)
- Oil leak from Cylinder Head Cover;
- PDI Instruction
- A "How To" activate Car Net® 2.0
- Vehicle Software (SW Level 5.4.3)
- Warranty Instruction and guidance
- How to handle brake noise or pulsation during Perfect Delivery Inspection (PDI)
- Identify and resurfacing brake rotors.
- Alignment sheet submission.
- Oil leak from Cylinder Head Cover;
- Explanation of state-of-charge at the end/start
- Oil leak from Cylinder Head Cover;
- Oil leak from Cylinder Head Cover;
- Activation
- Rotary latch operation.
- Oil leak from Cylinder Head Cover;
- Oil leak from Cylinder Head Cover;
- Oil leak from Cylinder Head Cover;
- Oil leak from Cylinder Head Cover;
- How to identify and when to replace a leaking strut
- What to do if customer mentions water droplet within tail lights.
- Customer states MIL-on, P055F stored in ECM memory with message on cluster stating “please warm engine oil...
- Remote Key Battery Replacement
- Using Alignment Sheet Submission Form
- Disc Cleaning
- How to check for HVAC system leaks using nitrogen.
- Over all summary of HV Battery range
- Additional build status Information required when Replacing H.V. Battery Cell Modules
- Steps to perform when a
- Customer states MIL-on, P055F stored in ECM memory with message on cluster stating “please warm engine oil...
- Warranty brake rotor machining is allowed between 6 and 12 months or 6,000 and 12,000 miles
- HV Battery Checking Remaining Capacity and Determination of HV Battery Health
- Irrelevant Trouble Codes stored in HV Battery Charger Control Module.
- Improper installation
- A/C System Flusing Instruction
- Pending diagnostic improvement in the control unit for the High-Voltage Charger -AX4- (diagnostic address...
- Brake Repair or Replacement Information
- Determining HV-Battery Health, Remaining Capacity
- What to do if accessory pack is missing, incorrect or damaged during Perfect Delivery Inptection.
- Identifying and Mixing Engine Coolant
- CV Boot replacement
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Water migration under the RAPGARD® protection when vehicle arrives at dealership.
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- This is a notice for software changes with the ODIS diagnostic program to correct the communication during...
- Capacitive Discharge Instruction.
- Replacing cretain control modules will require specific Guided Fault Finding (GFF) direction.
- Cleaning the refrigeration Circuit R1234YF
- Internal Moisture Accumulation
- This is a notice for software changes with the ODIS diagnostic program to correct the communication for...
- Half of the VW emblem, light strip in the grill, and the daytime running lights will no longer be...
- Moisture witin rear tail lamp assembly
- HVAC duct cleaning and deodorizing
- Additional reporting
- Vehicle Concerns Before Recall Repair Available
- 12V battery testing instruction
- Inspecting sensors for damage
- The purpose of this Technical Bulletin is to inform Volkswagen dealerships that beginning on 10/1/2024,...
- How to manage software versions using VW diagnostic Tool
- Wind & Water Leak Checking
- Battery Health, Remaining Capacity
- Battery testing
- Airbag / Pyrotechnic Safety Belt Deployment Inquiries, update to contact information due to retirement.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2025 Volkswagen ID.4?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history