The contact owns a 2015 BMW 428I. The contact discovered that the water pump was continuously running after the vehicle was turned off. The contact referenced and associated the failure with the federal safety agency Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the VIN was not included. The dealer was notified of the failure. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 118,357.
2015 BMW 428I electrical problems
35 complaints (45% of all complaints for this car). Typical mileage when it fails: 84,000. 1 crash reported.
- owner complaints
- 35
- of this car's complaints
- 45%
- typical mileage
- 84,000
- crashes
- 1
- recalls
- 1
Which part fails
Owners did not name a specific part.
At what mileage
Complaints by mileage at the time of the problem.
BMW 428I electrical problems in other years
Specific symptoms reported on the 2015 BMW 428I electrical
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Electrical system: wiring: connectors/plugs/receptacles
- What is wrong
- BMW of North America, LLC. (BMW) is recalling certain 2012-2015 X1 sDrive28i, X1 xDrive28i, 2012-2016 Z4 sDrive28i, 528i, 528i xDrive, 328i, 328xi, 2016-2018 X5 xdrive 40e, 2014-2016 228i, 228xi, 428i, 428i xDrive, 328xi Gran Turismo, 2013-2017 X3 sDrive28i, X3 xDrive28i, 2015-2018 X4 xDrive28i, 2015-2016 428xi vehicles. An improperly sealed electrical connector on the water pump may be exposed to water and short circuit.
- Risk
- An electrical short increases the risk of a fire.
- Remedy
- Dealers will inspect and replace the water pump and plug connector as necessary, and install a protective shield, free of charge. Owner notification letters were mailed on March 28, 2025. Owners may contact BMW customer service at 1‑800‑525‑7417.
Recall number 24V608000 · Recall details
What 2015 BMW 428I owners say
Most recent owner complaints, unedited.
The contact owns a 2015 BMW 428I. The contact stated that while the vehicle was parked, while attempting to start the vehicle, it failed to start. The contact stated that the vehicle eventually started. The vehicle was taken to an independent mechanic, where it was diagnosed with coolant pump failure. The contact was informed that the coolant had been continuously running, causing the battery to completely drain. The contact was informed that the battery needed to be replaced, the radiator needed to be flushed, and the repair of a small oil leak was needed. The vehicle was repaired. The VIN was included in the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). While driving to the dealer, the loss of communication with the coolant pump warning light illuminated. The contact was informed that the coolant pump had passed the inspection and did not need to be replaced. The contact was informed that the shield was installed as per the recall. The contact stated that upon retrieving the vehicle from the dealer, the battery was completely drained. The contact was informed that the battery needed to be replaced. The dealer was informed that the battery was replaced three weeks prior. The contact requested that the dealer replace the coolant pump according to the recall notification, however the request was denied. The manufacturer was not made aware of the failure. The failure mileage was approximately 130,000.
The contact owns a 2015 BMW 428I. The contact stated that while driving at an undisclosed speed, the coolant warning light intermittently illuminated on several occasions. The contact was informed that the VIN was included in the federal safety agency Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The vehicle was taken to a dealer, where it was diagnosed that there was an electrical connector on the water pump that was exposed to water and that the water pump needed to be replaced. The contact stated that the manufacturer had removed the VIN from the recall. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was unknown.
The contact owns a 2015 BMW 428I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The contact called the local dealer, who confirmed that recall parts were not yet available and advised the contact to wait for another notification to arrive when parts become available. The vehicle was not diagnosed or repaired. The manufacturer was not contacted about the issue. The contact had not experienced a failure.
The contact owns a 2015 BMW 428I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that while driving 20 MPH, the check engine warning light illuminated, and the messages "Engine Overheated" and "Please Pull Over" were displayed on the instrument panel. The contact replaced the water pump and the thermostat; however, the failure persisted, and the vehicle was taken to an independent mechanic to be diagnosed and the contact was informed that the water pump had failed and needed to be replaced. The water pump and thermostat were replaced; however, the failure persisted, and the engine kept overheating. The vehicle was taken back to the independent mechanic. The water pump and thermostat were replaced. The independent mechanic checked the electrical system. However, no cause for the failure was found. The contact stated that the failure persisted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was unknown.
Recall #24V‑609. Recall was issued in October 2024. My wife drives this car....BMW has no update. Need it repaired ASAP! Please inquire. Thank you, [XXX] [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2015 BMW 428I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2015 BMW 428I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2015 BMW 428I. The contact stated while driving at an undisclosed speed, the engine overheated and the vehicle started shaking with the drivetrain malfunction message displayed. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The dealer was contacted and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure but was unable to confirm when parts would become available. The failure mileage was approximately 93,000. VIN tool confirms parts not available.
The contact owns a 2015 BMW 428I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
Questions about the 2015 BMW 428I electrical
Does the 2015 BMW 428I have electrical problems?
Owners have filed 35 complaints about the electrical of the 2015 BMW 428I, 45% of all its complaints.
At what mileage do 2015 BMW 428I electrical problems start?
The typical (median) mileage in owner complaints is 84,000 miles.
Was there a recall on the 2015 BMW 428I electrical?
Yes, 1 recall: 24V608000. Check your VIN to see if your car still needs the free repair.
What year does the BMW 428I have the most electrical problems?
The BMW 428I model years with the most electrical complaints are 2015 (35 complaints), 2016 (24 complaints) and 2014 (16 complaints).
Other 2015 BMW 428I problems
Engine 37Airbags 7Brakes 6Fuel system 5Body 4Transmission 4Acceleration 3Tires 3Seat belts 2Steering 2Seats 1Suspension 1Wheels 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 BMW 428I?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history