Check a VIN

Workhorse W20 recalls

There are 5 safety recalls on record for the Workhorse W20, covering 98,338 vehicles in total across all the models in each campaign. Newest first.

Workhorse W20 recalls by model year

2008 12007 12006 22005 22004 22003 12002 22001 32000 1

All recalls

Service brakes, hydraulicReported April 3, 2009 · 48,876 vehicles affected
What is wrong
Navistar is recalling certain model year my 2001-2008 workhorse w20, w21 and w22 chassis and certain model year 2009 through 2011 monaco rv admiral, arista, monarch, and riptide recreational vehicles equipped with axles that include bosch zops or zoht pin slide hydraulic disc brakes. When combined with occasional or seasonal vehicle operation may experience calipers sticking in the applied position. This can result in abnormal heat generation at the wheel end causing brake drag. The driver would normally have warning of the brake drag if undetected by the driver.
Risk
The temperature increase at the wheel end can eventually lead to soft pedal conditions due to brake fluid boil, and possible extended stopping distance increasing the risk of a crash.
Remedy
Workhorse dealers will replace all four bosch brake caliper assemblies free of charge. The safety recall began on september 16, 2010. Owners may contact workhorse at 1‑877‑246‑7731.

Recall number 09V110000 · Recall details

Engine and engine coolingReported June 20, 2006 · 30,335 vehicles affected
What is wrong
On certain motor home and truck chassis equipped with general motors 8.1l v8 engines, improper hardening during the heat treatment process can cause the fuel rail pulse damper retainer clip to fracture, resulting in inadequate retention of the damper. If the damper becomes loose, fuel could be pumped by the fuel pump into the under hood area.
Risk
In the presence of an ignition source, a fire could result.
Remedy
Dealers will replace the fuel rail pulse damper retainer clips on these engines free of charge. The recall began on september 1, 2006. Owners may contact workhorse at 877‑294‑6773.

Recall number 06V225000 · Recall details

SteeringReported May 2, 2006 · 3,881 vehicles affected
What is wrong
Certain chassis may have been equipped with incorrect steering intermediate shafts. The spline can strip while the steering wheel is being turned.
Risk
This steering condition could increase the risk of a crash.
Remedy
Dealers will inspect and, if necessary, replace the steering intermediate shafts. The recall began on may 22, 2006. Owners may contact workhorse at 1‑877‑294‑6773.

Recall number 06V148000 · Recall details

Service brakes, hydraulicReported February 18, 2004 · 10,235 vehicles affected
What is wrong
On certain motorhome chassis equipped with bosch zops, the pads can drag on the rotor surface due to the pin slide.
Risk
A hang up or lock up may cause the calipers to over heat and not allow the driver to stop safely. This could cause overheating of the brake calipers which could result in a vehicle fire.
Remedy
Dealers will inspect, repair and replace according to the procedure developed by bosch (see campaign 03e064000). The recall began on august 1, 2004. Owners should contact workhorse at 1‑877‑294‑6773.

Recall number 04V084000 · Recall details

Suspension: rear: springs: leaf spring assembly: u-bolt, leaf spring to axleReported October 4, 2001 · 5,011 vehicles affected
What is wrong
Vehicle description: motor home and commercial chassis. The rear axle u-bolts may not be tightened correctly due to random failure of production tooling in the specified time span.
Risk
Low u-bolt torque can result in u-bolts coming loose and not properly retaining the rear axle to the vehicle, resulting in a loss of vehicle control.
Remedy
Dealers will tighten the rear axle u-bolts. Owner notification is expected to begin october 10, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact workhorse at 1‑877‑946‑7731.

Recall number 01V317000 · Recall details

Questions about the Workhorse W20 recalls

How do I check if my Workhorse W20 has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the Workhorse W20 have?

5, covering service brakes, hydraulic, engine and engine cooling and steering.

VIN decoder

See the problems and recalls for an exact car

Buying a used Workhorse W20?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history