2000 Audi A6 electrical problems

What is wrong

On certain passenger vehicles equipped with halogen low beam headlights, certain connector pins in the headlight switch connector come into contact with each other causing a short circuit. Note: vehicles with xenon low beam headlights are not affected because the circuit in these vehicles contains a fuse, which precludes excessive current flow in the case of a short circuit. Audi s6 and s6 avant vehicles are all equipped with xenon low beam headlights and, therefore, are not longer affected by this recall.

Risk

This condition could lead to overheating or fire.

Remedy

Dealers will reroute the wiring harness by installing a jumper wiring harness. The recall began on december 16, 2006. Owners may contact audi at 1‑800‑822‑2834.

Recall number 06V198000 · Recall details

What is wrong

On certain passenger vehicles, if a driver's knees push against the knee bolster (crash element) located under the dashboard, it can contact the headlight switch wiring harness, and an electrical short could occur.

Risk

A fire could originate in the left dashboard area.

Remedy

Dealers will install a protective covering on the knee bolster (crash element). In addition, the wiring harness as well as the felt protector on the left side of the dashboard carrier will be checked, and replaced if necessary. The recall began on july 26, 2004. Owners should contact audi at 1‑800‑822‑2834.

Recall number 04V133000 · Recall details

Volkswagen of america, inc. (voa) conducted a safety recall (the federal safety agency recall number 04v133) to add a plastic cover to the top section of the knee bolster crossmember to prevent contact with the headlight switch wiring harness.the scope of the original recall covered model years 1998 through 2004 with vehicle production dates of august 1997 through december 2004.the office of defects investigation has received nine complaints alleging that after having the recall remedy performed, a fire started in the driver's side dashboard area.voa reports that if the plastic cover is not installed properly by the dealers, the headlight switch wiring harness could continue to contact the crossmember, resulting in a short and/or fire in the driver's side dashboard area.voa will conduct a new safety recall to add an additional (and larger) cover over both the knee bolster crossmember and the plastic cover assembly installed in the first recall.all of the federal safety agency complaints and all but 3 voa claims are for my 1998 through my 2000.voa reports that beginning in my 2001, audi extended the time for the deburring process of the crossmember.voa was not able to verify the cause of fire in the my 2001 and later vehicles due to either extensive fire damage or other reason.the rate of fire occurrence is significantly less for the my 2001 and later vehicles. The recall covers model years 1998 through 2000 with vehicle production dates of august 1997 through may 2000.voa will recall 66358 my 1998-2000 audi a6, a6 avant, s6, and s6 avant vehicles.odi is aware of a total of 59 warranty, field and consumer reports for these vehicles.the recall is identified by the federal safety agency number 06v‑198.

RQ06003

The subject vehicles are equipped with a knee bolster located under the dash, near the drivers knees.a wiring harness is also located in the dash, in that same area.audi's analysis of 39 vehicles indicated that the knee bolster was rubbing against that wiring harness.over time the harness sheathing wears away and the wires come into contact with the metal knee bolster, resulting in a fire. Audi will conduct a safety recall on an expanded scope of audi a6 vehicles, to add a plastic cap to the top of the knee bolster bracket, which will prevent abrasion to the wiring harness. Audi will recall 186,000 my 1998-2004 audi a6 vehicles.odi is aware of a total of 24 warranty, field and consumer reports for these vehicles.the recall is identified by the federal safety agency number 04v‑133.

EA03025

Of the 22 total complaints, 11 were received for the 1999 model year and 11 for the 2000 model year. Audi is conducting testing to determine the origin and cause of the fire.

PE03035