Check a VIN

1990 Western Star Conventional recalls

There are 7 safety recalls on record for the 1990 Western Star Conventional, covering 18,274 vehicles in total across all the models in each campaign. Newest first.

All recalls

Engine and engine cooling: exhaust system: manifold/header/muffler/tail pipeReported January 5, 1996 · 21 vehicles affected
What is wrong
These heavy trucks were equipped with exhaust mufflers without heat shielding.
Risk
Someone working behind the cab could contact the hot muffler causing personal injury. Also some of these vehicles were equipped with deck plates with no grab handles for access.
Remedy
Dealers will install muffler shields and, where necessary, grab handles.

Recall number 96V022000 · Recall details

Service brakes, hydraulic: foundation components: drumReported February 22, 1995 · 48 vehicles affected
What is wrong
The brake return springs on the front brakes can contact the front hubs as the brake pads and drums wear, resulting in spring failure. A piece of the failed spring can lodge in the brake cam causing the brake to drag and the steering to pull to one side.
Risk
Steering pull from the dragging brake can increase the potential for a vehicle crash.
Remedy
Dealers will replace the front hubs on the affected vehicles.

Recall number 95V034000 · Recall details

Equipment: recreational vehicle/trailerReported January 1, 1995 · 122 vehicles affected
What is wrong
Straps holding the sleeper upper bunk in the raised position can release without warning.
Risk
If the restraining strap releases suddenly, thebunk falls without warning and can strike an occupant sitting in the lower bunk causing personal injury.
Remedy
Dealers will replace the upper bunk retaining straps with an improved automotive safety belt style design strap.

Recall number 95V014000 · Recall details

Suspension: front: springs: coil springsReported November 9, 1994 · 1,690 vehicles affected
What is wrong
The aluminum rear spring shackle brackets have developed cracks which can lead to separation of the brackets from the frame rail.
Risk
The suspension can drop down on one side, causing a reduction of steering control which could result in an accident.
Remedy
Dealers will replace the spring brackets.

Recall number 94V221000 · Recall details

StructureReported December 7, 1993 · 5,304 vehicles affected
What is wrong
The cab access grab handles have thinner than specified wall thickness and are susceptible to fatigue failure breaking at the bend radius near the upper mounting bolt hole.
Risk
Failure during use of the grab handles can cause auser to fall resulting in personal injury.
Remedy
Western star dealers will remove and destroy the recalled grab handles. New handles will be installed on these vehicles.

Recall number 93V207000 · Recall details

Power train: clutch assembly: pedal/hand lever(motorcycle)Reported October 8, 1992 · 10,893 vehicles affected
What is wrong
Premature failure of the aluminum clutch release lever can occur from stress corrosion due to continuous loading of the lever and exposure to road salt spray.
Risk
If the failure occurs during vehicle operation, theclutch is rendered inoperative and the vehicle operator cannot control thevehicle speed by up-shifting or down-shifting, which may result in loss ofvehicle control.
Remedy
Replace the aluminum lever with an iron lever.

Recall number 92V143000 · Recall details

Electrical system: 12v/24v/48v battery: cablesReported December 6, 1990 · 196 vehicles affected
What is wrong
When brake air lines and battery electrical cables are routed through the angle brackets on the frame rails, the leaf spring may rub against the battery cables or air lines, causing fraying and eventually rupture.
Risk
If the battery cables are sufficiently frayed, the cablesmay cause a short circuit and result in a fire. If the brake air lines areruptured or punctured, severely decreased braking ability may ensue.
Remedy
Reroute battery and air line hoses away from the rear transmission support spring.

Recall number 90V200000 · Recall details

Questions about the 1990 Western Star Conventional recalls

How do I check if my 1990 Western Star Conventional has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the 1990 Western Star Conventional have?

7, covering engine and engine cooling, service brakes, hydraulic and equipment.

VIN decoder

See the problems and recalls for an exact car

Buying a used 1990 Western Star Conventional?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history