Ground spider failure. 2006 fjr1300 with 30,880 miles on the clock, bought it used from a local honda dealer on 4/8/10. Started noticing weird hiccups less than a month after I bought it. I first started to notice problems on the way home from deals gap, nc while sitting in 98 degree rush hour louisville traffic. Bike died on me: turn signal indicators lit up, gas gauge flashed, windshield stayed put, no headlight or taillight, no starter button, no fans, no horn. Pushed bike to side of road and fiddled with it for a few minutes, thinking it had just overheated. After a few minutes of sitting around, it fired right up. This pattern happened to me everyday for about a month. Decided to take it to the dealer when the bike died on me in a low speed, pucker-inducing turn with my fiancee on the back. Dealer spent 7 hours of labor to diagnose the problem. Had the choice of replacing the entire wiring harness ($$$$) or changing and rewiring the grounding block for free. I chose option #2. Thank you dreyer honda for paying dreyer yamaha's labor to correct this issue! It is a real safety hazard that should definitely be a recall from yamaha. As a result of this issue, I was stranded in traffic 8 times, dead on the side of the road twice, and nearly wrecked in a turn with a passenger due to the power cutting out.
2006 Yamaha FJR1300A electrical complaints
Page 2 of 2: complaints 11 to 39 of 39, newest first, as owners wrote them.
This failure occurred on a 2006 yamaha fjr1300a model. After riding motorcycle for a couple of hours I stopped for a meal break. When I tried to start motorcycle it would not restart. Instruments were flashing indicating an electrical error. Motorcycle needed to be trailer home. Upon inspection by an authorized yamaha dealer it was found to have an overheated, melting, ground junction in the main wiring harness. Yamaha corp. Authorized a replacement of the main wiring harness under my extended warranty. If this had occurred while the motorcycle was under power the engine would have shut down potentially causing injury or death.
Yamaha fjr motorcycle. Motorcycle engine will not crank or start. Problem was found to be a defective electrical ground splice located near the left front upper corner of the engine. Inspection revealed the electrical ground, group splice had overheated and burnt with associated burnt wires. This motorcycle has several of these types of electrical ground splices and there have been internet reports of many failures, not all of them the same splice I had a problem with. The potential danger is an engine stall out and or numerous electrical failures at once. The other potential danger is of an electrical fire under the gas tank due to the melted and burnt wires associated with this failure.
Making a right hand turn on my 2006 yamaha fjr -1300a and the bike died while in mid turn. The start button would not work, the lights were on, even though the key was turned off. When the ignition switch was turned on, the gauges were erratic. I took the bike apart on the side of the road to try and locate the problem. I found a burned grounding connector. Apparently yamaha feeds 5 18 gauge wires into a connector with one 18 gauge wire coming out to ground. There are six or seven connections like this in the wiring harness. Cleaning the connections was a temporary fix to get me home. I am now looking for a better fix that will be permanent. Had this happened at speed in the mountains, the results could have been much worse.
Failure of grounding coupler (spider) causing loss of all power while motorcycle is in motion. Failure caused by environmental (rain, dirt, etc) factors entering the coupler and causing corrosion and failure to conduct electrical ground. Motorcycle is disabled until coupler is repaired or wiring harness is replaced.
2006 yamaha fjr 1300 a. Wire connection near fuel tank corroded and was melting. Headlamps quit, along with horn, turn signals. Engine would miss with the turn signal switch in the left or right position. I was in the dark, when the lights quit. I have heard of other fjr 1300 owners with the same problem.
Started motorcycle. Wife and I exited our driveway onto road. Traveled several hundred feet down the road. Complete loss of power while underway due to an ignition switch failure. Luckily no injuries. Temporarily bypassed (hot wired) ignition switch.
Sudden failure of ignition switch caused motorcycle to stop running. The failure kills all electrical aspects of bike. Have to coast to side of road.
1. 2006 yamaha fjr1300a, while riding the bike turned off completely as if the battery was disconnected, bike stalled and fell over. 2.occurred once, bike would not restart, had to get truck and trailer to pick me up and took to dealer. 3.new ignition switch and harness was put on it.
The ignition switch on my 2006 fjr1300 is defective. It will peridodically not turn on the electrical system to start the motorcycle. Many other people have this same problem on the fjr forum.
I went to start my motorcycle in the garage and it had no power. I am an ase certified master technician. I traced the problem to a failure of the ignition switch. I disassembled the switch and found that the solder joint on one of the power wires had melted, and there was heat damage to the contacts inside the switch. I re-soldered the wires, cleaned the contacts, and reassembled the switch. I am still using this switch, but I suspect it may fail again due to the number of other failures that have been occurring lately, as listed on fjrforum.com.
2006 yamaha fjr1300 motorcycle. 11300 miles on it. Traveling on road at 50 MPH. Abruptly there was a total shut down of motor and electrics. This is a well known and documented failure published on the fjr forum. The solder joint holding the brown ignition wire to the board in the switch comes free and it is same as turning the switch off. This would be and maybe has been a deadly situation if it were to happen in traffic. With the surprise when it happens and the dead motor causing the bike to slow very quickly could cause a rear end collision. On a motorcycle that ant good. A factory recall is urgently needed to replace these switches with a updated one. A new switch will be ordered by dealer but will it do the same thing? Will I be this lucky again?
06 yamaha fjr 1300 ignition failure, while parked,no accident . Then bike started. Has repeated failure several times over last few days.. Bike in yamaha shop now being checked. Bike has appox.16,800 miles on it.
2006 yamaha fjra. Turned key on, nothing. After reading the comments on ignition failure, called aaa to have my '06fjra towed to the yamaha dealer. The yamaha dealers service manager checked on ignition and was told "there's none in the country". He had no idea how long it would take to get the part. Indicated that this is a widespread problem with all years of the fjr.
Lost all electrical power to the motorcycle as I was accelerating up a hill with a car directly behind me causing an extremely unsafe situation. Problem was diagnosed as an ignition switch failure by north country powersports in rangely maine.
1.during a cross country road trip, ignition switch failed after refueling motorcycle. 2.first time, stranded 1200 miles from home. 3.bike towed by towing service to dealer 50 miles away. By passed switch, installed toggle switches, toggle switch failed on last day of trip while traveling down interstate highway. Remove switch, twisted wires together and came on home.
Ignition switch failure on 2006 yamaha fjr1300 motorcycle. Mine failed while parked, but others on the fjr forum failed while riding causing immediate engine cut off. Dealer replace the ignition switch at my cost. See http://www.fjrforum.com/forum//index.php?showtopic=26098.
While on cross country motorcycle trip, the ignition switch failed causing the vehicle to lose all power. Had this occurred in traffic (which it has on other's bikes) it could have been catastrophic. It only failed once, and remained broken. Roadside repair required hot wiring the bike and bypassing the failed ignition switch.
Total failure of the ignition switch while in traffic. Had just turned left onto a highway and the bike just shut down. I was lucky that I could get to the side of the road right away. This could have been bad with a different mix of traffic. I had no warning at all that anything was wrong.
Tl*the contact owns a 2006 yamaha fjr 1300. He stated that there was an electrical failure with the motorcycle. The ignition switch (main switch) brown wire was improperly manufactured. The contact is a former bike mechanic and replaced the ignition switch. The failure mileage was 34,450 and current mileage is 39,020. Updated 09/10/08 *bf updated 09/15/09
My motorcycle is a 2006 yamaha fjr1300a with 19924 miles at the time the ignition switch failed in enterprise nevada. I tried to start the bike and no power. Fuses all good. No prior indication of failure. By putting the key between 'off' and 'on' I sometimes got power and the bike would start. I had no cell service. Nearest next store/help was 92 miles. No tow service available. Fearful the bike would have suddenly quit if the key was jiggled by a road bump prior to or after my temporary repair. I duct taped the key in position to minimize the chance of crash or injury.
The ignition on my 2006 yamaha fjr1300 keeps failing when I try to start it. I have taken it to a dealership who stated that the battery posts were loose. After getting it back the same problem keeps occurring. When I turn the key the gauges sweep and there is a brief moment where the gauges light up then it all goes dead. I can move the wires and wiggle the key to get it started but if I move either of those after I start the bike it dies. This is an ongoing problem.
Ignition switch failure (soldered wire fell off). Happened in slow speed maneuver. I cut the ignition wire and put in a temporary switch. If this had happened on the highway...
No special events leading to the failure of my ignition switch. Complete loss of power on the motorcycle. I believe there is ample opportunity for loss of life with this problem. Will talk to the dealer about a fix.
My motorcycle(2006 yamaha fjr 1300) just had a total electrical failure while taking a slow right turn. Turns out the wiring was pulled so tight to the ignition the wire coming off the battery was pulled loose from the igniton. On the fjr owners website others complained about this problem as well.
2006 yamaha fjr1300 motorcycle. Sudden complete shut down of electrical system. Problem caused by wires detaching from ignition switch. Wires too tight from factory and were cold soldered with very weak connection. Can you imagine powering up to overtake a vehicle and you have a sudden without warning complete loss of power,a very dangerous senario
Stopped for fuel and stopped engine, after fueling turned ignition switch to on position, dasn lights and display did not come on, starter motor would not work.
Ignition switch failure on 2006 yamaha motorcycle model number fjr 1300a resulted in sudden loss of power in a corner and stranded in death valley, nevada. Four wires enter the switch housing. One of the two large wires pulled completely out of the switch, with the brass switch contact still soldered/crimped on the end. This failure *appears* to be the result of the wiring harness being stretched too tight during the assembly process. The wires going into the switch have no slack, they are 'banjo string tight'.
Turning the ignition key failed to turn on the power. Unable to start motorcycle. Due to location at time of failure (no cell or public phone readily available) almost had to leave motorcycle in this remote location. Was able to 'jiggle' the key and finally get power to start. Continued to hotel where upon morning, no amount of 'jiggling' would turn on power to start. Was suggested to 'try' brake cleaner in the ignition switch to clean the contacts, but switch would still not function, and to rent u- haul truck to return motorcycle to home location. 22 hours later upon returning home, ignition switch intermittently would turn the power on. Due the intermittent nature dealer replaced the switch. Still awaiting parts and determination of who was paying the bill.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Yamaha FJR1300A?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history