2004 Acura TL suspension problems

Filed Jul 19, 2024 · Suspension · MA

I was driving and all of a sudden I hit a pot hole and then when I went to take a turn my car ended up making a shaking rattling sound when I pulled to to side to check it the ball joint was half way out of the control arm

Filed Oct 6, 2022 · Suspension · 150,000 miles · TX

The contact owns a 2004 Acura TL. The contact stated while driving at 60 MPH with her mother in the front passenger’s side seat, her mother informed her that the vehicle was bouncing. The vehicle was taken to an independent mechanic where the front lower control arms, shocks, and bushings were replaced; however, the contact stated while driving at an undisclosed speed, the driver's side of the vehicle dropped significantly and the vehicle stopped. The vehicle was towed to the residence. The dealer was notified of the failure and informed the contact that the VIN was not under recall. The vehicle was not diagnosed or repaired. The contact associated the failure with the federal safety agency Campaign Number: 11E022000 (Suspension). The manufacturer was not notified of the failure. The failure mileage was approximately 150,000.

Filed Jul 5, 2022 · Steering, Suspension · WA

I purchased this used car and while driving the VSA (Vehicle Stability Assis) light comes on with the accompanying trianlge with exclamation point. When the light comes on while driving the car will tug you to the right. Once you stop the vehicle and turn off and re-start the light will turn off. As you drive again, the light comes on and tugs the vehicle to the right. When we purchased the vehicle I drove it home with my 16 year old (it is planned to be his first car) and I was on the highway going 60 and the VSA light came on and tugged the vehicle to the right. I did not lose control but it can definitely catch someone off guard and cause them to over correct. I took the car in to a local auto shop and they said there was a fault on the VSA module and a couple of other issues. I spent $1,300 to replace both front bearings, hubs, 1 speed control sensor because they recommended that be done before looking to replace the VSA modulating assembly ($1,800 + install). I checked the Acura site and but there is nothing there about a recall for the VSA module. I have seen other posts online of people saying that the car pulls to the right when the VSA light comes on so I seems to be an issue. In winter conditions having an issue like this could cause an over correction and/or loss of control which could cause an accident.

Filed Dec 14, 2020 · Steering, Suspension · 150,000 miles · KS · fire

After having my car in the shop for 2 weeks trying to figure out why the power steering won't stop freaking exploding when there is nothing wrong with any of the parts except the hoses going bad. I once again was left in the middle of a busy street with no power steering trying to muscle my way back to the shop. This is ridiculousssssss. Why are they not telling us their cars have issues!!!!!

Filed Oct 20, 2020 · Acceleration, Airbags · 5 miles · NY

I have not been contacted about the airbag recall, the potential problem with the accelerator pedal and the driver side lower ball joint recall. Several years ago I exited a highway, came to a stop sign and when I made a right turn the drivers side ball joint broke. I had the repair done and luckily I didn't hurt ao or myself. Thank you stay safe. I think it was in 2015.

Filed Apr 22, 2019 · Suspension · SC

Tl* the contact owns a 2004 acura tl. While driving approximately 10 MPH and attempting to make a turn, a loud boom sound was heard from the front end of the vehicle. The sound caused the wheels to "move up and down". There was no warning indicator illuminated. The failure recurred three times. The dealer was not contacted. The manufacturer was made aware of the failure and stated that there was no recall and nothing could be done. The vehicle was taken to an independent mechanic and repaired. The diagnosis and repair specifics were not disclosed. The failure mileage was unknown.

Filed Sep 10, 2018 · Body, Seat belts · 169,558 miles · DC · 1 injury

Struts snapped on highway

Filed Jun 7, 2018 · Suspension · 172,000 miles · SC · crash

The aftermarket ultra-power k500117 {#51210sepa01} (economy) ball joint represents a severe safety hazard. It can result in separation of the lower control arm. The jpg ultra-power k500117 {#51210sepa01} (economy) after failure shows the lower control bushing ripped from the llower control arm. Jpg beck/arnley 1027932 bushing close-up is identical design as the acura oem part. This bushing is pressed into the control arm from the top. From the factory, once the ball joint is in place, the retainer nut holds both the ball joint and bushing securely in the control arm. The factory flanged nut is larger than the bushing diameter as to ensure contact with the control arm underside. Observe the nut in .jpg ultra-power k500117 {#51210sepa01} (economy)'s. It is a standard lock nut. The diameter is too small. It makes no contact with the control arm, but rather seats directly to the bushing. The bushing is only pressed in, and will eventually pull out. As can be seen in the after failure picture, there is no way the nut could hold the ball joint and bushing in place as acura (honda) designed it to do. Please look at the nut of the moog k500117 as an example of a correctly designed ball joint and nut, and how the nut is flanged. This is the correct style nut as it will make contact with the lower control arm instead of only the pressed in bushing. It can be easily seen in the second picture that the nut is clearly smaller than the control arm bushing. Order number 82540335 through rock auto was purchased on 4/12/2018. The ball joint, bushing and nut simply pulled out. The lower control arm is destroyed, as is the cv axle. Damage to the fender and fender skirt as well. It is fortunate this failure happened while turning into a parking lot rather than at highway speeds just moments before.

Filed Jul 11, 2017 · Suspension · 152,000 miles · MD

Tl* the contact owns a 2004 acura tl. While driving 3 MPH over a speed bump, the contact heard a loud abnormal noise and the front driver's side of the vehicle detached. The vehicle was towed to a storage yard. The contact inspected the vehicle and diagnosed that the ball joint had separated. The contact stated that this was not the first failure. The vehicle was also towed to jaggs auto service where it was diagnosed that the ball joint had separated. The contact referenced the federal safety agency campaign number: 11e022000 (suspension); however, the VIN was not included. The manufacturer was notified of the failure, but offered no assistance. The failure mileage was approximately 152,000.

Filed Feb 29, 2016 · Suspension · 200,897 miles · SC

Tl* the contact owns a 2004 acura tl. After exiting the highway and pulling into a store parking lot, the vehicle was briefly parked. Upon restarting the vehicle and depressing the accelerator pedal, there was an abnormal noise and the vehicle was unable to be driven. The vehicle was towed to an independent mechanic who diagnosed that the lower control arm prematurely fractured, which caused the entire axle to fracture. The independent mechanic diagnosed that the axle, ball joints, and lower control arm needed to be replaced. The contact was not included in the federal safety agency campaign number: 11e022000 (suspension). The manufacturer was notified of the failure and provided no remedy. The approximate failure mileage was 200,897.