When coming to a stop at 25 MPH the brake pedal will go to the floor and the vehicle won't stop. The dealer has inspected the vehicle, and was not been able to duplicate the problem.
1993 Chevrolet Blazer brakes complaints
Page 9 of 14: complaints 221 to 250 of 376, newest first, as owners wrote them.
When applying the ABS brakes on wet pavement, the pedal goes to the floor and the brakes failed to stop the vehicle. Cause unknown. Please provide further details.
Brakes: when driving and applying brakes, put pedal completely to the floor and still it was hard to stop the vehicle, had new master cylinder put on, and vehicle is worse, dealer says there is nothing wrong with the brakes. *ak
When brakes are applied the wheel will lock and vehicle will go into a slide. The dealer has not been able to duplicate the problem.
Upon brake application, brakes have a tendency to lock up either on wet/dry surface and vehicle will swerve, not having equal braking. Please describe details.
When brakes are pressed they skip. The owner has changed the brake system. . *ak
Abs brake problems; when slamming on the brakes on wet road the system worked fine. Afterwards, when making a normal stop, the pedal was spongy and went close the floor. Pulled over and pumped the pedal, the pedal came back up and was hard. After driving the rest of the day, owner had no problem with brakes.
Brakes: driving approximately 20 MPH, approaching a red light, attempted to slow down, put foot on brake and brake pedal went completely to the floor, made a loud noise at the time, 1/2 block later brakes were fine. Took to garage and they could find no problem. *ak
When applying the ABS at 30 to 40mph the vehicle will not respond and the pedal goes to the floor. Has been to dealer and problem is not solved.
Brakes: when attempting to stop brake pedal goes completely to the floor and cannot stop the vehicle. Dealer can't duplicate the problem with the brakes.
When driving the truck and having to come to a stop, applied foot on the brake pedal and the truck just continues to go forward.
When driving the truck and you applying foot to the brake pedal the truck just keeps going, and the pedal goes down to the floorboard.
When applying the brakes the wheels wont lock up and the pedal goes to the floor, and the car keeps going. Dealer says that it's normal.
When hitting a bump in the road and when the brakes are applied, they go to the floor. *ak consumer stated when the ABS are working the brakes seem like they are not going to stop, the brake pedla goes all the way to the floor.
Abs brake failure. Brakes taken for repair at least three times and no problem found.
Brakes: when driving at slow speed and having to make a quick stop, the vehicle will not always stop. Have to put the pedal completely to the floor, and it still will not stop. Been to shop numerous times and they can't duplicate the problem.
When traveling on an incline and upon making a gradual stop, the brakes failed to stop the vehicle, the pedal did not travel to the floorboard, consumer has contacted the dealer. *ak consumer stated the pedal did go to the floorboard and did not stop.
When stepping on the brakes the vehicle would slow down, but would not stop normally. In a panic situation, the vehicle would probably hit the vehicle in front. Driver would have to leave about 2 additional car lenghts between her vehicle and the vehicle in front. *ak engine smokes when started, dealer stated that the valve seals are bad.
Abs brakes grind when driving on wet pavement.
Consumer can be driving at any speed low/ high ,applies pressure on brakes, do not respond or stop right away, pushes brake to floor, still does not work. Eeds to pump brakes about 3-4 times before can actually stop.this defect happens in park position or reverse.
While driving 30 MPH vehicle experienced total brake failure. Consumer states that brakes fail randomly .the dealer has been contacted.
Under 40 MPH when the brakes were applied they didn't pick up. Upon applying the brakes and pushing the brake pedal to the floor the result of the brakes going to the floor is like pushing the brake pedal lightly. This problem caused the vehicle to be run off the road to avoid hitting another vehicle.
Noticed brakes & ABS light was on. Took to dealer & informed that brake module had failed, & that vehicle was unsafe to drive. Manufacturer refused to help due to out of warranty.
When applying the brakes the vehicle has difficulty stopping. Has gone to dealer once. *ak the egr valve gets carbon in it and fails. Whekn this happers, the vacuum is cut off from the power brakes of the power steering fails.
Intermittent ABS brake failure.
Brakes: when driving the brake pedal goes completely to the floor before the brakes will engage. Have taken to dealer several times and they don't think there is a problem.
When applying the brakes in the snow there is no stopping at all. But this problem happens all the time in good and bad weather. Investigation on ABS braking system failure, ea 94038.
When depressing the brake pedal the pedal becomes very hard, resulting in extended stopping distance, causing consumer to have an accident. Ea94-038. *ak consumer states there was complete failure of both the ABS system and power brake system.
Anti-locks braking system failure, vehicle has no rear brakes, causing extended stopping, only front brakes are working, ea94-038 active.
Brake master cylinder failed.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1993 Chevrolet Blazer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history