While driving the truck the ABS brake light comes on. Took the truck to the dealer, and the dealer took 3 days to find the problem, the module valve relay was broken, that was the outcome of the dealer's decision on the brakes.
1995 Chevrolet Blazer brakes complaints
Page 11 of 19: complaints 281 to 310 of 531, newest first, as owners wrote them.
Driving at approximately 20-25 MPH, preparing to stop brakes were inoperative.vehicle eventually stopped at about 100 feet or less.dealer changed brake lines,claims that rotors and linings were glazed.this defect could result in an accident. *ak
Anti-lock brakes failed, resulting in an accident.
When driving the truck and making a turn, put foot on the brake pedal and the pedal did not move, and the truck cut off and would not restart. The truck had to be towed.
Abs failure.
Brakes: when driving and applying the brakes, the pedal goes completely to the floor and the vehicle continues to roll. It eventually stops after pushing the pedal completely to the floor. Happens under 40 MPH- not in wet conditions, specifically in city traffic.
Anti-lock brakes failed causing accident.
Brakes: when driving and applying the brakes they will not engage. Pushed completely to the floor and nothing happened. Had in for repairs five times, and had five sets of brake pads put on.
Approximatel 1 week after brakes were repaired by dealer, they failed totally.
Brakes have failed several times almost resulting in an accident.
Abs brakes fail to operate properly. Brake pedal, when depressed, goes to the floor with almost no pressure, resulting in extended stopping distance. Also master cylinder failed.
Whenever applying the brakes (ABS), the vehicle would experience longer stopping distance. The brake pedal would go to the floor. It happens intermittently.
Hard brake pedal.
Brake calipers stuck, causing vehicle to pull while braking.
Windshield wipers failed.
When applying the brakes the pedal goes to the floor and vehicle does not stop. Dealer has not seen vehicle.
While driving at approximately 10-30mph, getting ready to slow down, making a turn by applying brakes, heard noises. Brakes will not work properly, will not grab.this is an intermittent problem. Dealer cannot find problem. This defect can result in an accident.
Abs brake system fails on bumpy roads and pedal goes all the way to the floor.
In wet conditions the defective ABS braking system malfunctioned, causing the brake pedal almost to hit the floor and caused extended stopping distance, increasing potential for an accident.
When depressing the brakes hard the ABS and brake light comes on for approximately 5 second.
Anti lock brakes have failed on several occasions, one incident resulted in an accident.
Anti lock brakes failed, causing accident.
E.c.v. Failed, causing loss of power brakes.
Anti lock brakes failed several times momentarily.
Brake problems; on regular road conditions when applying the brakes, the pedal drops to the floor. Dealer is not able to find a problem with the brakes. At dealer (8) times since january for brake problems. Problem still exists.
Anti-lock brakes fail when weather is wet or icy.
Extended stopping distance.
While driving the vehicle consumer tried to make a sudden stop by depressing the brake peda, the vehicle continued to still travel , consumer pressed the pedal again the vehical stopped. Dealer has been contacted.
Owner rear ended another vehicle when he tried to apply the brakes and the pedal went to the floor. There was no braking ability.
Ea94-038; upon making a sudden or a gradual stop on wet or dry surface, consumer noticed the pedal traveling to the floorboard. Consumer also noticed a loud noise, resulting in extended stopping distance. Consumer has contacted the dealer, dealer has replaced the pads and shoes.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Chevrolet Blazer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history