2000 Volvo WX problems

What is wrong

On certain heavy-duty class 8 vehicles, the body builder wiring option was mis-wired in such a way that the auto neutral with service brake status option may allow the transmission to go into forward gear without the driver's foot pressing down on the brake pedal first.

Risk

Unintended movement of the vehicle could put persons in danger inside and outside the vehicle.

Remedy

Volvo trucks will notify its customers and install an additional air operated stop light switch and the necessary wiring changes. Owner notification is expected to begin during september 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact at 1‑800‑528‑6586.

Recall number 03V308000 · Recall details

What is wrong

On some heavy duty class 8 vehicles equipped with arvinmeritor axle assemblies which may have been manufactured with trw model 20edl ball sockets, the tie rod ball-socket bearings have a below specification case depth and/or hardness which can lead to premature wear out of the socket in some applications.

Risk

If this condition occurs, the driver can lose steering control, possibly resulting in a vehicle crash.

Remedy

Dealers will replace the ball socket assemblies. This campaign supersedes the federal safety agency campaign nos. 01v‑139.001 and 02v‑037.002. Owner notification began july 25, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact volvo trucks at 1‑800‑528‑6586.

Recall number 02V037005 · Recall details

What is wrong

Vehicle description: heavy duty 6x4 trucks equipped with chalmers 800 series suspension kits. These suspension kits may have insufficient penetration of the weld attaching the torque rod eye to the torque rod tube.

Risk

Failure of the weld could result in separation of the eye and tube, causing a lock of axle retention, which could result in loss of vehicle control.

Remedy

Dealers will replace all chalmers fixed torque rods on these vehicles. Chalmers is conducting the owner notification and remedy for this campaign. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chalmers at 1‑905‑624‑9750.

Recall number 01V167004 · Recall details

What is wrong

Vehicle description: heavy duty trucks equipped with accuride 22.5 x 8.25 15 tubeless demountable rims, part no. 32051. Certain rims contain a non-fusion area in the butt-weld of the mounting ring. Under certain circumstances, the defect could develop into a crack on the mounting ring.

Risk

Over time, the crack could propagate and if not heeded, could result in mounting ring failure, potentially causing the rim to separate from the vehicle.

Remedy

Accuride will inspect and replace the defective or suspect wheel rims.

Recall number 00V190002 · Recall details

What is wrong

Vehicle description: heavy duty trucks built with bendix air ABS with an ec-17 1030r electronic control unit (ecu), there have been reports of unwanted ABS activation at low speeds caused by 1) chafed ABS wheel speed sensor wires on rotating parts or 2) a damaged component at the wheel end that generates a certain type of erratic sensor signal.

Risk

This condition could cause the ABS ecu to exhaust the air at the air brake modulators for one or more of the wheels. This could result in extended braking distances and a possible crash.

Remedy

Dealers will replace the ABS ecu.

Recall number 00V232003 · Recall details