Abs brakes; when applying the brakes in normal conditions, the pedal went to the floor and the brakes failed to stop the vehicle. Please provide further details.
1994 Chevrolet Blazer brakes complaints
Page 8 of 16: complaints 191 to 220 of 434, newest first, as owners wrote them.
Owner has ABS brakes. While drivng at 35-40 MPH owner had an accident due to brakes not stopping vehicle. When pressed pedal goes to floor of vehicle. Also brake sensor was replaced, but problem remains.
Ea94-038; when traveling on wet pavement and upon depressing the brake pedal, the pedal goes to the floorboard, making it very difficult to stop the vehicle, resulting in brake fade away, causing extended stopping distance. Consumer has contacted the dealer, dealer unable to find the problem.
The brake pedal goes to the floor and requires excessive pressure to stop, its an intermittent problem. This would cause the vehicle to have an extended stopping distance.
Owner has ABS brakes. While applying the ABS brakes in panic stop situation vehicle would not stop, causing owner to hit another vehicle. Dealer found no problem with brakes
Brakes: when applying the brakes with pedal completely to the floor it does not stop the vehicle.
Consumer has experienced brake failures since ownership, in 1997 failure caused accident.
Whenever ABS brakes are applied, the pedal continues to go to the floor. Vehicle has extended stopping distance. Problem occurs when pavement is wet/slippery. Happens intermittently. Took to dealer & problem cannot be located.
Anti lock brakes failed, causing loss of control.
Consumer applied brakes normally for school crossing gaurd during wet weather with pedal all the way to the floor and the ABS system kicked in. But the braking distance was exceeded. Dealer said he knew about the problem, but because gmc felt the brakes were fine and there is nothing he could do.he instructed consumer to brake and keep pedal down, and it should be okay.
Anti-lock brakes failed several times in wet weather conditions.
Brake problems.
Skidding of braking system during inclement weather. Fault cause : increased stopping distance.
Brakes: when driving and attempting to stop had to push brake pedal completely to the floor and the vehicle still roll for a while before can get it to stop.
When applying the ABS brakes in normal driving conditions the brakes will fail, causing exttended stopping distance which nearly caused a collision to occur.
Consumer had to replace the front braking system. Also, replaced thermostat twice.
Brakes: when driving, especially in damp weather, pushes pedal completely to the floor and has trouble with the truck stopping. Had vehicle in shop several times, and they say there is nothing wrong with it.
Ea94038, ABS braking system failure; intermittently. When applying the brakes on normal road condtions, during normal braking, the pedal is very hard with no play. Sometimes when going over bumps the ABS kicks, and does not allow to use the brake pedal. The front brakes pads have been replaced (4) times within a (2) year period. Consumer is still experiencing a problem with system. Dealer stated the pads, drums, calipers and rotors needs replacing at this time.
Ea94038, the defective ABS braking system malfunctioned, causing brake pedal to fade and extended stopping distance which almost caused an accident.
Brakes wear rapidly goes to the floor.
Anti lock brakes fail in wet conditions, locking up causing vehicle to slide and go sideways.
When applying the ABS brakes the pedal will nearly travel to the floor, causing extended stopping distance which nearly caused a collision to occur.. Please give any further details.
Anti lock brakes not stopping vehicle properly.
Abs brakes, when applying the brakes in normal conditions, the pedal goes to the floor and the brakes fail to stop the vehicle. *ak consumer states that brakes feel soft and not grabby, whenever driving over a bumpy road and applying brakes, it takes about 5 seconds before brakes hold.
While applying ABS brakes,vehicle will not stop. Also brakes make a strange noise when applied. Owner notes sensor replaced, but did not correct problem.
Abs brake system fails when sudden stopping is required and when going over bumps in the road.
Upon traveling on wet pavement and upon depressing the brake pedal, brakes lock up, shaking in the front end. Pedal traveled to the floorboard, resulting in extended stopping distance. Consumer has contacted the dealer, dealer unable to determine the problem. Please provide further details.
While drivng vehicle and applying ABS brakes all 4 wheels locked up.owner notes this is second time problem occurred.cause unknown.
Rear brakes are not providing stopping power under panic stops. The dealer has inspected the vehicle.
Brake failure on several occasions.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Chevrolet Blazer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history